Page 1
Introduction
wireless PIR motion sensor
enabled device (interoperable, two
main
devices result in more possible transmissi
enabled device displaying the Z
and ours can also be used in other manufacturer’s Z
signal when movement is detected inside the building
Wave
Frequency Range:
Operating Range: Up to 50M
Operating Temp.:
Battery: CR123A
nsert battery into the battery compartment, LED will start to flash slowly.
Wave
. Press the program switch of
stop flashing, if not, please try again.
from network,
PIR03
sensor
at 2 meters above surface. To enhance proper operation, place
the home security device. This sensor is a Z
way RF mesh networking technology) and is fully compatible with any
enabled device acts as a signal repeater and multiple
logo can also be used with it regardless of the manufacturer,
enabled networks. This sensor mon
Wave
instruction
once. The LED on the
delete” mode, and follow
sensor
Thanks for choosing the Comax’s
Wave TM
Z-Wave TM enabled network. Every
Z-Wave TM
and send Z-Wave TM
Product Description
Specification:
Protocol: Z-
Installation
1. Open the cover and i
2. Close the back cover.
To add the sensor, Put the Z-
CM-PIR03 to your controller
To Delete the sensor
instruction to delete the CMdeleted. The LED on the
3. Mount the sensor
can detect the room widely.
Operation Manual
Wireless PIR Motion Sensor
CM-PIR03
-
powered Z-Wave TM
on routes which helps eliminate “RF dead-spots”.
-Wave TM
-Wave TM
868.4MHz, 865.2MHz
-10°C to 50°C
-1pcs
Interface Controller into “add” mode, and follow
Put the Z-Wave Interface Controller into “
to your controller. Press the program switch of
should start to flash.
for
line of sight
.
CM-PIR03
itors movement,
once to be
sensor
on the angle which
-
to add the
sensor should
Page 2
, sensor will send the st
no movement detected in three minutes after sent status of “ON”, the sensor will send the
Normal operation, the LED will not light.
sensor equipped with tamper switch. If the cover of sensor is removed, the PIR sensor will
Wave
sensor
for one year from the date of purchase. If the product proves defective during this one
This warranty does not apply
Damage to units caused by accident, dropping or abuse in handling, or any negligent use.
Units which have been subject to unauthorized repair, taken apart, or otherwise modified
Units not used in accordance with instruction
Damages exceeding the cost o
Transit damage, initial installation costs, removal cost, or reinstallation cost.
free from physical defects in material and workmanship under normal use
year warranty period, Comax
Operation
1. Walk in front of sensor
2. If
3.
4. The CM-PIR03
send an alarm report to the Z-
Warranty terms
Comax Guarantees that every PIR
will replace it free of charge.
Note:
•
•
•
•
•
atus of “ON” and the LED will flash once.
status of “OFF”
Interface Controller, and the LED will go solid.
is
-
to
f the product
Loading...