Parts List
1. 5010000350 4-watt Fluorescent Tube
TO INSTALL OR REPLACE BATTERIES
Your new lantern operates on 6 “D” cell batteries. For longest life, use alkaline batteries.
1. With lantern off, turn upside down and unscrew base by rotating counterclockwise
then lift off base. (Fig. 1)
2. Press in tab and open battery cover. (Fig. 2)
3. Install 6 batteries in the correct orientation as shown on the battery housing.
Always be careful that all 6 batteries are installed correctly. (Fig. 3)
4. Close battery cover then replace base and turn clockwise until hand tight. Check
that base is securely installed in closed position.
TO CHANGE FLUORESCENT BULB
NOTE: This lantern uses two standard 6 inch (15.2 cm),
4-watt fluorescent tubes.
(See Parts List for replacement #).
1. With lantern in normal upright position, remove top
cover by rotating counterclockwise until the index
mark is at OPEN position. (Fig. 4)
2. Lift off cover and remove old tube(s).
3. Install new 6 inch, 4 watt fluorescent tube(s). (Fig. 5)
4. Replace top cover and turn clockwise until the index
mark is at CLOSE position. (Fig. 4)
Fig. 1
Fig. 3
Fig. 4
Fig. 5
THINGS YOU SHOULD KNOW
1. Operating time for this lantern depends on whether it is run continuously or
intermittently. Intermittent operation extends the run time of a set of batteries.
2. In cold temperatures, the fluorescent tube is more difficult to light and may be
dim until it warms up. Below 20˚F (-7˚C), the bulb may not light.
3. When the fluorescent tubes are not lit to full brilliance, batteries should be
replaced. If this is not done and lantern is used, the tubes will become blackened.
4. IMPORTANT: Do not leave discharged batteries in the lantern for an extended
period of time as this could permanently damage the lantern.
5. To clean the outside of the lantern and globe, use only a damp cloth and mild
dishwashing liquid. Avoid excessive water and strong cleaner which can damage
the lantern.
Fluorescent tube(s) contains mercury (Hg) and
must be recycled or disposed of according to
local, state or federal laws. Call (800) 835-3278
or visit www.coleman.com/recycle for recycling
instructions or safe disposal locations.
OPEN CLOSE
TO OPERATE
Your Coleman®Personal Twin Tube Lantern has a three position switch:
• The center position is OFF.
• Turn the knob counterclockwise to I and only the left tube will light. (Fig. 6)
• Turn the knob clockwise to II and both tubes will light for maximum light output.
(Fig. 7)
Fig. 6
Fig. 7
NOTE: The time that the lantern will
operate depends on how it is used. On
new alkaline batteries, the run times
are as follows:
• 14 hours with both tubes (II) turned
on constantly
• 25 hours with one tube (I) turned
on constantly
OFF
OFF
OPEN CLOSE
1
Fig. 2
TAB