Page 1
Wireless Door/ Window Sensor
Introduction
for choosing the COMAX’s Wireless
Wave enabled device acts
This sensor monitors door/window and send
Product Description and Specification
Wave
Frequency Range: 865.2 Mhz
Operating Range: Up to 50M
Operating Temp.:
Battery: CR123A
Using the screws or adhesive tape fix the rear cover on the frame along the opening edge of door /
Insert a CR123A battery into the battery compartment and LED will start to flash slowly, which means the
ng sensor to a network, Put the Z
to your controller.
meter. Press the program switch of
To remove the sensor from a network, Put the Z
from your controller. Press the program swit
Fix the Magnet by using the adhesive tape or fixing screws, locate the Magnet close to the
distance between these two devices should be
Opening the door/window to separate the
Closing the door/window to align the magnet with the sensor will send the
Normal operation, the LED will not light.
Wave
as a signal repeater and multiple devices result in more possible
signal when door or window is opened and closed.
Wave
add” mode, and follow
he distance between sensor and controller is suggested to be in one
should go solid, if not,
delete” mode, and follow
from your controller. Press the program swit
CM
he status of "ON"
status of "OFF"
for 1 second
Thank you
is fully compatible with Z-Wave
Every main powered Ztransmission routes.
Specification:
Protocol: Z-
Installation
1. Unscrew and open the rear cover.
2.
window.
3.
sensor has not yet been “added”.
4. For addi
add the CM-DW01
please try again.
instruction to delete the CM-DW01
6.
Operation
1.
will flash once.
2.
flash once.
3.
Operation Manual
CM-DW01
Door/Window sensor. This sensor is a Z-
Z-Wave
line of sight
-10°C to 50°C
- 1Pc
-Wave Interface Controller into “
T
CM-DW01 for 1 second. The LED on the sensor
-Wave Interface Controller into “
ch of sensor
not more than 1.5cm.
magnet from the sensor will send t
enabled device and
instruction to
.
-DW01 sensor the
and the LED
and the LED will
Page 2
4. The CM-DW01 sensor equipped with tamper switch. If the cover of sensor is removed, the door sensor will
send an alarm report to the Z-Wave Interface Controller, and the LED will go solid.
Warranty terms
Comax Guarantees that every wireless Door/Window sensor is free from physical defects in material and
workmanship under normal use for one year from the date of purchase. If the product proves defective during this
one-year warranty period, Comax will replace it free of charge.
Note:This warranty does not apply to
• Damage to units caused by accident, dropping or abuse in handling, or any negligent use.
• Units which have been subject to unauthorized repair, taken apart, or otherwise modified
• Units not used in accordance with instruction
• Damages exceeding the cost of the product
• Transit damage, initial installation costs, removal cost, or reinstallation cost.
Loading...