Coleman 9392-2251, 9392-2321, 9392-2301, 9392-2261, 9392-2311 User Manual
...
Pole & Hub Assembly
–Begin with the Center Hub and Canopy
Poles.
–Insert the end marked TOP into the
center hub and connect one pole at a
time to the hub. (illus1), (illus. 4)
–Add a canopy hub to the five open
ends of the center hub assembly.
(illus. 2), (illus. 4)
–Insert the clip end of Leg Connector
Poles into the Canopy Hub.
–Where the two open ends of the
Leg Connector Poles meet, insert them
into the two angled openings of the Leg
Hub. Repeat for 4 more sets. (illus. 3),
(illus. 4)
–Insert clip end of Leg Pole into
open end of Leg Hub. Disconnect the
shock-corded Leg Pole so that the
lower spiked pole is laying on the
ground. (illus. 4)
15’x15’ GEOSPORT™SCREENHOUSE
1
2
3
4
When You Are Ready To Set Up Your
Shelter
–Select a level area clear of rocks,
branches and other hard or sharp objects.
–Do not assemble your shelter under trees.
–For easier set up, two or more people
are recommended.
ASSEMBLY PARTS
Instructions apply to Part Number 9392-515
Leg Poles (5)
Part No. 9392-2301
Leg Connector Poles (10)
Part No. 9392-2311
Leg Hub (5)
Part No. 9392-2271
Center Hub Part (1)
No. 9392-2251
Canopy Poles (5)
Part No. 9392-2321
Canopy Hub(5)
Part No. 9392-2261
Illus. 4
Partially assembled
frame with all hubs
in position
Illus. 3 Leg Hub
Partially assembled
frame locked into hub
Illus. 1
Poles inserted
into hub
Illus. 2
Canopy Hub
Center Hub
Canopy Pole
Center Hub
Canopy Hub
Leg Hub
Leg Pole
Canopy
Pole
Leg Connector Poles
Leg Connector Poles
Leg Pole
Leg Hub
5
PRINTED IN SRI LANKA Rev. 11/04
Things You Should Know
•
Never store shelter, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your shelter. Use separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE SHELTER FABRIC OR SHELTER STAKE LOOP TO
REMOVE STAKE.
•
SHELTER POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
•
Do not leave your shelter set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away from this tent fabric.
This shelter meets the flammability requirements of CPAI-84. The fabric will
burn if left in continuous contact with any flame source. The application of
any foreign substance to the shelter fabric may render the flame-resistant
properties ineffective.
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
Attach Shelter to
Frame
–Drape the canopy over the frame (illus. 5)
–Position each corner over a Leg Hub
–Fully extend each pole by
completing the interlocking of the
shock corded pole sections.
–Insert the brass hook into the hole
near the base of the pole (illus. 6, 8)
–From the inside of the shelter secure
the pole frame to the shelter with the
hook and loop closures.
–Adjust poles to pull the shelter taut
and stake down through the fabric
loops at the end of each pole
–Adjust hook straps to increase
tautness (illus. 7)
–Attach guy lines to fabric
guy loops at each corner
and stake out (illus. 7)
illus. 5 Shelter draped over
partially assembled frame
illus. 6
Insert Brass Hook
into hole near the
base of the
illus. 8
Completed shelter with guy lines
staked out
illus. 7
Stake through
Stake Loop
Use to adjust or
tighten canopy
Loading...