Columbia Products 56FAL, 56FAL-0.5, 56FBL, 56FBL-0.5 Operating Manual

HANDS-FREE FLOOR MOUNTED WASH STATIONS

AC OR BATTERY POWERED

Operating Manual for Three-Person Hands-Free Floor Mounted Wash Stations

AC Models 56FAL and 56FAL-0.5

Battery Models 56FBL and 56FBL-0.5

1

Columbia does not recommend use with harsh chemicals.

NSF/ANSI Standard 2 - Food Equipment and NSF/ANSI 372 low-lead.

COLUMBIA SPECIFICATIONS

HANDS-FREE FLOOR MOUNTED WASH STATIONS

AC OR BATTERY POWERED

2

Parts List

(1) Floor mount wash station

(1) Leg assembly set

(4) Washers and nuts for connection sink to leg assembly set

(3) AC or Battery powered sensor faucet assembly

(3) Mixing check valve

(1) Strainer assembly with basket

Installation Instructions

Step 1

1. 2 and 3-Person models require leg assembly.

2. Place wash station sink on leg assembly and secure with hardware (provided).

3. Establish sink location.

4. Mark the floor where the four holes are at the base as shown in illustration A.

5. Drill holes as required for mounting hardware. (Hardware not included).

Step 2

1. Install strainer assembly.

2. Install faucets to the sink following the instructions provided with sensor unit.

3. Attach supply tube with elbow to back of faucet.

4. Install mixing check valve and compression fitting to control box of each sensor faucet.

Step 3

1. Secure wash station to floor.

2. Connect waste line to strainer assembly (s).

3. Mount sensor control boxes at desired location on wall.

4. Connect power line from sensor to control box.

5. Attach supply tube from faucet to control box.

6. Connect hot and cold water from the source to mixing check valve (s).

7. Remove aerator from the spout assemblies and flush water system. (see step 7 sensor
installation instructions)

8. Check connections for leaks.

9. Replace aerator onto the spout (s).

Step 4

1. Seal gap between bowl and leg assembly as shown in illustration B.

2. We recommend sealing top of backsplash to wall if applicable as shown in illustration C.

Tools Required

Tape Measure

Adjustable Wrench

Drill Motor and Drill Bits

Pipe Wrench

Level

Safety Glasses

Screw Drivers: 1 Phillips & 1 Standard

Pencil

Socket Wrench

Illustration A

Illustration B

Notice for California Consumers

WARNING: This product can expose you to chemicals including Chromium (hexavalent compounds),

Lead, and Phthalates (DEHP) which are known to the State of California to cause cancer and birth defects
or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

NOTE: Lead content originates from Brass components in valves and faucets and is certied under

NSF/ANSI 372 as containing less than 0.25% lead in wetted surfaces.

1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]

Illustration C

©2019 Columbia Products

COLUMBIA SPECIFICATIONS

56 Floor

Top

HANDS-FREE FLOOR MOUNTED WASH STATIONS

AC OR BATTERY POWERED

3

1.5” (38mm)

Front Side

.5” R

(12.7mm)

.5” R

(12.7mm)

30” (762mm)

60” (1524mm)

57” (1448mm)

10.25”

(267 mm)

30” (762mm)

2” drain hole

2” (51mm)

16.5”

(407mm)

(508mm)

1.5” (38mm)

10”

(254mm)

8” (203mm)

27” (686mm)

20”

1.5” (38mm)

35” (889mm)

floor to rim

height

20” (508mm)

2” (51mm)

7.5” (191mm)

45º

.75” (20mm)

2.875” (73.02mm)

Hole Configurations

11”

(279.4mm)

.875” (22mm)

dia. holes (3)

Floor Mounting Detail

.5” dia.

1.5” Leg

Thickness

Floor

Mounting

Holes

10.5” on
Center

.75” From

Edge of Leg

to First Hole

19”

(482.6mm)

49.625” (1260.5mm)

19”

(482.6mm)

11”

(279.4mm)

6.75”

(171mm)

(254mm)

10”

1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]

©2019 Columbia Products