Coleman 2000000456 User Manual

Assemble Frame

– Start with one of the Main Tent Poles and

gradually apply pressure to the pole, forming an arch, until you are able to insert the pole tip into the grommet on

the corner web. (illus. 4) – Repeat for second pole. – Go to the Side Pole and gradually apply

pressure to the pole, forming an arch,

until you are able to insert the pole

tip into the grommet. (illus. 4)

Phad X

™

part number 2000000456

Layout & Positioning of Rainfly, Pole Assembly

– Layout and position Rainfly with doors facing

desired direction. (illus. 1) Unzip doors.

– For best results in windy conditions, position

back of tent into the wind. – Stake down rear tent corners. (illus. 1) – Assemble frame poles by interlocking the

shock-corded sections. This will make two

long silver Main Tent Poles and one red

Side Pole. – Insert the cap end of the two Main Tent Poles

through the poles sleeves with the silver trim. – Insert the cap end of the red Side Pole through

the pole sleeve with the red trim.

Main Tent Poles (Silver)

Part No. 9830-1151

Side Pole (Red)

Part No. 9830-1251

Rainfly

Part No. 9830-1371

illus. 1

illus. 2

Tent stake

through Loop

illus. 3

Insert Pole Talon on stake loop into pole.

illus. 4

Tent frame up

POLE ASSEMBLY PARTS

Main Tent Poles

Side Poles

Things You Should Know

•

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•

Seam sealer has not been provided with your tent. It is necessary and we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

•

Never store tent, even for a short period of time, without

drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use separate storage bag.

•

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE

ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•

TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER

DURING STORAGE.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

Attach Tent

– Layout the tent. (illus. 5) – Position the tent in under the Rainfly – Starting at the back of the tent, clip the

tent to the Rainfly in the corners and then the side. (illus. 6)

– Attach the top of the tent to underside of

the Rainfly with toggle and loops. (illus. 7)

– Optional ground cloth in vestibule can be

removed at attached and clipped to the webbing at front of the Rainfly. (illus. 6)

– Stake out rainfly doors, keep rainfly

taut. (illus. 8)

– Attach Guy Lines to Guy Wings

on the sides of the Rainfly and stake out. (illus.8).

illus. 5

Tent ositions in under Rainfly

illus. 8

Completed tent with Rainfly.

Stake out

Guy Line

Tent toggles to loops on underside of Rainfly

illus. 6

Tent clips onto pole stake loop

illus. 7

Attach tent to underside of Rainfly with toggles