COBY electronic CX-CD331 User Manual

PORTABLE CD PLAYER

CX-CD331

Headphone jack

BATTERY OPERATION (BATTERIES NOT INCLUDED)

Your unit operates on two(2)AA size alkaline batteries. Open the CD cover and insert the batteries in the battery compartment following the polarity diagram located inside.

Hearing experts advise against the constant use of personal stereos played at high volume. Constant high volume use can lead to hearing loss. If you experience ringing in the ears or hearing loss, discontinue use and seek medical advice.

To remove the disc from its storage case, press down on the center of

the case and lift the disc out. Hold it carefully by the edges as shown

below.

Read the instruction manual before operating this unit.

Do not expose the unit to high temperature or humidity.

Use dampened soft cloth to clean the unit. Do not use strong

detergent or solvent to clean the unit.

Consult your dealer if you are ever in doubt about the

installation,

operation or safety of your equipment

General

Maximum Output (Stereo Headphone..15mW+15mW(32ohm)

Radio Frequecy

FM..................................................88-108MHz

DC.................................................. 3V with 2 size "AA" Batteries

5.1"x 1.1"x 5.9"(WHD)

Tuning Control

LCD Display

The CD mechanism and the sensitive circuitry may cause interference

to a radio tuner nearby. Do not operate this unit while operating other

radio devices.

Danger This product utilizes invisible laser

radiation. Avoid direct exposure to

the beam.

Caution Use of controls, adjustments or procedures not listed in

this manual may result in hazardous radiation exposure.

Only compact discs identified with this mark can be used with this player.

COMPACT

DIGITAL AUDIO

RADIO OPERATION

(1)Slide the FUNCTION switch to FM position to turn

the power on.

(2)Get to the desired station by tuning knob.

(3)Set a proper listening level by volume control.

(4)To turn off the radio, slide the FUNCTION switch to CD.

Open door lock

FF button

REW button

Stop button

Play/Pause button

(1)Press PLAY/PAUSE ( )button to turn the power on.

(2)LCD screen will display" ".

(3)LCD screen will display " no diSC" if CD is not

in the unit.

(4)LCD screen will display "Er" if the unit cannot

read CD track data.

(5)When CD track data has been read, LCD

screen will display the last track number

with the total play time.

(6)Unit will start playing from track No.1

automatically.

Volume control

Function Switch

CD OPERATION

Press STOP( )button to stop play,

and the last track Number will display.

Press PLAY/PAUSE( )button to pause

on/off alternately.

Time display will flash on pause mode.

(1) Press FF (or REW )button to set the

desired track# . Press PLAY/PAUSE

button to play. Press FF (or REW )

button to change the track # during the play

mode.

(2) During play, press REW button to play

previous track.

(3) During pause mode, press FF (or REW )

button to play the next track (or previous track).

The unit will keep in pause mode and time

display will flash.

Press FF button

Press REW button at the head of NO.4

Insert the disc into the unit with the label of the disc facing UP.

Gently wipe the disc using a soft cloth from the center to the outer

direction to remove dust, fingerprints or any other particles on the

disc surface. Never use chemicals, such as record sprays , anti-static

sprays, benzene or thinners to clean the CD. These chemicals can

damage the disc surface permanently.

To avoid serious scratches on CD, keep them in the cases after each

use. Scratches can cause the laser pick-up skip in the future play.

Do not place stickers or write anything on the disc.

During play, press and hold FF (or

REW ) button to fast forward (or

fast reverse) the current track.

POWER OFF

Press STOP button to get to the stop mode. The player will shut off automatically after a few seconds.

(1) is displayed when the battery voltage

reaches low.

(2) When the voltage is too low, the unit will

automatically turn off.