#90403E
FILTER PUMP
OWNER’S MANUAL
Website: www.bestwaycorp.com/support
DO NOT RETURN THIS ITEM TO THE STORE OR
WEBSITE WHERE IT WAS PURCHASED. PLEASE
VISIT WWW.BESTWAYCORP.COM/SUPPORT
FOR QUESTIONS, OR FOR DEFECTIVE OR
WARRANTY CLAIMS.
303021190746
WARNING
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be followed,
including the following:
READ AND FOLLOW ALL INSTRUCTIONS
WARNING - RISK OF ELECTRIC SHOCK - The pump cannot be using while people are inside
the pool.
WARNING - TO REDUCE THE RISK OF INJURY, do not permit children to use this product
unless they are closely supervised at all times.
WARNING - RISK OF ELECTRIC SHOCK. Connect only to a grounding type receptacle. This
product is provided with a ground-fault circuit-interrupter. If replacement of the plug is needed, use only
identical replacement parts.
WARNING: The unit is provided with a ground-fault circuit-interrupter (GFCI). To test the GFCI,
push the test button. The GFCI should interrupt power. Push the reset button. Power should be restored. If
the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the pump
without the test button being pushed, a ground current is flowing, indicating the possibility of an electric
shock. Do not use this pump. Disconnect the pump and have the problem corrected by a qualified service
representative before using.
CAUTION - To reduce the risk of electric shock the pool must be installed no closer than 6 feet
(1.8 m) from any electrical outlet. Do not place portable appliances closer than 5 feet (1.5 m) from the pool.
WARNING: The pump is not intended to be bonded to the equipotential bonding grid.
DO NOT BURY CORD. Locate cord to minimize abuse from lawn mowers, hedge trimmers, and other
equipment.
WARNING - To reduce the risk of electric shock, replace damaged cord immediately. If the
supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
WARNING - To reduce the risk of electric shock, do not use extension cord to connect unit to
electric supply; provide a properly located outlet.
CAUTION - This pump is for use with storable pools only. Do not use with permanently-installed
pools. A storable pool is constructed so that it is capable of being readily disassembled for storage and
reassembled to its original integrity. A permanently-installed pool is constructed in or on the ground or in a
building such that it cannot be readily disassembled for storage.
CAUTION - For continued protection against possible electric shock this unit is to be mounted to
the base in accordance with the installation instructions.
IMPORTANT - Using the pump with an unmatched electrical supply is dangerous and will
result in catastrophic failure of pump.
RISK OF ELECTRIC SHOCK - When working with electricity, turn the electrical power off at the circuit
breaker and lock breaker door. Failure to do so will result in increased risk of shock, injury and possibly
death.
DO NOT REMOVE THE GROUNDING PRONG OR MODIFY THE PLUG IN ANY WAY. DO NOT USE
ADAPTOR PLUGS. Consult a qualified electrician for any questions related to the validity of your plugs
grounding. Handle the pump with care. Do not pull or carry the pump by the power cord. Never pull a plug
from the outlet by yanking the power cord. Keep cord free from abrasions. Sharp objects, oil, moving
parts, and heat should never be exposed to the filter pump.
NOTE: Please examine equipment before use. Notify Bestway at the customer service address
listed on this manual for any manufacturing defect or missing parts at the time of purchase. Verify that the
equipment components represent the filter pump model that you had intended to purchase.
2
NOTE: Place pump on a solid and level ground. Pay attention to position of pool and pump so
adequate ventilation, drainage, and access for cleaning is available. Never place pump in an area that
may accumulate water, or in an area where foot traffic will flow around the pool.
NOTE: Atmospheric conditions may affect the performance and life span of your filter pump.
Unnecessary wear and tear may occur during periods of cold, heat and exposure to sun. Whenever
possible shelter the pump from these conditions.
NOTE: Do not add chemicals in the filter pump.
NOTE: Assembly and disassembly of this product should only be performed by adults.
• THERMALLY PROTECTED MOTOR CSA ENCLOSURE 3.
• FOR USE WITH SWIMMING POOLS ONLY.
• CAUTION: TO ENSURE CONTINUED PROTECTION AGAINST SHOCK HAZARD, USE ONLY
IDENTICAL REPLACEMENT PARTS WHEN SERVICING.
• WARNING: RISK OF ELECTRIC SHOCK. CONNECT ONLY TO A GROUNDING TYPE
RECEPTACLE.
• CAUTION: THIS PUMP IS FOR USE WITH STORABLE POOLS ONLY - DO NOT USE WITH
PERMANENTLY-INSTALLED POOLS.
• CAUTION: CONNECT ONLY TO GROUNDING TYPE RECEPTACLE PROTECTED BY A
CLASS A GROUND FAULT CIRCUIT INTERRUPTER.
• CAUTION: FOR CONTINUED PROTECTION AGAINST POSSIBLE ELECTRIC SHOCK THIS
UNIT IS TO BE MOUNTED TO THE BASE IN ACCORDANCE WITH THE INSTALLATION
INSTRUCTIONS.
• WARNING - RISK OF ELECTROCUTION
1) Connect Only To Properly Grounded Outlet. Do Not Remove Ground Pin.
2) Inspect Cord Before Using – Do Not Use If Cord Is Damaged.
3) Keep Ground-Fault Circuit-Interrupter Dry And Off The Ground.
4) Do Not Touch Plug With Wet Hands.
5) Double Insulated – When Servicing Use Only Identical Replacement Parts.
6) Read Instruction Manual Before Using.
DO NOT REMOVE THIS TAG
SAVE THESE INSTRUCTIONS.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
WARNING: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
3
P6029
P6124
P6029
P61730
P6113
P61739
P61730
P6113
P61731
P61732
P61733
58505/90358
P61735
P61736
P61740
P4134
P6517
P61734
P6005
P6019
P6029
Part Code
P61730
P6113
P61731
P61732
P61733
58505/90358
P61734
P61735
P61736
P61740
P61739
P6019
P6517
P6124
P6005
P6029
P4134
P61408
P6680
P61408
P6680
QTY
2
2
1
1
1
1
1
1
2
1
1
2
1
4
2
3
1
1
2
1 2
A
P6019
P6517
3 4
A
B
B
P4134
B
P6019
P61408
B
B
P6680
4
A
A
B
B
A
B
B
B
ABA
B
P6124
NOTE: You must
clean the filter cartridge every day
and open the top valve let the air out
then close it before using the pump, otherwise the pump may not work.
PEDESTAL FIXING Fig.1
The filter pump must be vertically fixed on ground or a certain
pedestal made of wood or concrete before use.
There should be two holes 7mm in diameter on the pedestal, the
space between which should be 256mm. Put filter pump on the
pedestal and fix them together by fasten the bolts and nuts. All the
pedestal parts should weigh over 18kgs at least to prevent the pump
from accidental falling.
450
256
300
270
6
6
Operation
1) Open/unscrew the Air Purge Valve on the the Filter Pump; air is released as water fills the
Filter Pump.
2) When water comes out of the Air Purge Valves, close both the Air Purge Valves and wipe
away any water.
3) Test the GFCI plug.
4) Start the Filter Pump by turning on the switch to the “I” position.
GFCI Test
A B C D
Fig.1
RESET
TEST
A. To test the GFCI plug, insert it into a grounding type receptacle.
B. Press the “RESET” button; the indicator turns red.
NOTE: If the indicator light is not on, the test has failed.
C. Press the “TEST” button. The indicator turns off.
NOTE: If the indicator light is not off, the test has failed.
D. Press the “RESET” button, the indicator light turns red, and the filter pump is ready for use.
RESET
TEST
RESET
TEST
WARNING: RISK OF ELECTRIC SHOCK. THE GFCI MUST BE TESTED BEFORE EACH
USE.
WARNING: DO NOT USE THE PUMP IF THE ABOVE TEST FAILS. Please contact your local
Coleman
Customer
Service.
5
NOTE: Never operate pump while the connection valves are closed.
NOTE: To prevent the risk of electrical shock, ensure your hands are completely dry when
plugging-in the Filter Pump.
IMPORTANT: DO NOT DRY RUN THE FILTER PUMP - Make sure both the pool’s Inlet and
Outlet valves are fully covered by water before operating the Filter Pump.
PUMP MAINTENANCE
CAUTION: YOU MUST ENSURE THE FILTER PUMP IS UNPLUGGED BEFORE ANY
MAINTENANCE OR STORAGE BEGINS OR SEVERE RISK OF INJURY OR DEATH EXISTS.
1) Unplug the Filter Pump.
2) Stop water flowing to the Filter Pump refer to pool’s manual.
3) Unscrew the Filter Cap Retainer and remove the Filter Cap.
4) Clean the Filter Cartridge with a garden hose. If filter cartridge remains soiled or discolored, it is necessary to replace it with a new one.
5) Insert the cleaned (or new) Filter Cartridge; ensure it is centered in the Filter Pump.
6) Check that the Filter Cap Seal is in place.
7) Replace the Filter Cap and screw the Filter Cap Retainer into position.
8) Open the Valve A and B.
9) Follow the PUMP INSTALLATION DIRECTIONS section to prepare the system for use.
IMPORTANT: To ensure pool water stays clean, please clean the filter cartridge every day.
For sanitary reasons we suggest replacing the Filter Cartridge with a new one every two weeks.
PUMP STORAGE
1) Unplug the Filter Pump.
2) Stop water flowing into the Filter Pump and to remove the Filter Cartridge.
3) Discard the Filter Cartridge.
4) Detach all Hoses.
5) Dry all components thoroughly.
6) Store the filter pump in a dry location out of the reach of children. Storage temperature: 4-40
7) Drain the pool according to the Pool Owner’s Manual.
PUMP WARRANTY
For information concerning pump warranty please visit our website at: www.bestwaycorp.com
º
C (39.2-104F)
6
T
I
E
M
I
D
L
•
•
360 DAYS ON PUMP
•
W
The product you have purchased comes with a limited warranty from the manufacturer Bestway®.
®
Bestway
stands behind our quality guarantee and assures, through a replacement warranty, your product will be free from manufacturer’s
defects.
The limited warranty is valid as follows:
360 days for the motor pumps, 30 days for hoses, fitting and accessory included in the package, all from the original date of
purchase.
To file a warranty claim, please contact your Bestway® After Sales Center at 1-855-838-3888 before sending any documents. They will
provide full instructions of what is needed for your claim. Bestway
will not replace any products deemed to have been neglected or used outside of the owner’s manual guidelines. Bestway’s warranty covers
manufacturing defects discovered while unpacking the product or during use, as recommended within the user manual. This warranty applies
only to products that have not been modified by any 3rd parties. The product must be stored and handled in accordance with the technical
recommendations.
The warranty does not cover damages caused by misuse, abuse, neglect, including but not limited to: collision, fire, excessive heat exposure,
improper use of chemicals, exposure to extreme weather conditions, improper installation, or improper storage.
Replacements and repairs don’t extend the duration of warranty. The warranty start date is the date of sale shown on the original
receipt/ purchase invoice.
®
is not responsible for economic loss due to water or chemical costs and
•
Y
T
A
N
R
R
A
Please copy the Batch Number found on the body of the filter pump.
Batch Number
BATCH NUMBER:
TO: Bestway® Service Department
Website: www.bestwaycorp.com
Toll-Free:1-855-838-3888
Please provide your address details in full.
Note: Incomplete address details will result in delayed shipments.
®
Bsetway
reserves the right to charge for redelivery of undelivered packages where the recipient is at fault.
Batch Number
Date of purchase:
Date:
Customer Code Number:
Batch Number
REQUIRED INFORMATION - PLEASE WRITE THE SHIPPING ADDRESS
Name:
City:
Address:
Country / State:
Zip code: Retailer:
Mobile:
Fax:
Telephone:
E-mail:
Please Clearly Write Your Item Code:
POOL FILTER PUMP
MODEL
#XXXXX
Item Code
IMPORTANT: ONLY THE DAMAGED PART WILL BE REPLACED, NOT THE COMPLETE SET.
Bestway® reserves the right to request photographic evidence of defective parts, or to require sending the item for additional testing.
In order to best assist you, we request all information you provided to be complete.
FOR FAQ, MANUALS, VIDEOS OR SPARE PARTS, PLEASE VISIT OUR WEBSITE: www.bestwaycorp.com
VIDEOS ARE ALSO AVAILABLE ON OUR BESTWAY CHANNEL ON YOUTUBE: www.youtube.com/user/BestwayService
7
© 2015 The Coleman Company, Inc.
and are registered trademarks of The Coleman Company, Inc., used under license.
Manufactured by
©2015 Bestway (USA) Inc., 3411 E. Harbour Drive, Phoenix, Arizona 85034, United States of America
®™ Trademarks used in some countries under license to
Bestway Inflatables & Material Corp., No.3065 Cao An Road, Shanghai, 201812, China
www.bestwaycorp.com
Loading...