Rev . 090921
U / EN
User manual
NORDIC
Juice machine
Your retail dealer
...............................................................................
...............................................................................
2.
General !
Read the instructions carefully before you start working with this equipment.
The equipment should be installed and serviced by trained staff
General
Dispenser description for Nordic
Nordic is a dispenser for cooling water and mixing juice- concentrate to a ready to drink
product.The dispenser is for
three non-carbonated drinks and chilled water.
- The dispenser is connected to the water mains by a pressurised tube and to an electric wall
socket by a power plug.
- The water-pressure is adjusted with the water-regulator and the pressure is displayed on the
manometer.
- The water is chilled by the cooling-block, which in its turn is chilled by the air-cooled
compressor.
- The water-temperature is adjustable with a thermostat.The mixing ratio product/water is
adjusted with the ejectors.
- Pushing one of the four buttons on the front panel dispenses the mixed product or water.
Venturi ejector
The mixing ratio is adjusted on the ejectors. When water
flows through the ejector, the concentrate mixes with the
water.
The mixing ratio is regulated on the ejector. There are
two kinds, one for products with cells, and one for
products without cells.
Turn the adjustment screws according to the label on the
ejector in order to increase or decrease the amount of
concentrate.
3.
Dispenser description Nordic
Picture description
Water-regulator with manometer
The water-regulator can be adjusted up to 6 bar.
The minimum pressure is 2,2 bar.
Note! When adjusting the pressure, dispense product.
4.
Dispenser description Nordic
Picture description
Water valve
The Water valve is connected to the ejector and
opens the water-flow.
Push-button
The push buttons on the front panel
controls the water valves.
Use only one button at a time.
Cooling-block
The cooling-block is a flow through block with three built-in
stainless steel coils.
The coils are for water, refrigerant R134A and
thermostat
Transformer
The transformer is a 230 / 24 V (32 V A).
The transformer supplies 24 V to the magnetic-valves.
5.
Dispenser description Nordic
Picture description
Thermostat
The thermostat keeps the temperature within correct
range. Factory adjusted do not adjust, this may cause
damage and water leakage in the dispenser.
Illumination
Behind the front panel there is a low-energy fluorescent
lamp with the effect off 24W .
The fluorescent lamp is a PL-lamp.
Change low-energy lamp
Loosen frontplate (4 screws). (A), hold the frontplatte
see (B). Lift out frontplate (C) and change lamp.
assemble the frontplate.
AA
AA
B
C
D
6.
Dispenser description Nordic
Picture description
Drip-tray
It is possible to connect drainage to the drip-tray.
Large particle-filter
A large particle-filter is fitted between the cooling block
and the water valves.
It is possible to rinse the filter if needed.
7.
Installation and users instruction Nordic
Picture description
Unpack dispenser from the packaging and ensure
that nothing is damaged.
Place the dispenser to it´s position. Note:
The dispenser weights about 49 kg.
Don’t lift by door/front panel.
Allow a space of min. 40mm around the
frame for air circulation.
Place the machine on a flat level and waterproof surface.
If necessary adjustment with the adjustable feets.
8.
Installation and users instruction Nordic
Picture description
Connect the water-hose from the dispenser to the
cold water mains (do not forget seals).
Turn on the water and check for leaks.
Note!
It is strongly recommended to use some sort of
water isolator in the water line in case of an
emergency leakage.
Connect the power-plug to the wall socket.
Now the compressor starts and the front panel
lights up.
The water pressure is factory adjusted to
2.2 bar, which is the correct working pressure.
Check by pressing and holding one product button and
reading the manometer. If there is variations adjust by
pulling up knob and turn it until you get a reading of
2.2 bar.
9.
Installation and users instruction Nordic
Picture description
Place the bag-in-box in the dispenser and connect
it to the pinch solenoid-valve and ejector.
Pushing the centre of the pinch solenoid valve and
sliding the tube in from the side, fixes the tube.
Cut the tube to correct length and push it onto the
elbow connector on the ejector.
Place a cup under the outlet pipe.
Dispense a glass of product by pressing
the push-button.
Check that the brix-value (mixing ratio) is
okay , if not adjust.
T o adjust the brix, use the adjustment screw on the ejector .
The dispenser is now ready to use
10.
Maintenance Nordic
Change of bag-in-box
1. Turn the box so the perforated side is turned upwards.
2. Brake the perforation on the box and place the main pipe
in the punched hole
3. Place the box in the dispenser so that the tube points
down to wards the pinch-solenoid. Press the end of the
pinch-solenoid and insert the tube from the side
4. Check the tube length so that it will reach 1cm into the
venture nipple.
5. If the tube is to long, cut it to the right length.
6. Slip the tube to the venture nipple.
7. Make sure that the tube is not twisted, and shut the door to
the dispenser.
8. Place a cup under the outlet-pipes and draw until the juice
comes out.
Daily cleaning
1. Clean internal and external surface with a damped rag.
2. Use the cleaning-brush to clean the outlet-pipes
3. Wet the brush in water and put it in the outlet pipe from the
inside of the door.
4. Clean the drip-tray .
11.
Maintenance Nordic
Periodic cleaning
1. Disconnect the bag-in-box tube from the
venture.
2. Fill the cleaning bottle with warm water and
some washing-up liquid and connect it to
the venture.
3. Shut the dispenser door and put a cup under the
outlet-pipes rinse the venture and the outletpipes by pressing the respective push buttons.
4. Use the cleaning-brush to clean the outlet pipes
Return the boxes and connect the tubes to
the ventures.
12.
Handling and cleaning instructions Nordic
1. Open the Bag-in-Box at the perforation. Pull out the
silicon tube and the plastic connector, so it is clear of the
box.
2. Place the box inside the dispenser. Press in the pinch
solenoid and slide the tube in to the opening. (Fig 2)
3. Push the tube onto the ejector nozzle. (Fig3)
4. The dispenser is now ready to use.
1. When changing the Bag-in-Box, the dispenser should
be cleaned with hot water.
2. Fill the rinsing bottle with a solution of hot water and a
sanitising agent. Add two drops of washing-up liquid.
Connect the tube to the nozzle and wash it through.
(Fig 4)
3. Wet the brush in a hot water and sterilising solution.
Clean the outlet pipes by pushing the brush all the way
through the pipe and back again. (Fig 5)
4. Rinse the pipes with the water solution from the bottle.
5. The pinch solenoid that the tube runs through should be
cleaned on a regular basis, by pouring a hot water and
sterilising solution over it. This will dissolve any residual
concentrate.
6. The air inlet (condenser) at the back of the machine should be
cleaned from dust on a regular basis by brushing or
vacuuming the grid.
Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4. Fig. 5.
13.
Trouble shooting Nordic
Problem Probable cause Attend to
Concentrate is
Dripping from outlet
pipe.
The tube is not
properly fixed into the
pinch solenoid valve
Fix the tube properly into
the pinch solenoid valve
Mostly water or only
water coming from
outlet pipe
The tube is kinked due
to incorrect length
Cut the tube to correct
length
The pinch solenoid needs
cleaning.
The tube is twisted. Untwist the tube.
Clean pinch solenoid
with hot water.
The bag is empty. Replace bag.
Nothing happens
when I push the
buttons, and there is
no ”clicking” sound.
No power to the valves
Check the valve on/off key switch inside the door.
Thermo fuse in the
transformer has cut.
(On older models, a fuse
has blown).
Remove power to the
dispenser and put it back
on after 10 sec.
(Change fuse).
Nothing happens
when you push the
buttons, and there is a
”clicking” sound.
Water supply turned off
Check water supply
Water regulator turned off
or failed.
(Manometer =0 bar).
Check water regulator
(change needle valve in
water regulator).
The cooling coil has
frozen.
(Manometer = max
pressure)
Shut off water supply and
call service.
14.
Trouble shooting Nordic
Problem Probable cause Attend to
The taste is to strong/
weak.
The dispenser is not
cleaned properly.
Clean ejector, outlet pipes
and pinch solenoid.
The ejector is not adjusted
correctly.
Dirt in the water valve. Call service.
Call service.
It constantly drips
fluid from the outletpipes.
Call service.
Troubles with cooling
system.
The drinks are not
cold.
Failure in thermostat. Call service.
Failure in cooling system. Call service.
15.
Technical data Nordic
Electrical connection 230 V/50 Hz/ 2,5 A
Water connection 3,0 m T ube with 3/8" internal thread (minimum 2,2bar
water pressure.)
Compressor Elektrolux GL 80
Cooling gas HFC-134 a Amount to fill 240 gram
Cooling capacity 294 W
Cooling system Dry block with stainless-steel pipes inside.
Front light 24 W Fluorescent-lamp
Front sign size 400 x 550 mm
Dispenser measurement Height 745 mm
With 385 mm
Depth 560 mm
Weight 49 Kg
Note 1. The thermostat is factory adjusted and improper adjustment
may cause the cooling system to freeze causing damage or
water leakage in the dispenser.
Note 2. It is strongly recommended to use some sort of water isolator in
the water line in case of an emergency leakage.
Note 3. Maximum ambient temperature in the room where the dispenser
is located should not exceed more then 25 C.
Note 4. If the dispenser has frozen, check water tubs and connections
inside the dispenser before running the dispenser again.
Notes Nordic
16.
Dimension sketch.
NORDIC
Juice machine
COFFEE QUEEN
Art. nr/Art. no. 1704145
FOR SERVICE
Please contact your retail dealer
Din återförsäljare / Your retail dealer
...............................................................................
...............................................................................
...............................................................................
COFFEE QUEEN AB, Box 960, 671 29 ARVIKA, besöksadress; Korpralsv 1B,
T el vxl; +46 (0)570-47700, Fax; +46 (0)570-47719
E-mail: info@coffeequeen.se www.cof feequeen.se
Loading...