Coleman Bayside User Manual
Connect Frame to Tent
–Insert pin into the ends of the main tent poles
at the rear of the tent on either side of the Pet
Den. (illus. 3, illus. 4) Go to opposite end of
pole and gradually apply pressure to the pole
forming an arch until you are able to insert the
pin at the front tent corner, into the pole end.
(works best standing in the open door way,
with two people) Repeat for second pole.
–Insert pin on the side tent into the end of the
main pole running above the front door. Go to
opposite end of pole and gently apply
pressure to the pole forming an arch until you
can insert the side pin into the pole end.
(illus. 3), (illus. 4)
–Insert other side pin into grey side pole end
and gently apply pressure to the pole, forming
an arch until you can insert the pin at the rear
of tent into the pole end. (illus. 4), (illus. 5)
–Insert Pet Den pole into
grommets on the sides
of the Pet Den.
Bayside™Family Dome with Pet Den
15’x10’
1
Layout & Positioning
of Tent, Pole Assembly
–Layout and position tent with door facing
desired direction. (illus. 1)
–Unzip door.
–Stake down tent, using the rings on the
stake loops and the corner fabric loops.
Keep the floor taut. (illus. 2)
–Assemble frame poles by interlocking
shock-corded poles. (3 main poles, 2 side
poles, 1 Pet Den pole)
–Insert one main tent pole through the pole
sleeve above the front door. Insert the other
two main poles through the pole sleeves
angling front to back, they will cross each
other. (illus. 1)
–Insert two (Grey) side poles through the pole
sleeves toward the back corners of the tent.
–Insert Pet Den pole through pole sleeve at
rear of tent.
2
When You Are Ready To Set
Up Your Tent
–Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions,
position the end of tent into the wind.
Rainfly Pole
Front Door
Side Pole
Side Pole
Pet Den Pole
Assembled black
main tent poles
inserted through
pole sleeves.
Instructions apply to Part Number 9277A151
illus. 1
illus. 2
Tent stake
through ring
on stake loop
illus. 4
Tent frame set-up
illus. 5
Pet Den
Part No. 9277A3301
Part No. 9277A3601
Main Tent
Poles (Black)
Part No. 9277A3501
Side Poles
(Grey)
Pet Den Pole
Part No. 9277A3401
illus. 3
Insert pin into
pole end
Rainfly Part No. 9277A3701
Side pole
Main pole
Side Pins
Main pole
above door
Pet Den
pole
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Seam sealer has not been provided with your tent. For additional
protection we recommend seam sealing your tent prior to camping. Seam
sealer may be purchased through your local retailer or at your local sporting
goods store.
•
Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous
contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties
ineffective.
Attach Tent to Frame
Using Frame Clips
–Attach frame clips along
the edges of tent to frame poles.
(illus. 6), (illus. 7)
–Make any adjustments to the tent
corner stakes that are needed.
3
4
Attach Rainfly
–Assemble rainfly pole by
interlocking shock-corded pole.
–Insert rainfly pole through pole
sleeve at the center of the front
curved edge on the underside of
rainfly. (illus. 8), (illus. 10)
–Drape rainfly over tent frame, pole
side down. Rainfly pole should be over
front door.
–Connect the eight elastic loops with
hooks, (found at the rainfly corners)
to the eight fabric loops on the bottom
row of frame clips. (illus. 9), (illus. 10)
–Insert the tips of the rainfly poles
into the grommets on the front
of tent. (See above illus. 7)
–Secure rainfly with attachments
located on underside of fly.
(illus. 9)
–Attach and stake out 4 guy lines
at the front and rear of tent.
illus. 7
Assembled tent without rainfly.
NOTE:
Grommets
for rainfly
pole are on
frame clip
webbing
illus. 6
Frame clips
illus. 8 Insert rainfly
poles through the
pole sleeve on
underside of rainfly
illus. 10
Completed tent
with rainfly.
illus. 9
Underside of
rainfly attaches
to frame poles
Rainfly pole
in grommet
Rainfly hooks attach to fabric loops
on the corner frame clips (illus. 9)
Guy line
Hooks attaches
to fabric loop
PRINTED IN CHINA Rev. 11/05
Loading...