CODELOCKS CL5500 SERIES, CL5510, CL5510PK, CL5010 Installation Instructions Manual

10/23/2018 KA-01201 · Customer Self-Service

Home (/) > Knowledge Base - Home (/knowledgebase/) > KA-01201

CL5500 - US Version Installation
Instructions

Box Contents

Check the contents of the box are correct

Views: 82

Print



https://support.codelocks.com/knowledgebase/article/KA-01201/en-us 1/8

10/23/2018 KA-01201 · Customer Self-Service

FUNCTIONS

https://support.codelocks.com/knowledgebase/article/KA-01201/en-us 2/8

10/23/2018 KA-01201 · Customer Self-Service

CL5510 LATCH FUNCTION

Outside handle turns freely without operating the latchbolt. When the code is entered the keypad will flash
blue and the handle will retract the latchbolt. The latch automatically locks the door when closed. The key
will open the door without the code.



OPERATIONS CHECK

You should familiarise yourself with the operation of the lock and check that all the parts work properly.

Remove the battery cover from the back plate and install the 4 x AA cells supplied.

Connect the cables from the front plate and back plate. A BEEP should be heard when you do this. If no
BEEP is heard then check that the batteries are correctly installed.

Place the long spindle in the front plate socket and using finger grip only, test that the spindle is easily
moved 80° in both directions. Leave socket in the centred position.

Enter the factory Master Code #12345678.

The keypad will flash blue and the spindle should not turn as before. After 5 seconds the keypad will flash
red and the spindle should turn easily again. This confirms that the clutch engaged correctly when the code
was entered.

N.B. When the Master Code is entered 3 times consecutively without performing a programming function,
a penalty time of 10 seconds is activated.

Disconnect the cables.



SPECIAL FIXING NOTE

REMOTE RELEASE OPTION

Cables are provided for the REM 1 and REM 2 terminals on the circuit board.

https://support.codelocks.com/knowledgebase/article/KA-01201/en-us 3/8