T E C H N OLO G I E S I N C .
AMPLIFIER 60.0
OPER ATION MANUAL
+BANK -BANK
CODA TECHNOLOGIES, INC. MONO BALANCED AMPLIFIER
SAFETY PRECAUTIONS
INTRODUCTION
INITIAL SETUP
DESIGN PHILOSOPHY
TECHNICAL DATA
60.0
1
2
4
7
CARE AND HANDLING
WARRANTY AND DISCLAIMER
WARRANTY REGISTRATION
8
9
10
SAFETY PRECAUTIONS
CAUTION
CAUTION
WARNING
WARNING
CAUTION: TO PREVENT ELECTRIC SHOCK,
DO NOT REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE, REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
THIS SYMBOL IS TO ALERT YOU OF THE
PRESENCE OF UNINSULATED DANGEROUS VOLTAGE WITHIN THE UNIT'S
ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A
RISK OF ELECTRIC SHOCK.
!
WARNING:
CAUTION -
THIS SYMBOL IS INTENDED TO ALERT
YOU OF THE PRESENCE OF IMPORTANT
OPERATING AND MAINTENANCE
!
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE. TO
AVOID ELECTRICAL SHOCK, DO NOT OPEN THE
UNIT. REFER SERVICING TO QUALIFIED PERSONNEL.
Never install or remove the power cord from the chassis
unless it has been disconnected from the AC power source
rst.
Never pull on the power cord when removing it from an AC
-
power source. Grasp it by the plug.
Do not leave the power cord connected to an AC power
-
source unless it is connected to the unit.
-
It is recommended that during extended periods of nonuse
the unit's power cord be unplugged from its AC power
source.
Route the AC power cord so that it will not be damaged or
-
walked on.
INSTRUCTIONS IN THE LITERATURE
ACCOMPANYING THE UNIT.
INTRODUCTION 1
Thank you for purchasing the AMPLIFIER 60.0.
This amplier is a precision device designed in an eort to provide the
listener with unmatched soudn quality through superb design and
construction.
Although it’s operation is fairly simple, in order to operate your amplier
properly and realize all the capabilities of the 60.0 we recommend you
read this entire manual carefully.
INITIAL SETUP 2
WARNING: Please ensure that the power switch is turned OFF while you are connecting the
r. Connecting or disconnecting cables while the is powered on could
cause damage to your speakers.
The connectors are clearly marked on the back panel of the ampli er.
1. Audio input can be by balanced or unbalanced interconnects. Connect only one type
of input at a time, connecting balanced and unbalanced connectors can cause damage
or distortion.
between the positive and negative posts or post pairs.
3. The AC line input should be connected to an AC outlet with the power cable provided
4. The fuse and voltage selector unit houses a 5x20mm slow-blow fuse and a voltage
selector cartridge. Ensu
re that the voltage, visible through a small window next to the AC
input, is set to the appropriate voltage for your country. When changing voltages, ensure
that the power cable is disconnected fr r.
NOTE:
directly befor
2 2
NEG.OUTPUT
1
POS.OUTPUT
PUSH
USEONLY SPECIFIEDFUSE TYPE
6
8
120
3
4
5