Coleman DURANGO 9271-210 User Manual

DURANGO™FAMILYCABIN™20'X10'

Layout & Positioning of Tent

–Layout and position tent with door

facing desired direction. (illus. 1)

–Stake down tent, starting with

the corners. Do not stretch too tight. Angle the stakes slightly toward the tent. (illus. 2) Keep the floor taut.

–Unzip the door.

Assemble & Place Roof Poles

–Assemble all shock-corded

roof poles.When assembled will form a continuous arch with both ends pointing down. (illus. 3)

–Select center roof poles (longer,3 section)

and insert them diagonally through the two center roof sleeves.They cross and form an “X”. (illus. 1 & 4)

–Select end roof poles (shorter, 2 section).

and insert them through the roof sleeves at each end of the tent. (illus. 1)

When You Are Ready To Set Up Your Tent

–Select a level campsite clear

of rocks, branches and other hard or sharp objects.

–Do not set up your tent

under trees.

–For best results in windy

conditions, position the end of tent into the wind.

–See owners manual for

more tips

Center Curved Roof Poles

Part No. 9271-205

End Curved Roof Poles

Part No. 9271-206

End Brace Poles

Part No. 9271-203

Center Brace Poles

Part No. 9271-202

Rainfly Poles

Part No. 9271-204

Rainfly Part No. 9271-201

Instructions apply to Part Number 9271-210

illus. 3 Three section curved roof pole assembly.

illus. 4 Curved roof pole system shown

inserted diagonally through pole sleeves.

illus. 2

Stake loops

properly staked

Front door

End roof sleeve

Center curved roof poles diagonally

through pole sleeves

illus. 1

Pole sleeves

Shock corded poles

Forms an arch

Shock-corded

POLE ASSEMBLY PARTS

Raise Tent

–Assemble center shock-corded brace poles

(longer poles).

–Insert square end of brace poles into

curved roof poles and raise tent upright. (illus. 5, 6)

–Brace poles should attach to squeeze

pins at bottom of tent. (illus 7)

–Assemble end (shorter) shock-corded

brace poles.

–Insert end brace poles into end

roof assemblies.MAKE SURE when attaching the brace poles to the curved poles that the bottom of the brace pole naturally points down and toward the center of the tent. (illus. 9)

–Brace poles attach to squeeze

pins at edge of tent. (illus. 8)

illus. 6 Shown with center brace poles and end brace poles in position.

Center brace pole

Grommets for rainfly pole

End brace

pole

illus. 8

Rainfly poles

through pole

sleeves

Rainfly pole inserts into

grommets on tent

illus. 5 When attaching the brace poles to the curved poles make sure that the brace poles naturally point straight down.

illus. 9 Tent shown completely set-up.

Attach Rainfly

–Assemble rainfly poles,by interlocking

shock-corded poles.

–Insert rainfly pole through the pole

sleeves located at the center edges of the underside of rainfly. (illus. 8)

–Drape rainfly over tent frame, pole side

down. rainfly poles go over door and rear window and attach “S” hooks on rainfly into holes in brace poles.(illus. 11)

–Secure rainfly with hook & loop

fasteners located on underside of fly. (illus. 9)

–Insert tip of rainfly pole into the

grommet on the front of the tent and gently arch the pole until you can insert the opposite end in the other grommet.. Repeat for back side of tent. (illus. 6 & 9)

–Stake out rainfly ends using included

guylines. (illus. 10)

Brace pole

Curved poles in pole sleeve

Brace pole with hole for rainfly “S” hooks

illus. 10 Stake out rainfly

ends. Slide the disc up

the rope to tighten

guyline.

illus. 7 Insert squeeze pin into pole

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN SRI LANKA

PRINTED IN SRI LANKA Rev. 12/03

Things You Should Know

•

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent.Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent.It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.NEVER PULL ON THE TENT F ABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

•

Seam sealer has not been provided with your tent.We recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

•

Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements

of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.