Colebrook Bosson Saunders AV/VC Intro AVS/031/SLF1 Installation Instructions Manual

Installation Instructions for

intro

AV/VC Intro Shelf Mount

AVS/031/SLF1

REFER ALSO TO MAIN
INSTRUCTIONS FOR AV/VC
INTRO STAND INSTALLATION

AVS/031/SLF1PARTS INCLUDED:

Shelf

M6 Screws x4

WARNING

• Do not install equipment heavier than 6kg/13.2lb.

• Use with products heavier than the maximum weights indicated may result in
instability causing possible injury.

• Correct installation is essential to safe and reliable operation of the AV/VC
Intro product and falls outside the scope of responsibility of Colebrook Bosson
Saunders. Please follow assembly instructions carefully.

• Do not use this product for any purpose other than that for which it was designed.

• Ensure that floor or wall surface is strong enough to support the weight of the
fully-loaded AV/VC Intro and that the floor surface is flat and level.

• Do not install AV/VC Intro outdoors or in environments where it will be directly
exposed to moisture or highwinds.

• Follow the manufacturer’s guidance for mounting of monitors, displays and
other equipment.

• Please take care to avoid trapping fingers when installing or adjusting the product.

Column Brackets x2

Shelf Brackets x2

ELECTRICAL SAFETY

• Safe installation of electrical equipment is the responsibility of the installer.

• Colebrook Bosson Saunders recommends that only double-insulated
electrical equipment and cables are installed in AV/VC Intro unit.

MAINTENANCE AND INSPECTION

• Ensure all screws and fixings are fully tightened and occasionally re-tighten
if necessary.

• Clean with a damp cloth. DO NOT use solvents.

DISCLAIMER

As part of Colebrook Bosson Saunders ongoing product improvement
programme, the design of products may change without prior notice and
details may vary from those illustrated.

M4 Screws x4

AVS-031-SLF1-INST-A-NOV 2016

Unlock and remove back panel

1

Install column brackets

2.1

POSITION COLUMN BRACKET ON THE INSIDE OF THE COLUMN

2

2.2

FIX COLUMN BRACKETS TO COLUMN USING

2X M4 SCREWS

2.3

REPEAT INSTALLATION PROCESS FOR

SECOND BRACKET