Coleman Denali 9230-410 Instructions Manual
– Position the two 5-section 3-way hub Side Poles
approximately 10’ apart. (illus. 1)
– Place the 5-section 4 way hub Ridge Pole between
and parallel to the two Side Poles. (illus. 1)
– Attach the four 5-way Corner Hub (A)s to the ends of
the outside side poles. (illus. 1), (illus. 2)
– Attach the two 5-way Hub (B)
to the ends of the middle
ridge pole. (illus. 1), (illus. 2)
– Connect the six 2-section roof
poles to the hubs to complete
the roof frame main section.
(illus. 1), (illus. 2)
– Attach the ten 1-section poles
to the open hub on each
corner and the center ridge
pole to fully complete the
roof frame assembly.
(illus. 1), (illus. 2)
– Attach the four corner upright
poles to the downward
hub at each corner. (illus. 2)
– Attach the two center
upright poles to the
downward hub on
the center ridge. (illus. 2)
Denali
™
14’x10’
When You Are Ready To Set Up Your Tent
– Select a level campsite clear of rocks, branches and
other hard or sharp objects.
– Do not set up your tent under trees.
– For best results in windy conditions, position the end
of tent into the wind.
Instructions apply to Part Number 9230-410
(4) Corner Upright Poles
Part No. 9230-3671
(2) Center Upright Poles
Part No. 9230-3811
(6) 2-Section Poles
Part No. 9230-3771
(10) 1-Section Poles
Part No. 9230-3691
Rainfly
Part No.
9230-3661
POLE ASSEMBLY PARTS
1 Frame Assembly
5-WAY CORNER
HUB (A)
SIDE POLE
w/ 3-WAY HUB
SIDE POLE
w/ 3-WAY
5-WAY
HUB (A)
5-WAY
HUB (A)
CENTER
POLE
5-WAY
HUB (B)
2-SECTION
POLES
CORNER
POLE
5-WAY HUB (B)
CORNER
HUB (A)
SIDE POLE
w/ 3-WAY HUB
SIDE POLE
w/ 3-WAY HUB
RIDGE POLE
w/ 4-WAY HUB
2-SECTION
POLES
1-SECTION
POLES
illus. 2 Tent Frame Assembly
illus. 1 Roof Frame Assembly
(2) Side Poles w/ 3-way hub
Part No. 9230-3711
(1) Ridge Pole w/ 4-way hub
Part No. 9230-3751
(4) 5-way Corner
Hubs (A)
Part No. 9230-3791
(4) 5-way Corner Hubs (B)
Part No. 9230-3791
RIDGE POLE
w/ 4-WAY HUB
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
PRINTED IN SRI LANKA Rev. 1/06
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Seam sealer has not been provided with your tent. For additional protection
we recommend seam sealing your tent prior to camping. Seam sealer may be
purchased through your local retailer or at your local sporting goods store.
•
Do not leave your tent set-up for weeks at a time, be aware that
exposure to the ultraviolet rays of the sun can seriously damage material
and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the
flammability requirements of CPAI-84. The fabric will burn
if left in continuous contact with any flame source. The
application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
Guylines
3 Attach Tent to Frame
– Position tent under tent frame. (illus. 5)
– Locate the row of 5 hooks with red webbing.
This is the middle of the tent.
– Starting in the middle attach the hook on the
center of the tent roof through the hole on the
center 4-way hub. (illus. 5)
– Attach the hook of side edge of the tent
through hole on 5-way Hub (B)on the ridge.
Repeat for second side hook. (illus. 5)
– Attach the corner hooks on the tent through
holes on 5-way corner Hub (A)s. (illus. 5)
– Insert pole pin at the end of the fabric loop at
the base edge of the tent sides and four
corners, into the bottom of the poles. (illus. 6)
– Attach the pole clips to the tent poles. (illus. 7)
– Stake out tent through the rings with the
pole pins. (illus. 8)
– Stake out guylines. Two at each end, two
at each corner and one at each ridge.
(illus. 4), (illus. 7)
2 Attach rainfly
– Drape rainfly over top of tent frame,
with the pole pocket on under side of fly. (illus. 3)
– Insert end of 1-section pole into pole pocket on
under side of rainfly. Repeat for the other nine 1section poles and pole pockets. (illus. 3), (illus. 4)
illus. 3
Attaching
Rainfly
illus. 5
Tent under frame
hooked in 3 places to
hubs
illus. 4
Pole
Pockets
Attach
Guylines
illus. 6
Insert squeeze
pin into pole
illus. 8
Tent stake
through ring
Pole clips
Tent hooks
to hubs
illus. 7
Completed tent with rainfly.
Loading...