Coleman Tent User Manual

Pebble Creek™20’x11’

When You Are Ready To Set Up Your Tent

– Select a level campsite clear of

rocks, branches and other hard

or sharp objects. – Do not set up your tent under trees. – For best results in windy conditions,

position the end of tent into the wind.

Instructions apply to Part Number 9272-210C

POLE ASSEMBLY PARTS

(2) Main T

(2) Side Poles (Grey)

(2) Upright Poles

(2) Rainfly Poles

ent Poles

(Black)

(1) Center Pole

(Black)

Part No. 9272-321

Part No. 9272-323

Part No. 9272-319

Part No. 9272-317

Part No. 9272-325

Rainfly

Layout & Positioning of Tent, Pole Assembly

– Layout and position tent with doors

facing desired direction. (illus. 1) – Unzip doors. – Stake down tent corners, using the stake

loops. Keep the floor taut. (illus. 2) – Stake down tent through the rings on the pin

and ring system. – Assemble frame poles by interlocking shock-

corded poles. (four poles) – Insert the poles into pole sleeves. The longer

black poles should cross forming an “X” in

the middle of tent. The shorter side grey

poles insert into sleeves running front to

back. The shorter black center pole runs

straight front to back. (illus. 1)

Assembled poles inserted through pole sleeves

Part No. 9272-315

Connect Frame to Tent

– Insert one pin into the end of main black tent

pole to the side of the door. (illus. 3), (illus. 4)

– Go to opposite end of pole and gradually

apply pressure to the pole forming an arch until you are able to insert the pin into the

pole end. – Repeat for second pole. – Insert remaining pin into the end of side pole,

go to opposite end of pole and apply

pressure until you arch the pole and can

insert the pin into the pole. (illus. 3), (illus. 4) – Repeat for other side pole.

Side poles

(Grey)

Short Center

Pole (Black)

illus. 1

illus. 2

Tent stake

through ring

on stake loop

illus. 4

Tent frame

set-up

illus. 3

Insert pin into pole end

Attach Center Pole and Upright Poles to Hub.

– Insert center pole end into top of hub.

Repeat for other end. (illus. 5), (illus. 6)

– Insert the upright pole end with the clip

into the bottom of the hub until it clicks into position. (illus. 5), (illus. 6)

– Insert the metal clip located at the

center of the tent, into the bottom of the upright pole. (illus. 7)

– Repeat for second upright pole

on other side of tent.

Attach Frame Clips

– Attach frame clips along the edges of

tent to frame poles. (illus. 6), (illus. 8)

illus. 5 Center pole inserted into top of Hub and Upright pole inserting into bottom of hub.

illus. 6 Assembled tent without rainfly

Grommets for rainfly poles

illus. 8

Frame clips

Attach Rainfly

Things You Should Know

•

condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•

thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•

NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•

TOGETHER DURING STORAGE.

•

we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

– Assemble rainfly poles by interlocking

shock-corded poles.

– Insert rainfly poles into pole sleeves

located at the center edges of the underside of rainfly. (illus. 9), (illus. 10)

– Drape rainfly over tent frame, pole side

down. Rainfly poles should be over front and rear doors. (illus. 10)

– Hook the eight elastic loops (found at the

rainfly corners) to the fabric loops on the bottom row of frame clips. (illus. 11)

– Insert the tips of the rainfly poles into the

grommets on the front and rear of tent. (See above illus. 6)

– Secure rainfly with attachments located

on underside of fly. (illus. 9)

– Attach and stake out guylines.

Under certain conditions (cold weather, high humidity, etc.)

Never store tent, even for a short period of time, without drying it

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

Seam sealer has not been provided with your tent. For additional protection

Guylines

Rainfly poles

illus. 9

Rainfly

Underside of rainfly attaches to frame poles

Do not leave your tent set-up for weeks at a time, be aware that

•

exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

5975 Falbourne Street, Mississauga (Ontario) L5R 3V8

Rainfly pole

sleeves

illus. 10 Completed tent with rainfly.

IMPORTED BY

SUNBEAM CORPORATION (CANADA) LIMITED

1 800 387-6161 • www.colemancanada.ca

Hooks attach to

fabric loop

illus. 7

illus. 11

PRINTED IN SRI LANKA Rev

. 11/04

MADE IN SRI LANKA