Coleman Cimmar 9260C727 User Manual

Cimmaron™10’x7’ With Vestibule

Instructions apply to Part Number 9260C727

When You Are Ready To Set Up Your Tent

– Select a level campsite clear of rocks,

branches and other hard or sharp objects. – Do not set up your tent under trees. – For best results in windy conditions,

do not position the door of tent into

the wind.

Layout & Positioning

of Tent, Pole Assembly

– Layout and position tent with door

facing desired direction. (illus. 1) – Unzip door. – Stake down tent corners only, using the

rings at the end of the stake loops.

Keep the floor taut. (illus. 2) – Assemble frame poles by

interlocking shock-corded poles.

This will make two long poles. – Insert the poles diagonally into pole

sleeves.The center of the poles should

cross forming an “X” in the middle of

tent. (illus. 1)

(2) Main

Tent Poles

(1) Rainfly

Pole

POLE ASSEMBLY PARTS

Part No. 9260C722

Part No. 9260C723

Rainfly

Part No. 9260C721

Connect Frame to Tent

– Insert one end of main tent pole end onto

pin of pin & ring system, at tent corner. (illus. 3)

– Go to opposite end of pole and

gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole.

– Repeat for second pole.

Assembled poles inserted through pole sleeves

illus. 1

illus. 2 Tent stake

through ring

illus. 4

Tent frame

set-up

illus. 3

Insert pole end onto pin & ring

Attach Tent to Frame

Using Frame Clips

– Attach frame clips along

the edges of tent to frame poles. (illus. 5), (illus. 6)

– Make any adjustments to the tent

corner stakes that are needed.

Attach Rainfly

– Assemble rainfly pole by

interlocking shock-corded pole.

– Insert rainfly pole through pole

sleeve above vestibule door on the underside of rainfly. (illus. 7), (illus. 8)

– Drape rainfly over tent frame, pole

side down. Rainfly pole should be over the tent door.

– Insert one end of rainfly pole end

onto pin of pin & ring system, at the front tent corner. (illus. 4)

– Go to opposite end of pole and

gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole.

– Connect the four elastic loops with

“S” hooks, (found at the rainfly corners) to the four rings located at the end of the stake loops at the corners of the tent.

– Secure rainfly with frame ties

located on underside of fly. (illus. 8) – Stake out the tent with guylines. (illus. 8) – Stake out front of the vestibule.

illus. 5

Frame clips

illus. 7

Insert rainfly pole piece through the pole sleeve on the underside of the rainfly

Guyline

“S” hooks attach rings at the corners

illus. 6

Assembled tent without rainfly.

Frame ties

Pole sleeve

Vestibule door may be rolled up and secured with toggle & loops for added

ventilation

Guyline

illus. 8 Completed tent with rainfly.

Note where rainfly pole sleeves, rings, and under ties are located.

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.)

•

condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

Never store tent, even for a short period of time, without drying it

•

thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BYPULLING ON THE STAKE ITSELF.

•

NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

•

TOGETHER DURING STORAGE.

Seam sealer has not been provided with your tent. For additional protection

•

we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

PRINTED IN CHINA Rev. 7/04

Do not leave your tent set-up for weeks at a time, be aware that

•

exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEA T SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA