COBY electronic CX-39 User Manual

HOUR

MIN

TIME SET
LIGHT

ALARM SET ALARM

ON/OFF

POWER

FM/MW/SW1/SW2 4 BAND DIGITAL RADIO

AM

(

(

(

(

(

(

HOUR

MIN

TIME SET
LIGHT

ALARM SET ALARM

ON/OFF

POWER

FM/MW/SW1/SW2 4 BAND DIGITAL RADIO

AM

(

(

(

(

(

(

HOUR

MIN

TIME SET
LIGHT

ALARM SET ALARM

ON/OFF

POWER

FM/MW/SW1/SW2 4 BAND DIGITAL RADIO

AM

(

(

(

(

(

(

CX-39

Operating

Instruction

AM/FM/SW1/SW2 4 BAND RADIO WITH ALARM CLOCK

1

2

3

1. Telescopic Antenna

2. Handle Bar

3. AC socket

4. Battery Compartment

5. Power Indicator

6. LCD

7. Time Set/Light

8. Alarm Set

4

5

6

FM/MW/SW1/SW2 4 BAND DIGITAL RADIO

POWER

AM

(

(

(

(

(

(

TIME SET

ALARM SET ALARM

MIN

LIGHT

ON/OFF

SW1 SW2

FM MW

8

7

9

9. Alarm On/Off

10. MIN

11. HOUR

12. Band Switch

13. Tuning Dial

14. Volume Dial with
Power Switch

15. Earphone Jack

13

14

11

HOUR

10

15

12

POWER SOURCE ---------------------------------------

BATTERY OPERATION

1. Open the Battery Cover.

2. Insert 2 "D" size (UM-1 or equivalent) batteries
into the battery compartment,making sure that the
batteries are installed with the proper polarities
(+ and -).
AC Supply

1. Make sure the Voltage Selector is set to the
correct position. Connect the AC cord to the AC
socket and the wall socket. The set is now
ready to use.

2. To switch off the set completely, pull the AC cord
from the wall socket.
To prevent possible damage to this unit:
* Load new batteries with their polarities ( + and -)
aligned correctly.
* Do not apply heat to batteries, or internal short­circuit may occur.
* If this unit is not to be used for a long period of
time , remove all batteries and store them in a
cool and dry place.
* Remove dead batteries immediately and dispose
of them.
* Do not use old and new batteries together. Also
never use an alkaline battery with a manganese
Battery.
* Battery life
If the sound becomes low or distorted, replace all
of the batteries with new ones.

RADIO OPERATION ------------------------------------

1. Rotate the volume dial to turn the radio on and
adjust to the desired sound level.

2.Select the preferred frequency band
(FM/AM/SW1/SW2) by silding the band switch

3. Rotate the tuning dial to tune to the desired
station.The display shows the frequency.

4. Adjust the antenna (See ANTENNAS).

5. To switch off the radio,rotate the volume dial
until a click is heard.

CLOCK FUNCTION-------------------------------­TO SET THE TIME

AM

1. Press and hold the TIME SET button, and press
the HOUR button until the correct hour is shown.
* Ensure that the AM/PM is set properly.

2. While holding the TIME SET button, press the
MINUTE button until the correct minute is shown.

TO SET THE ALARM TIME

1. Press and hold the ALARM SET button, and a
" " Will appear on the display to identify the
alarm time. While holding the ALARM SET button,
press the HOUR button until the desired hour is
shown.
* Ensure that the AM/PM is set properly.

AM

2. While holding the ALARM SET button, press the
T

MINU E button until the desired minute is shown.

(

(

(

(

(

(

AM

3. After setting the alarm time, turn on the radio,

select the station, and turn the unit off.

4. Press the ALARM ON/OFF button, a " " will

appear on the display. The radio will turn itself on
at the alarm time.

(

(

(

(

(

(

ANTENNAS
FM:
Pull out the Telescopic Antenna and adjust its

Length and angle for optimum reception.
AM :
The sensitive ferrite core antenna inside the set

will provide excellent AM reception in most areas.
Turn the set in the direction which gives the best
results because the ferrite core antenna is
directional.

SW1-2:
Fully and vertically extend the telescopic antenna.

FM AM SW1-2

HELPFUL HINTS -----------------------------------

* If the set is not used for a long period of time,
Remove the batteries to prevent potential damage
due to possible battery leakage.
* Do not subject the set to temperatures over
60 C(140 F) because characteristics of the internal
parts may be adversely affected by heat. Never
leave the set in a car exposed to direct sunlight
for a long period of time with the doors and
windows closed . The cabinet may become
deformed and deterioration of the performance
may result.
* Since a strong magnet is used for the speaker,
keep magnetized commuter passes , tickets or
personal credit cards, recorded tapes, watches
etc. away from the radio. The speaker magent in
the radio may damage them.
* Do not place the set near strong magnets such
as those used in radio, television sets, speaker
boxes etc. as these may cause the frequency to
drift.
* Do not drop or subject the set to a strong impact
since the set is composed of precision parts.
* When listening in a train, car or building, use the
Radio near a window to obtain
reception.Reception may be difficult in a tunnel
or subway. Also note that operating the radio on
a metal object may adversely affect reception.
* Do not use benzene, thinners or any abrasive

powder to clean the cabinet. Wipe it with a soft cloth
moistened with a mild soap and water solution.
* Avoid spray-type insecticides. Some insecticides
contain chemicals that could cause cabinet
deformation.

-------------- SPECIFICATIONS ---------------------
Power Source: 2 "D" size/UM-1 batteries (DC 3V)
Frequency Range:

FM: 87.5-108.0 MHz

SW2: 12 - 18 MHz

Speaker: 8 3W
Power Output: 150mW (RMS. Max.)
Output Jack: Earphone 32

----------------------------------------------------------------------­* Design and Specifications are subject to change
without notice.
For recycling or disposal information about this
product, please contact your local authorities or the
Electronics lndustries Alliance: www.eiae.org

AM: 530 - 1710 KHz

SW1: 6.0 - 12 MHz