COBY electronic MP-CD561 User Manual
Portable CD/MP3 Player
with Text Display
MP-CD561
Instruction Manual
1
EQ button
DBBS button
PROG button
ESP/SEARH
button
MODE button
A
R/PREVIOUS button
(push POWER button
LCD
to left)
Display
NAME OF PARTS
Door open switch
PLAY/PAUSE
button(push
POWER button
upward)
POWER ON/ENTER
button
F.F/NEXT button
(push POWER button
to right)
OFF/STOP button
(push POWER
button downward)
HOLD switch
DC jack
Headphone jack
Volume control
HOLD switch
(on rear)
INTRODUCTION
Please read and follow the instruction manual
carefully before operating in order to avoid any
damages to the unit. Any adjustment or repair
should be done by a qualified service center only
to receive warranty.
BATTERY OPERATION(BATTERIES NOT INCLUDED)
Your unit operates on two(2) AA size alkaline batteries.
Open the CD cover and insert the batteries in the battery
compartment following the polarity diagram located
inside.
RE-CHARGEABLE BATTERY OPERATION
(RE-CHARGEABLE BATTERIES NOT INCLUDED)
You can operate this unit with two “AA” rechargeable
batteries. For new or exhausted rechargeable batteries,
we recommend to refer to battery manufacturer’s
guide.
When operating the unit with AC adapter and
non-rechargeable batteries in the compartment,
please make sure to set the “Charge” switch
to “Off” position to avoid damaging the unit.
1. Open the CD cover and insert the batteries (2x”AA”) in
the battery compartment following the polarity diagram
located inside.
BOTH BATTERIES MUST BE RECHARGEABLE NiCd
TYPES. OTHER BATTERIES MAY EXPLODE OR LEAK.
2. Plug in AC adapter and slide the “CHARGE SWITCH“
to “ON” position to start charging.(AC Adapter Not Included)
3. Unplug the AC adapter after charging.
DO NOT CHARGE THE BATTERIES MORE THAN 24
HOURS OR MORE THAN RECOMMENDED TIME.
OVERCHARGING MAY DETERIORATE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES.
4. If the operating time decrease drastically after the
batteries have been recharged properly, purchase new
rechargeable NiCd batteries.
Do not attempt to recharge alkaline batteries. This may
cause leakage and damage to the unit.
Do not mix alkaline batteries with rechargeable batteries.
MONEY SAVING TIPS.
Due to the nature of CD technology, the unit uses power
even when the unit is off. To extend the batteries’ life, use
the adapter for indoor operation or where power is
supplied. Use the battery operation only when the unit is in
mobile.
DBBS FUNCTION
The Dynamic Bass Boost System(DBBS) enhances the
low frequency(Bass) response of the output. Set the
Volume to low listening level and press DBBS switch in
the direction of the arrow to turn this function ON.
Note: Some CD’s with DBBS may exceed the bass
response capacity and can cause distortion. Do not play
DBBS in high volume. Playing DBBS in high volume may
cause damage to the headphone and more importantly to
your hearing.
HOLD FUNCTION
This HOLD function prevents any unwanted function
changes during PLAY or STOP mode. Slide HOLD switch
to the arrow direction (or opposite) to turn the function
ON (OFF). No other function buttons operate on HOLD
mode, except DBBS function.
CAUTION
Hearing experts advise against the constant use of
personal stereos played at high volume. Constant high
volume use can lead to hearing loss. If you experience
ringing in the ears or hearing loss, discontinue use and
seek medical advice.
To remove the disc from its storage case, press down on
the center of the case and lift the disc out. Hold it carefully
by the edges as shown below.
Insert the disc into the unit with the label of the disc
facing up.
Gently wipe the disc using a soft cloth from the center
to the outer direction to remove dust, fingerprints or any
other particles on the disc surface. Never use
chemicals, such as record sprays, anti-static sprays,
benzene or thinners to clean the CD. These chemicals
can damage the disc surface permanently.
To avoid serious scratches on CD, keep them in the
cases after each use. Scratches can cause the laser
pick-up skip in the future play.
Do not place stickers or write anything on the disc.
Read the instruction manual before operating this unit.
Do not expose the unit to high temperature or humidity.
Use dampened soft cloth to clean the unit. Do not use
strong detergent or solvent to clean the unit.
Ensure that all electrical connections(including the main
plug, extension leads and interconnections between
pieces of equipment) are properly made and in
accordance with the manufacture’s instructions.
Consult your dealer if you are ever in doubt about the
installation, operation or safety of your equipment.
IMPORTANT
The CD mechanism and the sensitive circuitry may
cause interference to a radio tuner nearby. Do not
operate this unit while operating other radio devices.
Danger This product utilizes invisible laser
radiation. Avoid direct exposure
to the beam.
Caution Use of controls, adjustments or procedures
not listed in this manual may result in
hazardous radiation exposure.
CONCERNING COMPACT DISCS
Only compact discs identified with this
mark can be used with this player.
CD MODE
POWER ON AUTO PLAY
Press POWER ON/ENTER button to turn the power on.
(1)
LCD screen will display
"HELLO wellcome" .
Then will display
"wellcome to CD/MP3" .
(2)
LCD screen will display "NO DISC", if CD is not in the
unit.
(3)
LCD screen will display " NO CD/MP3 " if the unit
cannot read CD track data.
(4)
When CD track data has been read, Unit will start play from No.1
automatically. LCD SCREEN will display the play time.
EQ
During play, press EQ button alternately
can simulate various sound. including:flat/
classic/jazz/rock/pop.
STOP
(1)
Press OFF/STOP ( )button to stop
play , LCD screen will display the last track
number and total play time.
PAUSE
(1)
Press PLAY/PAUSE( ) button to pause on/off
alternately,and the time will flash.
LISTEN TO DESIRED TRACK
Press FR (or FF ) button to set the desired
(1)
track#, press PLAY/PAUSE button to play.
Press FR (or FF ) button to change the track#
during the play mode.
Press FF button
During play or pause mode, press
(2)
FR button twice to play previous
track.
During play or pause mode, press
(3)
FF button to play the next track
MOVE TO THE DESIRED SPOT
During play, press and hold FF (or FR ) button
continuously to fast forward (or fast reverse) the current
track.
REPEAT PLAY
(1)
Press MODE button once to repeat one track.
(2)
Press MODE button twice to repeat all tracks.
Press FR button
1
INTRO PLAY
(1)
Press MODE button three times at stop mode
and "INTRO" will flash.
(2)
Press PLAY/PAUSE( ) button to start INTRO
play from track No.1
TO CLEAR, Press OFF/STOP( ) button.
During play, press FR button to play previous track.
RANDOM PLAY
(1)
Press MODE button four times at STOP mode
and "RAND" is displayed and flash.
Press PLAY/PAUSE( ) button to play tracks in
(2)
random order.
Or
Select RANDOM mode during play and "RAND" will flash.
(1)
Press FF and FR button to play tracks in random order.
(2)
(3)
To cancel, press MODE or POWER OFF/CANCEL( ) button.
RAND
RAND
To clear, Press OFF/STOP( ) button.
(3)
SKIP
Press ESP button to prevent disruption
or stopping of CD player. LCD will display
"ASP" at anti-shock mode.
(1)" "is displayed when the battery voltage reaches low.
PROGRAM PLAY
TO PROGRAM
(1)
Press PROG button at stop or play mode and "PROG"
(a)
and "00" will display.
Press FF (or FR ) button to select the track number.
(b)
(c)
When desired track is displayed, press PROG. button to set.
Repeat (b)~(c) to set up to 64 tracks. The display will show the
(d)
INTRO
current set track.
Set tracks can be checked by pressing PROG. button.
(e)
TO COMPLETE THE PROGRAMMING AND TO PLAY
(2)
Press PLAY/PAUSE( ) button to start the
programmed tracks.
PROG
PROG
PROG
(2)When the voltage is too low, the unit will automatically turn off.
MP3 MODE
IMPORTANT MP3 CD making tips.
Make sure to use mp3 file extension only when burning CDs.
Do not mix audio files and mp3 files within a CD ROM.
POWER ON AUTO PLAY
Press POWER ON/ENTER ( )button to turn the power on.
(1)
LCD screen will display "NO DISC", if CD is not in the
(2)
unit.
When MP3/CD track data has been
(3)
read, LCD screen will display the total
track number and the playtime, Unit will
start play from track No.1 automatically.
song info will move from right to left.
EQ
During play, press this button alternately
can simulate various sound. including:flat/
classic/jazz/rock/pop.
STOP
Press OFF/STOP ( )button to stop play.
LCD screen will display the last
track number.
PAUSE
Press PLAY/PAUSE button to pause on/off
alternately,time will flash at pause mode.
LISTEN TO DESIRED TRACK
(1)
Press FF (or FR ) button to set the desired
track#, press PLAY/PAUSE ( )button to play.
Press FF or FR button to change the track# during
the play mode.
Press FF button
(2)
(3)
During pause mode, press FF (or FR ) button to
play the next track (or previous track). The unit will start
play desired track.
MOVE TO THE DESIRED SPOT
During play, press and hold FF (or FR ) button
(1)
continuously to fast forward (or fast reverse) the current
track.
FILE SEARCH ON MP3 MODE
Press ESP SEARCH key to enter selection mode.
(1)
Press the key once to enter file search mode.
Press FF( )or FR( ) button to select the
desired letter.
Press and hold FF( )or( )FR 1-2 second(s) to select the next
page or last page.
Press FF( )or FR( ) to select the desired letter.
Press POWER ON/ENTER( ) key to confirm the selection.
To delete a letter, press OFF/STOP once.
If the selection is correct, press MODE once, then press
PLAY/PAUSE( ) key to play the desired song.
(2) Press ESP SEARCH button twice to enter folder
search mode.
On folder search mode, press MODE button once to
check the directory.
Press and hold FF 1-2 second(s) to read the whole
directory. Press FF to check the directory down,press
FR button, to check the directory up.
When the desired directory shows, press POWER ON/
ENTER( ) to enter its
subdirectory.
Press and hold FF or FR 1-2 second(s) to search the
desired track,Press POWER ON/ENTER( ) to confirm and
play.
REPEAT PLAY
Press MODE button once to repeat one track.
(1)
(2)
Press MODE button twice to repeat album tracks.
(3)
Press MODE button three times to repeat all tracks.
INTRO PLAY
Press MODE button four times at stop mode and "INTRO"
(1)
will flash.
1
ALBUM
ALL
INTRO
Press PLAY/PAUSE( ) button to start INTRO play
(2)
from track No.1
(3)
Press FF button to start INTRO play from next tracks in
random order.
(4)
Press FR button to start INTRO play from current or
previous track.
RANDOM PLAY
Press MODE button five times at STOP mode and "RAND" is
(1)
displayed and flash.
Press PLAY/PAUSE( ) button to play tracks in
(2)
random order.
To cancel RANDOM mode, press MODE or OFF/STOP( )
(3)
button.
PROGRAM PLAY
TO PROGRAM
(1)
Press PROG button at stop mode and
(a)
"PROG" display and "00" will flash.
Press FF (or FR ) button to select the folder number.
(b)
When desired folder is displayed, press PROG. button to set.
(c)
Press FF (or FR ) button to select the track number.
(d)
When desired track is displayed, press PROG. button to set.
(e)
Repeat (b)~(e) to set up to 64 tracks. The display will show
(f)
the current set track.
Set tracks can be checked by pressing PROG. button.
(g)
TO COMPLETE THE PROGRAMMING AND TO PLAY
(2)
Press PLAY/PAUSE( ) button to start the
programmed tracks.
RAND
PROG
(3)
(1)" "is displayed when the battery voltage reaches low.
(2)When the voltage is too low, the unit will automatically turn off.
SPECIFICATION
MP3/CD Play Section
Frequency Response..............................20 ~ 20,000Hz
Wow and Flutter......................................Below Measurable Limits
Sampling Rate.........................................8 times over sampling
D/A Converter..........................................1-Bit
General
Maximum Output (Stereo Headphone)… 20mW+20mW(32ohm)
Power Supply
AC Adapter....................................…110V 60Hz
DC......................................................4.5V with DC Adapter
3V with 2 size “AA” Batteries
Dimension ................................5.1"x 1.1"x 5.5"(WHD)
Weight .................................0.66lbs (Main Unit Only)
Accessories Included ………..Professional Digital Neckband
Stereo Headphones
(Batteries not Included)
Loading...