Coleman Dome 9556A605K User Manual

Connect Frame to Tent

– Insert one end of main tent pole

onto pin of pin & ring system, at tent corner. (illus. 3)

– Go to opposite end of pole and

gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole.

– Repeat for second pole. (illus. 4)

Layout & Positioning of Tent, Pole Assembly

– Layout and position tent with door

facing desired direction. (illus. 1) – Unzip door. – Stake down tent corners only, using

the rings at the end of the stake loops.

(illus.2) Keep the floor taut. – Assemble frame poles by

interlocking shock-corded poles.

This will make two long poles. – Insert the poles diagonally into pole

sleeves. The center of the poles

should cross forming an “X” in the

middle of tent. (illus. 1)

Assembled poles

inserted through

pole sleeves

illus. 1

illus. 2

Tent stake through ring

illus. 3

Insert pole end onto pin & ring

illus. 4

Tent frame set-up

6’x5’ DOME

When You Are Ready To Set Up Your Tent

– Select a level campsite clear of

rocks, branches and other hard

or sharp objects. – Do not set up your tent under trees. – For best results in windy conditions,

do not position the door of tent

into the wind.

(1) Rainfly

Pole

Rainfly Part No.

9556-1081

(2) Main Tent

Poles

POLE ASSEMBLY PARTS

Instructions apply to Part Number 9556A605K

Part No. 9556-1061

Part No. 9556-1071

Attach Tent to Frame Using Frame Clips

– Attach frame clips along

the edges of tent to frame poles. (illus. 5), (illus. 6)

– Make any adjustments to the tent

corner stakes that are needed.

Attach Rainfly

– Assemble rainfly pole by

interlocking shock-corded pole.

– Insert rainfly pole into reinforced

pockets located at the center edges of the underside of rainfly. (illus. 7), (illus. 8)

– Attach underside of rainfly to the

rainfly pole. (illus. 8)

– Drape rainfly over tent frame, pole

side down. Rainfly pole should point out over door and rear window.

– Connect the four elastic loops with

“S” hooks, (found at the rainfly corners) to the four rings at the corners of the tent.

– Secure rainfly with attachments

located on underside of fly. (illus. 9)

– Stake out the tent with (2) side

guylines. (illus. 9)

illus. 6

Assembled tent without rainfly.

illus. 5

Frame clips

illus. 7 Insert rainfly

pole into pocket on underside of rainfly

illus. 9

Completed tent with rainfly.

illus. 8

Underside of rainfly attaches to frame poles

Side guyline

Rainfly pole pockets

Rainfly pole pocket

Pole

attachments

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN VIETNAM

PRINTED IN VIETNAM Rev. 11/06

Things You Should Know

•

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•

TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

•

Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

Stake down doormat