ColorMaker CUE Owners Manual

ColorCue-PX

User’s Manual

Introduction

ColorCue is a wireless control for ColorMaker wireless LED xtures designed for both beginners and advanced
users. Fully programmable for advanced users and ready to command out of the box for beginners. The ColorCue
can command 8 individual xtures to control RGB with 16 programmable presets or create custom colors with
RGB Up / Down controls. ColorCue has 1 ColorRoll and 1 Scene button for easy event setup.

ColorCue Controls

A- Status indicator
B- Power ON-OFF switch
C- RGB Up / Down controls. Also used for ColorRoll timing.
D- Power up function keys. Used to set ColorCue network and restore factory defaults.
E- ColorRoll and Scene activation controls
F- Fade / Snap controls.
G- 8 xture select buttons
H- 16 programmable color presets
I - Blackout button
J- Save button used for ColorRoll, Scene and 16 Presets

Status Indicator identies the remotes status during operation.
Red indicated the maximum intensity has been reached when using the RGB Up buttons.
Green indicates the remote is currently updating a scene. During this time the RGB Up/Down buttons are disabled.
Yellow blink identies the remote has entered Network address edit.

Power switch. This one should be obvious, it turns the remote ON and OFF.

RGB Up / Down used to set the color of the xture by adjusting the red, green and blue intensity levels. When the

maximum level of the current key has been reached the indicator will turn red. The RGB controls also used to set
the roll rate of the ColorRoll which will be covered later during ColorRoll programming.

Fade / Snap controls. These 2 keys set the ColorCue color transition fade time. When set to Snap the selected color
changes the xture instantly hence the word Snap. When set to Fade the colors transition is slow approximately 4
seconds depending on the colors. Then Fade and Snap also sets the fade time for the 1 scene button control. To set
the Snap control press the Snap button to set the Fade press the fade button.

Fixture Select Buttons. Buttons marked with Q1 through Q8 selects the xture. After each xture is selected the
user can set the color by using the RGB UP/DN buttons or press 1 of the 16 presets. The ColorCue stores the color
of each xture so users can edit all 8 colors.

16 Programmable Color Presets keys are used to set the xture to a programmable preset. The keys are color
representation of the colors that are factory programmed. The presets can be edited and saved for custom colors.

Blackout buttons turns all xtures off and terminates all ColorRolls.

Save button is a Press and Hold button to save color presets, Scene and ColorRoll colors.

www.ColorMaker.net