Cole Parmer Masterflex 7583-50, Masterflex 7583-52 Operating Manual

OPERATING MANUAL

and

HAZARDOUS DUTY

PUMP DRIVES

MODEL NO.

7583-50
7583-52

Cole-Parmer Instrument Co.

625 East Bunker Court

Vernon Hills, Illinois U.S.A. 60061-1844

800-MASTERFLEX (627-8373)

[phone] (Fax)

www.masterflex.com

e-mail: [e-mail]

A-1299-0676

Edition 02

®

TABLE OF CONTENTS

Title Page

SAFETY PRECAUTIONS ................................................................. ii

INTRODUCTION AND GENERAL DESCRIPTION ......................... 1

SETUP AND DRIVE OPERATION ................................................... 2

Wiring ........................................................................................... 2

GENERAL INSTRUCTIONS ............................................................ 3

OPERATING INSTRUCTIONS ........................................................ 4

PUMP MOUNTING .......................................................................... 5

Add-On Head Capacity ................................................................. 6

MAINTENANCE ............................................................................... 6

Cleaning ........................................................................................ 6

Service Parts ................................................................................ 6

Lubrication .................................................................................... 6

SPECIFICATIONS ........................................................................... 7

WARRANTY ..................................................................................... 8

PRODUCT RETURN........................................................................ 8

TECHNICAL ASSISTANCE ............................................................. 8

i

SAFETY PRECAUTIONS

DANGER: The pump drive is intended for installation in a Class

1 Division 1 Group D hazardous (classified) locations
and must be installed by a qualified electrician per
the National Electrical Code ANSI/NFPA 70. Incorrect
installation of this product can result in the explo­sive ignition of flammable vapors and liquids which
may be present.

WARNING: To prevent ignition of hazardous atmospheres, this

system must not be installed in an area where vapor
or gases having an ignition temperature less than
280°C are present.

CAUTION: Failure to wire the system in the manner prescribed

can result in premature failure of the mechanical
speed reduction system and will result in voiding
the warranty.

WARNING: PRODUCT USE LIMITATION

These products are not designed for, nor intended for use in
patient connected applications; including, but not limited to,
medical and dental use, and accordingly have not been sub­mitted for FDA approval.

Trademarks bearing the ® symbol in this publication are registered in the U.S. and in other countries.

ii