Control Functions 4-3
Coolant Temperature Warning indicator
“ ”
When the coolant temperature reaches a
specified level, this light comes on to warn
that the coolant temperature is too hot. If
the light comes on during operation, stop the
engine as soon as it is safe to do so and
allow the engine to cool down for about 15
minutes.
CAUTION:
The engine may overheat if the vehicle is
overloaded. If this happens, reduce the
load to specification.
After restarting, make sure that the
overheat light is out. Continuous use
while the light is on may cause damage
to the engine.
Trip meter
Trip meter only records while the key is in the
“ON” position. Once the key is turned off,
the trip meter will re-set.
Fault code indicator
When the EFI encounters faults, the ECU will
send the fault code to the instrument display,
and it will flash on the clock.
If there are more than one fault code, they
will be shown in rolling sequence. When
fault codes are present, in order to see the
time press the clock button, the time will be
shown. Then after five seconds, the fault
code returns again. Only after the fault is
fixed, will the time show automatically.
The description for the fault codes are shown
in Chapter 11 of this manual.