Coleman Phact X User Manual

Assemble Frame

– Insert one end of the Main Tent Pole tips into the

grommet on webbing located at the corner of the tent. (illus. 3), (illus. 4)

– Go to opposite end of the Main Tent Poles and

gradually apply pressure to the pole, forming an arch, until you are able to insert the pole tip

into the grommet on the corner web. (illus. 4) – Repeat for second pole. – Insert one end of Side Pole into grommet on the

webbing at the side of tent and go to opposite end

of the Side Pole and gradually apply

pressure to the pole, forming an arch,

until you are able to insert the pole

tip into the grommet. (illus. 4) – Repeat for second pole.

Phact X

™

part number 9830-405

Layout & Positioning of Tent, Pole Assembly

– Layout and position tent with doors facing

desired direction. Unzip doors. (illus. 1)

– For best results in windy conditions, position

door or back of tent into the wind.

– Stake down tent corners. Keep the floor

taut. (illus. 2)

– Assemble Frame Poles by interlocking the

shock-corded sections. This will make two long red Main Tent Poles and two long silver Side Poles.

– Insert the two Main Tent Poles through the poles

sleeves with the red trim.

– Insert the silver Side Poles through the pole

sleeves with the silver trim.

Main Tent Poles (Silver)

Part No. 9830-1171

Side Poles (Red)

Part No. 9830-1271

Rainfly

Part No. 9830-1371

illus. 1

illus. 2

Tent stake

through Loop

illus. 3

Insert Pole Talon on stake loop into pole.

illus. 4

Tent frame up

POLE ASSEMBLY PARTS

Main Tent Poles

Side Poles

Things You Should Know

•

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•

Never store tent, even for a short period of time, without

drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use separate storage bag.

•

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE

ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•

TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER

DURING STORAGE.

Attach Rainfly

– Drape Rainfly over tent frame, with

rainfly double zipper door lining up over tent front door. (illus. 5)

– Connect the six clips to the clips located

at the corners and sides of the tent. (illus. 6 & illus. 7)

– Stake out rainfly doors, keep rainfly taut.

(illus. 7)

– Attach Guy Lines to Guy Wings on the

sides of the Rainfly and stake out (illus.7).

illus. 5

Rainfly

illus. 7

Completed tent with Rainfly.

Stake out door and vestibule

Guy Line

Guy Wings

illus. 6

Rainfly clips

onto pole

stake loop

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com