Coleman 9260F304 User Manual

Connect Frame to Tent
–Insert one end of main tent pole
onto pin of pin & ring system, at tent corner. (illus. 4)
–Go to opposite end of pole and
gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole.
SUNDOME
10’ x8’
1
Layout & Positioning of Tent, Pole Assembly
–Layout and position tent with door
facing desired direction. (illus. 1) –Unzip door. –Stake down tent corners only, using the
rings at the end of the stake loops.
(illus. 2) Keep the floor taut. –Assemble frame poles by
interlocking shock-corded poles.
This will make two long poles. –Insert the poles diagonally into pole
sleeves.The center of the poles should
cross forming an “X” in the middle of
tent. (illus. 1) –Fasten frame tie on top of tent over
both poles. (illus. 1), (illus. 3)
2
When You Are Ready To Set Up Your Tent
–Select a level campsite clear of rocks,
branches and other hard or sharp objects. –Do not set up your tent under trees. –For best results in windy conditions, do not
position the door of tent into the wind. –See owners manual for more tips.
Rainfly
Pole
Rainfly Part No. 9260F304
Main Tent
Poles
POLE ASSEMBLY PARTS
Assembled poles inserted through pole sleeves
Frame tie
Instructions apply to Part Number 9260F108
illus. 1
Tent frame set-up
illus. 3
Frame tie
Part No.9260D302
Part No.9260C303
illus. 2
Tent stake
through ring
illus.4
Insert pole end onto pin & ring
3
Attach Tent to Frame Using Frame Clips
–Attach frame clips along
the edges of tent to frame poles. (illus. 5), (illus. 6)
–Make any adjustments to the tent
corner stakes that are needed.
4
Attach Rainfly
–Assemble rainfly pole by
interlocking shock-corded pole.
–Insert rainfly pole into reinforced
pockets located at the center edges of the underside of rainfly. (illus. 7), (illus. 8)
–Attach underside of rainfly to the
rainfly pole. (illus. 8)
–Drape rainfly over tent frame, pole
side down. Rainfly pole should point out over door and rear window.
–Connect the four elastic loops with
“S” hooks, (found at the rainfly corners) to the four rings located at the end of the stake loops at the corners of the tent.
–Secure rainfly with attachments
located on underside of fly. (illus. 9)
–Stake out tent with (2) side
guylines. (illus. 10)
illus. 6 Assembled tent without rainfly.
illus. 5
Frame clips
illus. 7 Insert rainfly pole piece into pocket on underside of rainfly
illus. 9 Completed tent with rainfly.Note where rainfly pole pockets, rings, and attachments are located.
illus. 8
illus. 10
Side guyline
Underside of rainfly attaches to frame poles
“S” hooks attach to rings at the corners
Rainfly pockets
Rainfly pocket
Pole
attachments
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
PRINTED IN CHINA Rev. 7/03
Things You Should Know
Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent.Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be mini­mized by removing wet clothing from your tent and by providing good ventila­tion through the tent.
Never store tent, even for a short period of time, without dr ying it thorough­ly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
Seam sealer has not been provided with your tent.We recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.
Do not leave your tent set-up for weeks at a time, be aware that expo­sure to the ultraviolet rays of the sun can seriously damage nylon material and/or cause it to become discolored.
See owners manual for more tips.
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability
requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.
Loading...