COLEMAN Screen Lodge User Manual [fr]
Pole Assembly
–Assemble and connect one pole at a
time to the hub.
–Do not assemble poles completely.
–Go to the end of pole with the
spring clip and assemble all but the last
shock corded section.The pole should
curve down plus one section. (illus. 2)
–Insert the end with the spring clip into
one of the hub ports until it clicks into
position. (illus. 1, 2)
–Repeat for each of the five remaining
poles. (illus. 2)
14’x12’ Screen Lodge
1
When You Are Ready To Set Up Your
Shelter
–Select a level campsite clear of rocks,
branches and other hard or sharp objects.
–Do not set up your shelter under trees.
–For easier set up, two or more people
are recommended.
POLE ASSEMBLY PARTS
Instructions apply to Part Number 9192-142
Poles Par t No. 9191-101
Hub Part No.9191-102
Illus. 2
Partially assembled
frame locked into hub
Illus. 1
Poles inserted
into hub
Hub
Hub
2
Things You Should Know
•
Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent.
Use separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Do not leave your tent set-up for weeks at a time, be aware that exposure
to the ultraviolet rays of the sun can seriously damage material and/or cause
it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC.This tent meets the flammability
requirements of CPAI-84. The fabric will burn if left in continuous contact
with any flame source. The application of any foreign substance to the tent
fabric may render the flame-resistant properties ineffective.
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
Attach Shelter to Frame
–Drape the shelter over the frame,
positioning doors in the desired
direction.
–Position each corner over the
curve portion of the pole.
–Fully extend each pole by
completing the interlocking of the
shock corded pole sections.
–Insert the brass hook into the hole
near the base of the pole (illus. 4, 5)
–From the inside of the shelter secure
the pole frame to the shelter with the
hook and loop closures. (illus. 6)
–Adjust poles to pull the shelter
taut and stake down through
the fabric loops at the end of
each pole (illus. 5)
–Adjust hook straps to increase
tautness (illus. 5)
–Attach guy lines to fabric
guy loops at each corner
and stake out (illus.6)
illus. 3 Fabric draped over
partially assembled frame
illus. 6
Completed shelter
with guy lines
illus. 4
Insert Brass Hook
into hole near the
base of the pole
illus. 5
Stake through
Stake Loop
Use to adjust or
tighten canopy
Inside hook & loop
Loading...