COBY electronic CX-CD616 User Manual

SUPER SLIM PERSONAL CD PLAYER
with 15 SECOND ANTI-SKIP PROTECTION

CX-CD616

ALL1

INTRO

RANDOM

HOLD

PROG

ANTI-SHOCK

Anti-shock button

DBBS button

Stop button

REW button

To replace the insert color, gently press the three points under CD door.

LCD Display
PROG button

MODE button

Play/Pause button

FF button

DC jack
Headphone jack

Volume control

Hold switch

Open door lock

BATTERY OPERATION (BATTERIES NOT INCLUDED)

Your unit operates on two (2) AA size alkaline batteries. Open the
CD cover and insert the batteries in the battery compartment
following the polarity diagram located inside.

RE-CHARGEABLE BATTERY OPERATION
(BATTERIES NOT INCLUDED)

You can operate this unit with two "AA" rechargeable batteries.

For new or exhausted rechargeable batteries, we recommend
that batteries are recharged for 15 hours before use.(Refer to

battery manufacturer's guide)

When operating the unit with AC adapter and non-rechargeable
batteries in the compartment, please make sure to set the
"charge" switch to "off" position to avoid damaging the unit.

1.Open the CD cover and insert the batteries (2 X "AA" )in the

battery compartment following the polarity diagram located

inside

BOTH BATTERIES MUST BE RECHARGEABLE NiCd TYPES OR THE
BATTERIES MAY EXPLODE OR LEAK.

2.Plug in AC adapter and slide the "CHARGE SWITCH" to "ON"
position to start charging.

AC Adapter Not Included

3. Unplug the AC adapter after charging.

DO NOT CHARGE THE BATTERIES MORE THAN 24
HOURS OR MORE THAN RECOMMANED TIME.
OVER CHARGINGMAY DETERIORATE THE
PERFORMANCE OF THE RECHARGEABLE BATTERIES.

4.If the operating time decreases drastically after the batteries
have been recharged properly, purchase new rechargeable
NiCd batteries.

Do not attempt to recharge alkaline batteries . This may cause
leakage and damage to the unit.

Do not mix alkaline batteries with rechargeable batteries.
Do not leave the batteries on recharge for long periods of time.
This can damage the performance of the cells.

Due to the nature of CD technology, the unit uses power even
when the unit is off. To extend the batteries' life, use the adapter
for indoor opera-tion or where power is supplied. Use the battery
operation only when the unit is in mobile.

DBBS FUNCTION

The Dynamic Bass Boost System(DBBS) enhances the low
frequency(Bass) response of the output. Set the Volume to
low listening level and press DBBS switch in the direction of
the arrow to turn this function ON.

Note: Some CD's with DBBS may exceed the bass response

capacity and can cause distortion. To avoid this,
do not play DBBS in high volume. Playing DBBS in
high volume may cause damage to the headphone
andmore importantly, to your hearing.

HOLD FUNCTION

This HOLD function prevents any unwanted function changes
during PLAY or STOP mode. Slide HOLD switch to the arrow
direction (or opposite) to turn the function ON (OFF). No other
function buttons operate on HOLD mode, except DBB S funct ion
button.

CAUTION

Hearing experts advise against the constant use of personal
stereos play ed at h igh v olu me. C onstant high volume use
can l ead t o heari ng lo ss. If youex perience r ing ing in th e
ear s or he aring l oss , disconti nue use and se ekm edica l
adv ice .

.

To remove the disc from its storage case, press down on the
center of the case and lift the disc out. Hold it carefully by the
edges as shown below.

Insert the disc into the unit with the label of the disc facing UP.

Gently wipe the disc using a soft cloth from the center to the
outer direction to remove dust, fingerprints or any other
particles on thedisc surface. Never use chemicals, such as
record sprays , anti-staticsprays, benzene or thinners to
clean the CD. These chemicals candamage the disc surface
permanently.

To avoid serious scratches on CD, keep them in the cases
after each use. Scratches can cause the laser pick-up skip
in the future play.

Do not place stickers or write anything on the disc.

Read the instruction manual before operating this unit.

Do not expose the unit to high temperature or humidity.
Use dampened soft cloth to clean the unit. Do not use
strong detergent or solvent to clean the unit.

Ensure that all electrical connections (including the main plug,
extension leads and interconnections between pieces of
equipment)are properly made and in accordance with the
manufacture's instructions.

Consult y our d eal er if y ou ar e ever in doubt ab out t he in sta lla tion,
operati on or s afe ty of y our e quipment

General

Maximum Output (Stereo Headphone..15mW+15mW(32ohm)

AC Adapter......................................110V 60Hz

DC....................................................4.5V with DC Adapter

3V with 2 size "AA" Batteries

The CD mechanism and the sensitive circuitry may cause interference

to a radio tuner nearby. Do not operate this unit while operating other

radio devices.

Danger This product utilizes invisible laser

radiation. Avoid direct exposure to

the beam.

Caution Use of controls, adjustments or procedures not listed in

this manual may result in hazardous radiation exposure.

Only compact discs identified with this mark can
be used with this player.

(1)Press PLAY/PAUSE ( )button to turn
the power on.

(2)LCD screen will display " 15 SEC " .

(3)LCD screen will display " diSC " if CD is not
in the unit.

CO MPA CT

DI GITA L AU DIO

ANTI-SHOCK

ANTI-SHOCK

(4)LCD screen will display "Er" if the unit cannot
read CD track data.

(5)When CD track data has been read, LCD
screen will display the last track number
with the total play time.

(6)Unit will start play from track No.1
automatically.

Press STOP( )button to stop play,
and the last track Number will display.

Press PLAY/PAUSE( )button to pause
on/off alternately.
Time display will flash on pause mode.

ANTI-SHOCK

ANTI-SHOCK

ANTI-SHOCK

ANTI-SHOCK

ANTI-SHOCK

(1) Press FF (or REW )button to set the
desired track# . Press PLAY/PAUSE
button to play. Press FF (or REW )
button to change the track # during the
play mode.

(2) During play, press REW button to play
previous track.

(3) During pause mode, press FF (or REW )
button to play the next track (or previous track).
The unit will keep in pause mode and time
display will flash.

Press FF button

Press REW button at the head of NO.4

ANTI-SHOCK

ANTI-SHOCK

ANTI-SHOCK

ANTI-SHOCK

ANTI-SHOCK

During play, press and hold FF (or
REW ) button to fast forward (or
fast reverse) the current track.

(1) Press MODE button once to repeat
one track.

(2) Press MODE button twice to repeat
all tracks.

To listen to the first 10 seconds of each track.
(1) Press MODE button three times at STOP
mode and "INTRO" will display.

(2) Press PLAY/PAUSE ( ) button to starts
INTRO from track No.01.

Or

(1) Press MODE button three times during
play and "INTRO" will flash.

ANTI-SHOCK

1

ANTI-SHOCK

ALL

ANTI-SHOCK

INTRO

ANTI-SHOCK

INTRO

ANTI-SHOCK

(2) Press PLAY/PAUSE ( )button to start
INTRO play from track No.1.

(3) Press FF button to start INTRO play
from next track.

(4) Press REW button to start INTRO play
from current or previous track.

(1) Press MODE button four times at STOP
mode and "RANDOM" is displayed.

(2) Press PLAY/PAUSE ( ) button to play
tracks in random order.

Or

(1) Select RANDOM mode during play and
"RANDOM" will start flash.

(2) Press PLAY/PAUSE FF or REW
button to play tracks in random order.

(3) To cancel RANDOM mode, press MODE

INTRO

ANTI-SHOCK

INTRO

ANTI-SHOCK

INTRO

ANTI-SHOCK

INTRO

ANTI-SHOCK

RANDOM

ANTI-SHOCK

RANDOM

ANTI-SHOCK

RANDOM

ANTI-SHOCK

RANDOM

ANTI-SHOCK

(1) TO PROGRAM

(a)Press PROG. button and
"PROG" and " " will flash.

(b) Press FF (or REW ) button to select
the track number.

(c) When desired track is displayed, press
PROG. button to set.

(d) Repeat (b)~(c)to set up 20 tracks.
The display will show the current set track.

(e) Set tracks can be checked by pressing
PROG. button.

(2) TO COMPLETE THE PROGRAMMING AND TO PLAY

Press PLAY/PAUSE ( )button to start the
programmed tracks.

PROG

ANTI-SHOCK

PROG

ANTI-SHOCK

PROG

ANTI-SHOCK

(3) TO CLEAR THE PROGRAMMING

Press STOP( )button.

Press ANTI SHOCK button to prevent disruption
or stopping of CD player. LCD will display " "
at anti-shock mode.

(1) is displayed when the battery voltage
reaches low.

(2) When the voltage is too low, the unit will
automatically turn off.

ANTI-SHOCK

ANTI-SHOCK

ANTI-SHOCK

or STOP ( )button.