Coleman Garden Gazebo 14x12 User Manual

14’x12’ GARDEN GAZEBO

When You Are Ready To Set Up Your Shelter

–Select a level area clear of rocks,

branches and other hard or sharp objects. –Do not assemble your shelter under trees. –For easier set up, two or more people

are recommended.

ASSEMBLY PARTS

Instructions apply to Part Number 9392-642

Leg Poles (6)

Part No. 9392-3151

Ground Poles (Green) (6)

Part No. 9392-3101

Eave Poles (6)

Part No. 9392-3111

Eave Hub (6)

Part No. 9392-3021

Corner Hub (6)

Part No. 9392-3031

Cupola Top

Pole (6)

Part No.

9392-3131

Cupola Eave

Pole (6)

Part No.

9392-3121

Ground Pole

Hub (6)

Part No.

9392-3011

Center Hub(1)

Part No.

9392-2351

Overhead Poles (6) Part No. 9392-3141

Illus. 1

Cupola Top Poles inserted into Center Hub

Cupola

Top Pole

Overhead

Pole

Eave Hub

Eave Pole

Corner Hub

Leg Pole

Ground Pole Hub

Ground Pole

Illus. 2

Cupola and Eave

assembly

Illus. 3

Ground poles assembled

under partially assembled

frame structure.

Pole & Hub Assembly

–Begin with the Center Hub and Cupola Top Poles. –Insert the clip end of Cupula Top Poles into the

center hub and connect one pole at a time to the hub. (illus. 1)

–Attach the Eave Hub to the open end of the

Cupola Top Pole (illus. 2)

–Assemble shock-corded Eave and Overhead poles. –Connect the Overhead poles to the

bottom opening of the Eave Hub. (illus. 2) –Attach Corner Hubs to Overhead Poles. (illus. 2) –Connect the Eave Poles to Corner Hub. This will

make a six sided hexagon shape. (illus. 2)

–Insert one end of the Leg Pole into bottom of the

Corner Hub. Do not fully assemble the Leg Pole.

Leave the lower section laying on the ground.

(illus. 3). –Repeat for remaining Leg Poles.

–Assemble the shock-corded Ground Poles. –Working under the partially assembled frame,

insert one end into the 3 sided Ground Pole Hub.

The center opening should be pointing up. (illus. 3) –Insert the other end into a second Ground Pole

Hub. Continue by adding another Ground Pole to

the open side of the Ground Pole Hub until you

can close the loop, forming a hexagon shape.

(illus. 3)

PRINTED IN SRI LANKA Rev. 12/04

Things You Should Know

•

Never store shelter, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your shelter. Use separate storage bag.

•

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE SHELTER FABRIC OR STAKE LOOP TO REMOVE STAKE.

•

SHELTER POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

WARNING: Keep all flame and heat sources away from this shelter fabric.

This shelter meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the shelter fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN SRI LANKA

illus. 6 Fabric draped over

partially assembled frame

illus. 8

Completed shelter with guy lines staked out

illus. 4

Cupola Eave Pole

connects to Cupola

Top Pole through

fabric opening.

illus. 5

Cupola Eave Pole

about to be inserted

into Pole Pocket on

underside of

cupola eave.

Attach Shelter to Frame

–Drape the canopy over the frame (illus. 6) –You may need to stand inside the frame to adjust

the Cupola over the poles.

–Pull back the cupola eave fabric find the openings

for the Cupola Eave Poles. You should be able line up the openings with the open end of the Cupola Top Poles. (illus. 4)

–Connect the Cupola Eave Pole to the Cupola Top

Poles through the fabric opening. (illus. 4)

–Now pull the Cupola Eave fabric out over the

Cupola Eave Pole until you can insert the pole end into the pole pocket on the underside of the eave fabric. (illus. 5)

–Position the fabric corners over the pole corners.

(illus. 6)

–Secure fabric to frame by attaching hook & loop

fasteners around poles.

Stand-up Shelter and Connect to Ground Poles

–Fully connect the Leg Poles to stand the shelter up. –Align the Ground Pole assembly so the Hubs are

directly in front of the Leg Poles

–Lift one of the Leg Poles and insert it into the

Ground Pole Hub. Repeat for other Leg Poles. (illus. 9)

–Insert the brass hook into the hole

near the base of the pole (illus. 7)

–Adjust hook straps to increase

tautness. (illus. 7)

–Attach guy lines to fabric guy

loops at each corner and stake out. (illus. 8)

Leg Pole

illus. 7

Insert Brass Hook into hole near the base of the pole

Use to adjust or tighten fabric