Coleman 9277-139 User Manual

Connect Frame to Tent

–Insert one pin into the end of gray side tent

pole at tent corner. (illus. 3, illus. 4)

–Go to opposite end of pole and gradually

apply pressure to the pole forming an arch until you are able to insert the pin into the pole end. (works best with two people)

–Choose either black pole and insert the pin

into one end of the main tent pole and gradually apply pressure forming an arch until you can insert the pin in the other end

–Repeat for second black main tent pole.

(illus. 3, illus. 4)

TACOMA

™

13’x9’

Layout & Positioning of Tent, Pole Assembly

–Layout and position tent with doors

facing desired directions.(illus.1) –Unzip doors. –Stake down tent, using the rings on the

stake loops.Keep the floor taut.(illus.2) –Assemble frame poles by interlocking

shock-corded poles.(three poles) –Insert the black main tent poles through

the two pole sleeves (ea.) as shown

below.The poles will run parallel.(illus.1) –Insert the longer gray side pole through

the three pole sleeves running the

opposite direction of the black poles.The

gray pole should be on top of the black

poles where they cross.

When You Are Ready To Set Up Y our Tent

–Select a level campsite clear of

rocks, branches and other hard or

sharp objects. –Do not set up your tent under trees. –For best results in windy conditions,

position the end of tent into the wind. –See owners manual for more tips.

Rainfly Poles

Door

Grey side pole

through pole

sleeves and over

black poles

Assembled black main tent poles inserted through pole sleeves

Instructions apply to Part Number 9277-139

illus. 1

illus. 2

Tent stake

through ring

on stake loop

illus. 4

Tent frame

set-up

Part No.9277-407

Part No.9277-406

Part No.9277-408

Main Tent Pole (Black)

Side Pole (Gray)

illus.3 Insert pin into pole end

Rainfly Part No. 9277-409

Grommets for rainfly poles

Door

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA

PRINTED IN CHINA Rev. 7/03

Things You Should Know

•

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent.Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

•

Seam sealer has not been provided with your tent.We recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

•

Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

•

See owners manual for more tips.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability

requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

Attach Tent to Frame Using Frame Clips

–Attach frame clips along

the edges of tent to frame poles. (illus. 5), (illus. 6)

–Make any adjustments to the tent

corner stakes that are needed.

Attach Rainfly

–Assemble rainfly poles by

interlocking shock-corded pole.

–Insert rainfly poles through pole

sleeves located at the center edges of the underside of rainfly. (illus. 7), (illus. 8)

–Drape rainfly over tent frame, pole

side down. Rainfly poles should be over doors.

–Connect the six elastic loops with

“S” hooks, (found at the rainfly corners) to the six rings located at the end of the stake loops at the corners of the tent.

–Insert the tips of the rainfly poles

into the grommets on the front and rear of tent. (See above illus. 6)

–Secure rainfly with attachments

located on underside of fly. (illus. 8)

–Stake out the tent with (2) side

guylines and (4) corner guylines.

illus. 6

Assembled tent without rainfly.

Grommets for rainfly pole

illus. 5

Frame clips

illus. 7 Insert rainfly pole piece into pocket on underside of rainfly

illus. 8 Completed tent with rainfly.

Underside of rainfly attaches to frame poles

Side

guyline

Corner guyline

Rainfly pole in

grommet

“S” hooks attach to rings at the corners

Rainfly pole

through

pole sleeves

Clear window