Coleman 9232E199 User Manual
WEATHERMASTER™ 17'x9'
1
Layout & Positioning of Tent
– Layout and position tent with door
facing desired direction. (illus. 1)
– Stake down tent, starting with
the corners. Do not stretch
too tight. Angle the stakes
slightly toward the tent.
(illus. 2) Keep the floor taut.
– Unzip the door.
2
Assemble & Place Roof Poles
– Assemble all shock-corded
roof poles. When assembled will
form a continuous arch with both
ends pointing down. (illus. 3)
– Select center roof poles with
red stickers and square ends. Then
insert them through the two center
roof sleeves. (illus. 4)
– Select end roof poles with
blue stickers and round ends. Then
insert them through the roof sleeves
at each end of the tent. (illus. 4)
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear
of rocks, branches and other
hard or sharp objects.
– Do not set up your tent
under trees.
– For best results in windy
conditions, position the end
of tent into the wind.
(2) Center Curved Roof Poles
(Red Sticker) Part No. 9232E302
(2) End Curved Roof Poles
(Blue Sticker) Part No. 9232E303
(4) End Brace Poles
(Blue Sticker) Part No. 9232E305
(4) Center Brace Poles
(Red Sticker) Part No. 9232E304
Rainfly Part No. 9232E307
Instructions apply to Part Number 9232E199
illus. 3 Curved roof pole assembly.
illus. 4 Curved roof pole system shown
inserted through pole sleeves. Square end, red
sticker poles go into two center pole sleeves. Round end,
blue sticker poles go into two end pole sleeves.
illus. 2
Stake loops
properly staked
Front door
Roof sleeve
illus. 1
Pole sleeves
Shock corded poles
Forms an arch
POLE ASSEMBLY PARTS
3
Raise Center of Tent
– Assemble center shock-corded brace poles
(red sticker, longer poles). Pole should be
initially adjusted to the inner most hole “A”.
(illus. 7)
– Insert square end of brace poles into
curved roof poles and raise tent upright.
(illus. 5, 6, 7)
– Brace poles should attach to squeeze
pins at bottom of tent. (illus. 8)
illus. 5
Shown with both
center brace poles
in position and
curved poles
through both
center pole
sleeves.
Center brace pole
Rainfly
4
illus. 6 When attaching the brace poles
to the curved poles make sure that the
brace poles naturally point straight down.
illus. 9 Tent shown completely set-up.
Raise Sides of Tent
– Assemble end (blue sticker, round
ends) shock-corded brace poles.
– Insert (blue sticker) brace poles into
end roof assemblies. MAKE SURE
when attaching the brace poles to the
curved poles that the bottom of the
brace pole naturally points down and
toward the center of the tent. (illus. 9)
– Brace poles should attach to squeeze
pins at bottom of tent. (illus. 8)
– Can be adjusted to accommodate
for terrain
– Drape rainfly over tent and attach
“S” hooks on rainfly into holes in
brace poles. (illus. 9)
Brace pole
Curved
poles in pole
sleeve
Brace pole
with hole
for rainfly
“S” hooks
illus. 8
Insert squeeze
pin into pole
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
PRINTED IN SRI LANKA Rev. 7/04
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is caused by
water vapor from your breath, perspiration, or any wet clothing inside your tent. It is
NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing
from your tent and by providing good ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it thoroughly and
brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate
storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER
PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Seam sealer has not been provided with your tent. For additional protection we
recommend seam sealing your tent prior to camping. Seam sealer may be purchased
through your local retailer or at your local sporting goods store.
•
Do not leave your tent set-up for weeks at a time, be aware that exposure to
the ultraviolet rays of the sun can seriously damage material and/or cause it to
become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM
THIS TENT FABRIC. This tent meets the flammability requirements
of CPAI-84. The fabric will burn if left in continuous contact with any
flame source. The application of any foreign substance to the tent
fabric may render the flame-resistant properties ineffective.
Poles should be
initially adjusted to the
inner most hole “A”.
illus. 7
Loading...