Collins HI-SPEED Operation Manual

HI-SPEED®DOLLY OPERATIONS MANUAL

TELESCOPING CROSS RAILS AND DOLLY PLACEMENT

STEP 1. ADJUST TELESCOPIC CROSS RAILS BY FIRST DEPRESSING SPRING-LOADED PLUNGER AND SLIDING OUTER

TUBE UNTIL PLUNGER LOCKS INTO HOLE THAT MATCHES TOWED VEHICLE’S TIRE WIDTH. (58” to 84” USABLE LENGTH)

68” 76”

PLACE CROSS RAILS FORE AND AFT OF VEHICLE'S TIRES. LENGTH OF CROSS RAILS SHOULD BE ADJUSTED AS CLOSE AS

POSSIBLE TO OUTER SIDEWALLS OF VEHICLE’S TIRES.

NOTE:

MAKE CERTAIN CROSS

RAILS ARE PARALLEL

AND EQUAL IN LENGTH.

84”

USABLE LENGTH ADJUSTED TO VEHICLE’S WHEEL WIDTH

ALL COLLINS CROSS RAILS POSSESS AN ENGINEERED, POSITIVE CAMBER SINCE 1975. A SLIGHT “BOW” IS NORMAL.

STEP 2. PLACE DOLLIES BESIDE VEHICLE TIRES, WITH DOLLY IN UNLOADED POSITION: SPINDLES ABOVE DOLLY.

Questions? Phone: [phone] or [phone] Email: [e-mail]

HI-SPEED®DOLLY OPERATIONS MANUAL

Page 2

CONFIGURING DOLLY COMPONENTS

STEP 3A. ROTATE SAFETY LOCKS BY TURNING THEM 90° TO RELEASE WHEEL ASSEMBLIES FROM STOWED POSITION.

STEP 3B. ROTATE SPINDLE ASSEMBLIES TOWARD OUTSIDE OF DOLLY BODY

CONNECTING CROSS RAILS TO DOLLY

STEP 4. USING THUMB TABS, LOWER CROSS RAIL END PIECES INTO ONE OF DOLLY’S THREE RAIL-POCKET SLOTS,

POSITIONING THEM AS CLOSE AS POSSIBLE TO VEHICLE TIRE TREAD, FOR MAXIMUM GROUND CLEARANCE WHEN RAISED.

NOTE:

VEHICLE TIRES BEST

SUPPORTED AT ENDS

OF CROSS RAILS,

CLOSE TO DOLLIES

Questions? Phone: [phone] or [phone] Email: [e-mail]

HI-SPEED®DOLLY OPERATIONS MANUAL

ENGAGING SAFETY RATCHETS

STEP 5. ENGAGE EACH SAFETY RATCHET BY ROTATING CAM HANDLE 180° TO INTERLOCK INTO GEAR TEETH

Page 3

STEP 6. INSERT PRY BAR INTO EACH PRY POCKET

RATCHET ENGAGED

IN GEAR TEETH

SAFETY WARNING!

RAISING ANY DOLLY WITHOUT A SAFETY RATCHET SYSTEM

CAN BE HAZARDOUS, AS IT MAY LEAD TO PERSONAL INJURY,

VEHICLE OR PROPERTY DAMAGE, AND POTENTIAL LAW SUITS.

GIVE STRICT HEED TO THIS MOST CRUCIAL SAFETY WARNING!

SAFETY RATCHETS HAVE PREVENTED COUNTLESS INJURIES.

INSERTING PRY BAR

Questions? Phone: [phone] or [phone] Email: [e-mail]