Coleman FC9M060B12UP11, FC9M080B12UP11, FC9M080C16UP11, FC9M100C16UP11, FC9M100C20UP11 Technical Manual

259720-CTG-B-0108

DESCRIPTION

These Category IV, highly efficient, compact, condensing
type furnaces are designed for residential and commercial
installations in a basement, closet, alcove, recreation room or
garage where the ambient temperature is above 32°F, or
higher. They may be either side wall or thru-roof vented using
approved plastic type combustion air and vent piping. All
units are factory assembled, wired and tested to assure
dependable and economical installation and operation.

TECHNICAL GUIDE

Echelon
MODELS: FC9M*UP

GAS-FIRED
CONDENSING / HIGH EFFICIENCY
UPFLOW MODULATING FURNACES

NATURAL GAS
60 - 120 MBH INPUT

EFFICIENCY
RATING
CERTIFIED

ISO 9001

Certified Quality

Management System

Due to continuous product improvement, specifications
are subject to change without notice.

Visit us on the web at www.york.com for the most
up-to-date technical information.

Additional rating information can be found at
www.gamanet.org.

WARRANTY

Lifetime limited warranty on both heat exchangers to the orig­inal purchaser; a 20-year limited warranty from original instal­lation date to subsequent purchaser.

10-year warranty on the heat exchanger in commercial appli­cations.

5-year limited parts warranty.

FEATURES

• Modulating heating operation includes:

- Modulating gas valve

- Modulating inducer operation

• Provides increased comfort level & very quiet unit opera­tion

• Compact, easy to install, ideal height 40" cabinet

• Blower-off delay for cooling SEER improvement.

• Easy to connect power/control wiring.

• Built-in, high level self diagnostics with fault code display.

• Low unit amp requirement for easy replacement applica­tion.

• Integrated control module for reliable, economical opera­tion.

• May be installed as either two-pipe (direct vent) or single
pipe vent (using indoor combustion air)

• Top intake & vent connection allows installation in narrow
locations.

• Electronic Hot Surface Ignition saves fuel cost with
increased dependability and reliability.

• Induced combustion system with inshot main burners for
quiet, efficient operation.

• No special vent termination kit required.

• 100% shut off main gas valve for extra safety.

• PSC -four speed, direct drive motor with large, quiet
blower.

• 24V, 40 VA control transformer and blower relay supplied
for add-on cooling.

• Hi-tech tubular aluminized steel primary heat exchanger.

• Secondary (condensing) heat exchanger of 29-4C high­grade stainless steel.

• Solid removable bottom panel allows easy application.

• Easy access from front of unit for cleaning, maintenance or
service.

• Protection from intake, exhaust or condensate blockage.

• Insulated blower compartment for quiet operation.

FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE

259720-CTG-B-0108

26-1/2
24-5/8

1-1/2” GAS
PIPE ENTRY

7/8” JUNCTION
BOX HOLE

T-STAT WIRING
7/8” K.O.

CONDENSATE
DRAIN 7/8” K.O.

OPTIONAL RETURN AIR
CUT-OUT (either side)
FOR USE WITH
EXTERNAL FILTER
FRAME

7/8

LEFT SIDE

23-3/4

30-1/8

11

7

21-1/2

13-7/8

7/8

26-3/4

BOTTOM IMAGE

RETURN END

30-7/8

FRONT

1-3/8

C

A

1-1/4

40

28-3/8

21-1/2

11

8

24-3/8

20

D

2

24-7/16

TOP IMAGE

SUPPLY END

5/8

5/8

B

26-1/2

25-3/8

1-1/2” GAS
PIPE ENTRY

7/8” JUNCTION
BOX HOLE

T-STAT WIRING
7/8” K.O.

CONDENSATE
DRAIN 7/8” K.O.

RIGHT SIDE

DIMENSIONS

Models

Nominal

CFM

Cabinet

Size

A (in.) B (in.) C (in.) D (in.)
FC9M060B12UP11 1200 B 17-1/2 16-1/4 14-1/2 8-1/2
FC9M080B12UP11 1200 B 17-1/2 16-1/4 11 8-1/2
FC9M080C16UP11 1600 C 21 19-3/4 18 8-7/8
FC9M100C16UP11 1600 C 21 19-3/4 18 8-7/8
FC9M100C20UP11 2000 C 21 19-3/4 18 8-7/8
FC9M120D20UP11 2000 D 24-1/2 23-1/4 21-1/2 10-5/8

Cabinet Dimension

2 Unitary Products Group

ELECTRICAL AND PERFORMANCE DATA

259720-CTG-B-0108

Models

Input

Max/Min

MBH MBH In. HP Amps °F °F

Output

Max/Min

Blower

Size

Blower

Max.

Over-current

Protect

Air Temp. Rise

Maximum Input

Air Temp. Rise

Minimum Input

FC9M060B12UP11 60/21 57/20 11 x 8 1/2 7.7 20 40 - 70 20 - 50
FC9M080B12UP11 80/28 76/26 11 x 8 1/2 7.7 20 40 - 70 20 - 50
FC9M080C16UP11 80/28 76/26 11 x 10 3/4 10.2 20 40 - 70 20 - 50
FC9M100C16UP11 100/35 95/33 11 x 10 3/4 10.2 20 40 - 70 20 - 50
FC9M100C20UP11 100/35 95/33 11 x 11 1 12.8 20 40 - 70 20 - 50
FC9M120D20UP11 120/42 115/39 11 x 11 1 12.8 20 40 - 70 20 - 50

Models

Max. Outlet

Air Temp.

°F CFM In. Amps %

Nominal

Airflow

Cabinet

Width

Total

Unit

AFUE

Min. Wire Size

(awg) @ 75 ft.

One Way

Approximate

Operating Weight

Power Supply

(Voltage-PH-Hz)

FC9M060B12UP11 170 1200 17-1/2 9 95.0 14 135 115-1-60
FC9M080B12UP11 170 1200 17-1/2 9 95.0 14 142 115-1-60
FC9M080C16UP11 170 1600 21 12 95.0 14 157 115-1-60
FC9M100C16UP11 170 1600 21 12 95.0 14 162 115-1-60
FC9M100C20UP11 170 2000 21 14 95.0 12 164 115-1-60
FC9M120D20UP11 170 2000 24-1/2 14 95.0 12 180 115-1-60

* ESP (External Static Pressure) .5" WG is at furnace outlet ahead of cooling coil.
Annual Fuel Utilization Efficiency (AFUE) numbers are determined in accordance with DOE Test procedures.
Wire size and over current protection must comply with the National Electrical Code (NFPA-70-latest edition) and all local codes.
The furnace shall be installed so that the electrical components are protected from water.

NOTES:

1. For altitudes above 2000 ft. reduce capacity 4% for each 1000 ft. above sea level.

2. Wire size based on copper conductors, 60°C, 3% voltage drop.

3. Continuous return air temperature must not be below 55°F.

4. All filters must be high velocity cleanable type.

5. Air flows above 1800 CFM require either return from two sides or one side plus bottom.

Unitary Products Group 3

259720-CTG-B-0108
For additional connection diagrams for all UPG e quipment refer to “Line Voltage System Wiring” document available on-line at

www.upgnet.com in the Product Catalog Section.

AC 11A Single Stage Air Conditioner – PSC Modulating Furnace

ID MODELS

PM9

FC9M

THERMOSTAT

FL9M

*PP11C70224

Y

Full Stage Compressor

RH
24 – Volt Hot
(Heat XFMR)

G

Fan

RC
24 – Volt Hot
(Cool XFMR)

W

Full Stage Heat

HM1

Humidistat

24VAC Humidifier

(Optional)

PSC

MODULATING

FURNACE

PSC

MODULATING FURNACE

C

24 – Volt Common

Y/Y2

Second or Full

Stage Compressor

R

24 – Volt Hot

G

Fan

W

Modulating Heat

Single Stage Compressor

Y1

SINGLE STAGE
SINGLE STAGE

AIR

AIR CONDITIONER

CONDITIONER

SINGLE STAGE

1

SINGLE STAGE

AIR CONDITIONER

AIR CONDITIONER

C

24 – Volt Common

Y

Y

Compressor

Compressor Contactor

Clipping Jumper W914 for
electric heat on thermostat

is not necessary

Thermostat Chart - PSC Modulating Furnace/Single Stage Air Conditioner

4 Unitary Products Group

Part Numbers:

SAP = Legacy

155941 = 031-09140

1