Coleman SCREENED WEATHER MASTER User Manual
SCREENED WEATHERMASTER®17'X9'
1
Layout & Positioning of Tent
– Layout and position tent with screen room
facing desired direction. (illus. 1)
– Stake down tent, starting with
the corners. Do not stretch
too tight. Angle the stakes
slightly toward the tent.
(illus. 2) Keep the floor taut.
– Stake down the remainder
of the stake loops.
– Unzip the door.
2
Assemble & Place Roof Poles
– Assemble all shock-corded
roof poles. When assembled will
form a continuous arch with both
ends pointing down. (illus. 3)
– Select center roof poles with
red stickers, then insert through
the two center roof sleeves and
the roof pole sleeve at the front
of the screen room. (illus. 4)
– Select end roof pole, with blue
sticker, then insert through the roof
sleeve at end of the tent. (illus. 4)
When You Are Ready
To Set Up Your Tent
– Select a level campsite
clear of rocks, branches
and other hard or sharp
objects.
– Do not set up your tent
under trees.
– For best results in windy
conditions, position the
end of tent into the wind.
(3) Center Curved Roof Poles
(Red Sticker) Part No.
5010000474
(1) Rear Pole (Blue Sticker)
Part No.
5010000475
(6) Center Upright Poles
(Red Sticker) Part No.
5010000477
(2) Rear Brace Poles
(Blue Sticker) Part No.
5010000476
Rainfly Part No.
5010000481
Instructions apply to Part Number 2000000147
illus. 3 Curved roof pole assembly.
illus. 4 Curved roof pole system shown
inserted through pole sleeve.
illus. 2
Stake loops
properly staked
Front of
screen
door
Roof sleeve
illus. 1
Roof pole sleeve
Shock-corded poles
Forms an arch
POLE ASSEMBLY PARTS
3
Raise Center of Tent
– Assemble center shock-corded brace
poles (red sticker, longer poles).
Pole should be initially adjusted to the
inner most hole “A”. (illus. 7)
– Insert square end of brace poles into
curved roof poles and raise tent upright.
(illus. 5, 6, 7)
– Brace poles should attach to squeeze
pins at bottom of tent. (illus 8)
– Repeat for brace poles at front
of screen area.
illus. 5
Shown with both center
brace poles in
position and curved
poles through
center pole
sleeves.
Center brace poles
4
illus. 6 When attaching the
brace poles to the curved
poles make sure that the
brace poles naturally point
straight down.
illus. 9 Tent shown completely set-up. Note the different angles of
the end brace poles.
Raise Ends of Tent
– Assemble end (blue sticker, round ends)
shock-corded brace poles.
– Insert (blue sticker) brace poles into end
roof assemblies. MAKE SURE when
attaching the brace poles to the curved
poles that the bottom of the brace pole
naturally points down and toward the
center of the tent. (illus. 9)
– Brace poles should attach to squeeze
pins at bottom of tent. (illus. 8)
– Adjust poles to accomodate for terrain.
– Drape narrower end of rainfly over tent-
wider end over screen room, covering
the center and end poles sleeves.
Attach “S” hooks on rainfly into holes
in brace poles. (illus. 9)
Brace pole
Curved
poles in
pole sleeve
Rainfly hooks
to brace poles
PRINTED IN CHINA Rev. 11/07
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
illus. 7
Poles should be initially adjusted to the
inner most hole “A”.
illus. 8
Insert squeeze
pin into pole
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
•
Do not leave your tent set-up for weeks at a time, be aware that
exposure to the ultraviolet rays of the sun can seriously damage material
and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the
flammability requirements of CPAI-84. The fabric may burn
if left in continuous contact with any flame source. The
application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
Stake down
doormat
Loading...