Coleman Outsider 13 x 11 User Manual

Connect Frame to Tent

–Insert one end of main tent pole

onto pin, of pin & ring system, at tent corner. (illus. 4)

–Go to opposite end of pole and

gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole.

–Repeat for second pole.

13x11 Outsider

™

Tent

Layout & Positioning of Tent, Pole Assembly

–Layout and position tent with door

facing desired direction. (illus. 1) –Unzip door. –Stake down tent corners, and tent

sides using the rings at the end of the

stake loops and the side stake loops.

(illus 2) Keep the floor taut. –Assemble frame poles by interlocking

shock-corded poles.This will make two

long poles. –Insert the poles diagonally into pole

sleeves.The center of the poles should

cross forming an “X” in the middle of

tent. (illus. 1) –Fasten frame tie on top of tent over

both poles. (illus. 1), (illus. 3)

When You Are Ready To Set Up Y our T ent

–Select a level campsite clear of rocks,

branches and other hard or sharp objects. –Do not set up your tent under trees. –For best results in windy conditions, do not

position the door of tent into the wind. –See owners manual for more tips.

Rainfly

Pole

Rainfly Part No. 9261-833

Main Tent

Poles

POLE ASSEMBLY PARTS

Assembled poles

inserted through

pole sleeves

Frame tie

Instructions apply to Part Number 9261A131

illus. 1

illus. 2 Tent stake

through ring

illus.4

Insert pole tip onto pin & ring

Tent frame

set-up

illus. 3

Frame tie

Part No. 9261-831

Part No. 9261-832

Grommets for rainfly poles

Attach Tent to Frame Using Frame Clips

–Attach frame clips along

the edges of tent to frame poles. (illus. 5), (illus. 6)

–Make any adjustments to the tent

corner stakes that are needed.

–Stake out door mat

Attach Rainfly

–Assemble rainfly poles by

interlocking shock-corded pole.

–Insert rainfly pole through pole sleeves

located at the front and rear edges on the underside of rainfly.(illus. 7 & 8)

–Drape rainfly over tent frame, pole

side down. Rainfly poles should be out over front door and rear window.

–Connect the four elastic loops with

“S” hooks, (found at the rainfly corners) to the four rings located at the end of the stake loops at the corners of the tent.

–Insert rainfly pole into grommets

on tent body.(illus.6 & 8)

–Secure rainfly with attachments

located on underside of fly.

–Connect the rainfly side to the

side of the tent. (illus. 8)

–Stake out tent with 2 side and

4 corner guylines. (illus. 9)

illus. 5

Frame clips

illus. 7 Insert rainfly

poles through pole sleeves on underside of rainfly

illus. 8 Completed

tent with rainfly.

PRINTED IN CHINA Rev.7/03

Ranfly hook to tent side

“S” hooks attach to rings at the corners

Rainfly pole inserts into grommets

Things You Should Know

•

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent.Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

•

Seam sealer has not been provided with your tent.We recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

•

Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

•

See owners manual for more tips.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AW A Y FROM THIS TENT FABRIC. This tent meets the flammability

requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA

illus. 6

Assembled tent without rainfly.

illus. 9

Stake out the tent with

adjustable guylines.