Coleman 5065-715 User Manual
Assembly
and
Instruction Manual
Fireplace/Charcoal Grill
Model 5065-715
U. S. & foreign patents pending
2
Your Coleman® RoadTrip® Fireplace/Grill is a versatile unit that
functions as either a fireplace or a charcoal grill. Follow these
instructions for assembly and read carefully, particularly the safety
statements. The safety alert symbol, is a universally recognized
symbol used to identify safety information about hazards that can
result in personal injury. When this symbol is used you should pay
very close attention to what is written. Review these instructions
before beginning assembly or using your fireplace.
Introduction
FOLLOW INSTRUCTIONS AND WARNINGS TO AVOID FIRE, SERIOUS
INJURY OR DEATH.
•
Outdoor use only. Never use in enclosed area. Use in unventilated
areas will endanger your life.
• Keep away from all combustible materials including gasoline and other
flammable liquids and vapors.
• Use on a level, noncombustible surface only. Keep away from house,
garage, balconies, or eave overhangs.
• Keep out of the reach of children.
• Be sure screen is in place while in use and do not use in windy conditions.
• Do not overfill firebox or use to burn leaves and trash.
• Exercise the same care you would with an open fire.
• Never leave unit unattended when hot or in use.
• Completely extinguish fire before leaving.
• Use gloves when handling or moving. Ashes can remain warm for a
long time after extinguishing.
• Dispose of cold ashes properly.
• Do not modify in any way nor use with parts not expressly approved by
Coleman.
• Combustion by-products produced when using this product contain
chemicals known to the State of California to cause cancer, birth defects,
or other reproductive harm.
Contact local authorities regarding possible burn restrictions before using
product.
WARNING
3
• Check package for all parts needed for assembly.
Fireplace/Grill Parts Check List
• Check all items for shipping damage. Call Coleman at 1-800-835-3278
or TDD: 316-832-8707 if you have any problems.
■■ 1. Lid
■■ 2.
Firebox
■■
3. Screen Assembly
■■
4. Hinge Pin
■■
5. Cooking Grate
■■
6. Charcoal Grate
■■ 7.
Handle (3)
■■ 8. Leg Receptors (3)
■■ 9. Telescoping Legs (3)
■■ 10. Wire Brace
■■ 11. Damper
■■ 12. Fastener Hardware
1
4
2
6
5
8
11
3
9
7
12
10
4
Assembly
1. Carefully unpack all parts from shipping box.
2. Insert Telescoping Legs into Receptors with spring clips inside legs.
Important: Orient legs so small tube welded to leg faces inward. This
will ensure proper fit of the Wire Brace. Legs extend by pushing in on
both spring clips protruding from the legs and pulling the legs outward.
Then lock leg in place by aligning spring clips with holes in legs. Always be
sure spring clip is protruding through holes in legs to ensure stability.
Small tubes
must face inward
Spring Clip
Telescoping
Leg
Receptor
3. Assemble Wire Brace to all 3 legs by inserting ends into the small tube
welded to each leg. If wire brace does not fit, check Step 2 above to be
sure small tube is facing inward.
Wire
Brace
Small
Tube
Loading...