Coleman Eagle Rock User Manual

Connect Frame to Tent
– Insert one pin into the end of main tent
pole at tent corner. (illus. 3, illus. 4)
– Go to opposite end of pole and
gradually apply pressure to the pole forming an arch until you are able to
insert the pin into the pole end. – Repeat for second pole. – Insert pin into the end of side pole, go to
opposite end of pole and apply pressure
until you arch the pole and can insert
the pin into the pole. (illus. 3, illus. 4) – Repeat for other side pole.
Eagle Rock
9’6”x7’
1
Layout & Positioning of Tent, Pole Assembly
– Layout and position tent with door facing
desired direction. (illus. 1) – Unzip door. – Stake down tent corners only, using the
stake loops. Keep the floor taut.
(Intermediate loops will be staked later.) – Assemble frame poles by interlocking
shock-corded poles. (four poles) – Insert the poles into pole sleeves.The
longer black poles should cross forming
an “X” in the middle of tent. The shorter
side gray poles insert into sleeves
running front to back. (illus. 1)
2
When You Are Ready To Set Up Your Tent
– Select a level campsite clear
of rocks, branches and other hard or sharp objects.
– Do not set up your tent
under trees.
– For best results in windy
conditions position the end of tent into the wind.
Part No. 9277G9501
Front Door
Side Poles
Assembled poles inserted through pole sleeves
Instructions apply to Part Number 9277G957
illus. 1
illus. 2
Tent stake
through ring
on stake loop
illus. 4
Tent frame
set-up
Part No. 9277G9531
Part No. 9277G9521
illus. 3 Insert pin into pole end
Rainfly
Part No. 9277G9511
(2) Main Tent Poles
(2) Side Poles
(2) Rainfly Pole
3
Attach Tent to Frame Using Frame Clips
– Attach frame clips along the
edges of tent to frame poles. (illus. 5), (illus. 6)
– Make any adjustments to the
tent corner stakes, if needed.
– Stake out remainder of
intermediate loops.
4
Attach Rainfly
– Assemble rainfly poles, by interlocking
shock-corded poles.
– Insert rainfly pole through the pole
sleeves located at the center edges of the underside of rainfly. (illus. 7)
– Drape rainfly over tent frame, pole side
down. Rainfly poles go over door and rear window.
– Connect the four elastic loops with
“S” hooks, (found at the rainfly corners) to the fabric loops near frame clips.
– Insert tip of rainfly pole into the
grommet on the front of the tent and gently arch the pole until you can insert the opposite end in the other grommet. Repeat for back side of tent.
– Secure rainfly with hook & loop and
ties located on underside of fly. (illus. 8)
– Attach and stake out guylines.
illus. 6 Assembled tent without rainfly. Note the frame clips located on edge of tent.
illus. 5
Frame Clips
illus. 8 Completed tent with rainfly.
illus. 7
Underside
of rainfly
attaches to
frame poles
Rainfly Pole
Sleeves
Guyline
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
PRINTED IN CHINA Rev. 11/05
Things You Should Know
Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.
Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use separate storage bag.
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.
TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.
Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.
Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage nylon material and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.
Loading...