Codelocks KL1200 User Manual

INSTALLATION GUIDE

CODELOCKS LTD UK

Tel: [phone]
Fax: [phone]
[e-mail]

Helpline, service & spares
FREEPHONE 0800 393 405

CODELOCKS INC US

Tel: [phone]
Fax: [phone]
[e-mail]

KitLock is a
Codelocks Ltd brand

www.codelocks.com

www.kitlock.com

Replace existing cam lock with KitLock

A

Step 1 Remove existing cam lock.

Step 2 Place the 16mm (5/8") template

II-KL1200-v1:0313

hole over the hole left by the
cam lock and mark the upper
and lower fixing holes.

Step 3 Drill the two 6mm (1/4") fixing holes.

Step 4 Fit lock to door with gasket in

place using fixing bolts. Cut bolts

to correct length. Crimp several

times with the cutting jaws of pliers,

the surplus end should break off

quite easily. Measured from

beneath the bolt head, the length

should be the door thickness, plus

approx 12mm (1/2").

New Installation

B

Step 1 Place template on door and mark

upper and lower 6mm (1/4")

fixing holes and 16mm (5/8")

spindle hole.

IMPORTANT NOTE: Before

drilling fixing holes, please

ensure the position of the

KitLock when fitted will allow

enough clearance for selected

cam to work.

Step 5 From the inside of the door

select and fit appropriate
spindle and cam using fixing
bolt. Cut bolt to suit length
of spindle plus approx
10mm (3/8").

Step 6 Before closing the door check

the operation of the lock with
Master and User Code.

Step 7 If not changed already

CHANGE FACTORY SET
MASTER AND USER CODE
NOW!

Step 2 Drill all three fixing holes.

Step 3 Continue installation from step 4

to 7 from the Installation Guide
section A).

Vertical

KL12OO

Installation
Instructions

SPECIAL NOTES FITTING INSTRUCTIONS

Please read carefully:

• Before installing the lock, load
the batteries and familiarise
yourself with the operation and
programming.

• The handle will not turn until you
enter the factory default Master
Code 11 33 55 77 or the User
Code 22 44.

• Please see Programming Guide
to set your new Master and
User Codes and to set different
functions on lock if required.

The KitLock can be tted to:

A Cabinets, cupboards and lockers

etc as a direct replacement for
existing cam locks.

1

KitLock

2

Gasket

3

Upper and lower fixing bolts x 3*

4

Cam spindles x 4

5

Cams x 2

6

Cam fixing bolt

Batteries – 2 x 1.5V AAA
Template x 1

B It can also be fitted easily to

cupboards and cabinets that do not
have an existing locking device.

OPEN

LOCKED

KL12OO

*1 spare fixing bolt provided Please see installation guide on reverse