Coleman 2000001977 Owner's Manual

SUNDOME®12’x10’ 2-ROOM

Instructions apply to Part Number 9180-121

When You Are Ready To Set Up Your Tent

– Select a level campsite clear of

rocks, branches and other hard

or sharp objects. – Do not set up your tent under trees. – For best results in windy conditions,

do not position the door of tent

into the wind.

Layout & Positioning

of Tent, Pole Assembly

– Layout and position tent with door

facing desired direction. (illus. 1) – Unzip door. – Stake down tent using the rings of the

pin & ring system at the corners of the

tent. Keep the floor taut. (illus. 2) – Assemble frame poles by

interlocking shock-corded poles.

This will make two long poles. – Insert the poles diagonally into pole

sleeves. The center of the poles

should cross forming an “X” in the

middle of tent. (illus. 1)

(2) Main Tent

Poles

(1) Rainfly

Pole

POLE ASSEMBLY P ARTS

Part No. 9180-318

Part No. 9180-319

Rainfly Part No.

9180-317

Connect Frame to Tent

– Insert one end of main tent pole

onto pin of pin & ring system at tent corner. (illus. 3)

– Go to opposite end of pole and

gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole.

– Repeat for second pole. (illus. 4)

Assembled poles inserted through pole sleeves

illus. 1

illus. 2

through ring

illus. 4 Tent

frame set-up

illus. 3

Insert pole end onto pin & ring

Tent stake

Attach Tent to Frame

Using Frame Clips

– Attach frame clips along

the edges of tent to frame poles.

(illus. 5), (illus. 6) – Make any adjustments to the tent

corner stakes that are needed.

Assembled tent without rainfly.

Attach Rainfly

– Assemble rainfly pole by

interlocking shock-corded pole. – Insert rainfly pole into reinforced

pockets located at the center

edges of the underside of rainfly.

(illus. 7), (illus. 8) – Attach underside of rainfly to

the rainfly pole. (illus. 8) – Drape rainfly over tent frame,

pole side down. The rainfly pole

should point out over the doors. – Connect the four elastic loops

with “S” hooks, (found at the

rainfly corners) to fabric loops

near frame clips. (illus. 9) – Secure rainfly with attachments

located on underside of fly.

(illus. 10) – Stake out tent with (6) guylines.

(illus. 10)

illus. 5

Frame clips

illus. 7 Insert Rainfly

pole piece into pocket on underside of rainfly

illus. 9

“S” hooks

illus. 6

Rainfly pole pocket

Pole

attachments

illus. 8 Rainfly

Rainfly pole pockets

Underside of rainfly attaches to frame poles

Side guyline

illus. 10 Completed tent with rainfly.

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.)

•

condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

Never store tent, even for a short period of time, without drying it

•

thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BYPULLING ON THE STAKE ITSELF.

•

NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOPTO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

•

TOGETHER DURING STORAGE.

Seam sealer has not been provided with your tent. For additional protection

•

we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

PRINTED IN CHINA REV. 7/04

Do not leave your tent set-up for weeks at a time, be aware that

•

exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant proper ties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA