COBY electronic 907-DP74-0S01-00R, DP740 IB, DP740 User Manual

17 19

GETTING STARTED

COBY Electronics Corp.

56-65 Rust Street Maspeth, NY 11378

www.cobyusa.com www.ecoby.com

INSTRUCTION MANUAL

Please read this manual carefully before operation

DP740

WARNING:

To prevent ﬁre or shock hazard, do not expose this device to rain or moisture. Dangerous high voltage is present inside the enclosure. Do not open the cabinet.

CAUTION: To prevent electric shock, match wide blade of plug to wide slot of outlet and fully insert.

Protect your hearing: Hearing experts advise against the constant use of personal stereos played at high volume. Constant exposure to high volumes can lead to hear

ing loss. If you shoul

experience ringing in the ears or hearing loss, discontinue use and seek medical advice.

FCC Statement: this device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Note:

This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interfer

ence in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer

ence by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of

the FCC rules. Do not make any changes or modiﬁcation

s to the equipment unless otherwise speciﬁ ed in the manual. If such changes or modiﬁcations should be made, you could be required to stop operation of the equipment.

Please make sure that theitems shown below are included in the package. Should an item be missing, please contact the local retailer from which you purchased this product.

AC Adapter x 1

Manual x 1

Kickstand and Screw x 1

•

7″ Widescreen Digital Photo Frame

7" widescreen TFT LCD color display Displays JPEG, JPG photo files Photo slideshow mode Calendar and clock with alarm timer SD, MMC, MS, XD card slot Full-size USB port for use with flash memory drives Wall-mountable design with detachable stand

DP Frame x 1

180

7 8 9

DP740

1. -/+ Button Press to move the cursor left/right in menu setting and also can be used to turn pages in the full screen display.

2. Enter/Slidshow

Press for enter during menu selection. In photo (full-screen) display mode, press and hold this button to start / stop photo slideshow.

3. Change View

Press this button to shift between the view modes Crop to Fill, Full Screen and Fit to Screen in photo (full-screen) display mode. In Calendar Mode: press this button to change the calendar mode.

4. Menu

Press for exit. On the Main Menu Screen, press this button to move the cursor to the memory device list.

5. Down/Up button

Press to move the cursor down/up during menu selection. On the Main Menu Screen, select the desired memory device, and then press Enter button to confirm.

6. Card slot

Connect the SD/MMC/MS/XD card.

7. Power switch

To turn the photo frame on/off.

8. Full-size USB port

To connect with USB flash drives..

9. Mini-size USB port

To connect with computer.

10. Power Jack

Connect with the power source.

11. TFT Display.

Function Buttons

GETTING STARTED

Installing a Memory Card

Your picture frame supports the following types of memory cards:

Simply insert the memory card of your choice into its corresponding card slot located on the left panel of the photo frame. Takecare to orient the card in the proper direction.

Getting photos and ﬁles onto your picture frame for viewing couldn’t be easier!

Powering your Digital Picture Frame

Your PictureFrameshould be connectedto an AC 100-240V wall outlet.

Using the supplied power a

dapter, plug one end of the adapter into your photo frame’s Po

wer In jack and plug the other end into an AC 100-240V wall outlet.

Do not connect the power plug to a power outlet other than that which is indicated here or on the label as this may result in the risk of ﬁre or electric shock.

Do not handle the power plug with wet hands. Doing so may cause electric shock.

Use only AC adapters of the type speciﬁ ed here. Failure to do so may cause a ﬁre or damage the player.

•

XD-Picture (XD) Secure Digital (SD)

Multi Media Card

(MMC)

Memory Stick (MS)

USB Flash Storage Drive

DC OUT: 5V 1A

Turning Your Photo Frame On/Off

To turn your photo frame on, set the Power Switch to the “On” position. To turn your photo frame off, set the Power Switch to the “Off” position.

•

USB Port

(computer)

USB Port (mini)

Connecting to a Computer

Connect the photo frame to your computerwith USB cable. Upon

connection:

•

Your computer will automatically recognize installed in your photo frame. representing your installed memory cards will appear as “Removable Disk ” when you open “My Computer”.

Icons

a the memory cards

Make sure that there’s no USB flash drive connecting to the DP frame before connecting the DP frame to a computer.

Main Menu Screen

The demo slideshow will automatically start in approximately 8 seconds if you don’t press any button.

Photo

Select the Photo icon on the main menu screen and press Enter button to enter the Photo mode. If your photo frame is set to slideshow in photo setup, it will display the photo in slideshow

mode.You can press Menu button to enter thumbnail mode, and press Menu button again to exit. If your photo frame is set to thumbnail in photo setup, it will display in thumbnail mode. In this mode, to display a photo(full screen), use the direction button to select a thumbnail and press enter button to confirm.

The Photo List will display supported Photo ﬁles, only. Your photo frame can display baseline JPEG / JPG ﬁles.

CALENDAR

To view time and data, select Calendar on the main menu screen and press Enter button to confirm. Then the calendar will shown as below.

1. You can adjust the time and data in Calendar setup menu, please refer to Calendar setup in the Setup menu.

2. There are three display mods available, you can press Change View button to select the desired mode.

3. Press “-/+” button to view the previous/next month.

4. If there are available pictures, it will be displayed on the right of the window in slideshow mode, press Up/Down button to turn the pictures.

5. Press Menu button to exit.

SETUP

Photo Setup

Calendar

Display Mode

Display Ratio Slideshow Duration

Transition Effect Slideshow Repeat

Sets the photo display mode for entering the Photo Mode from the Main Menu.

Slideshow

Fit to Screen 5Sec.

Random On

Sets the photo display ratio. Sets the time interval of slideshow

photos. Sets the photo slideshow effect.

Sets the photo slideshow repeat function on/off

Calendar Setup

Display Mode

Sets the Calendar display mode

Sets the Clock Mode To set the Clock Time: Press the UP / DOWN

button to select the the time, and press the LEFT/RIGHT button to select the desired time.

To set an Alarm Time: Press the UP / DOWN button to select the Off/On and time and press the LEFT/RIGHT button to select the desired time and On. To delay the alarm timer, when the alarm timer sounds, press the ENTER button to turn it off completely, press any other buttons to delay it. The alarm timer will sound again 9 minutes, 18 mintues and 27 minutes later. The alarm will then turn off automatically.

24-Hour

Mon to Fri.

Repeat

Calendar+

Time+Slideshow

Set Date

Clock Mode Set Time

Alarm Time

Alarm Frequency

Alarm Set

Snooze

Sets the Alarm Frequency

Sets the Alarm

Sets Snooze Mode

To set Date: Press the UP / DOWN button to select the number of the date and year, and press the LEFT/RIGHT button to adjust.

System Setup

Resets all settings to their factory default state.

Sets the menu language of the photo frame. Sets the brightness of the screen. Sets the Contrast of the screen. Sets the Saturation of the screen.

Sets the Hue of the screen. Sets the power on

Sets the power off

Sets the auto boot/shut time for the photo frame.

1. Make sure the Power switch on the DP frame is set to ON.

2. Press the UP/DOWN button to select On / Off and time.

3. Press the LEFT/RIGHT button to select the desired time..

Sets the Auto-Power On / Off Frequency.

SETUP

language Brightness

Conrast Saturation Hue Power On

Reset

Power Off Auto boot time

Auto Shut time Auto-power

frequency

7 50

Off Off

Mon. to Fri.

Changing View

Press the CHANGE VIEW button to change between the screen ratio modes Full Screen, Fit to Screen and Crop to Fill. To view the previous/next photo, press Down/Up button.

Zoom

To zoom in the pictures, press “+” button.

Each successive press of “+” button will change the level of magniﬁcation as

shown below:

125% 150% 175% 200% 225%

250%

ZOOM OFF

KICKSTAND

Turn the screw to the right to tighten the kickstand.

Attach the kickstand to the DP frame.

Using the Kickstand

The player does not turn on.

Make sure the unit has been powered on manually (i.e., the Power Switch has been physically set to the ON position).

Ensure that the power cord has been properly connected to the power outlet.

•

If you have a problem with this device, please read the troubleshooting guide below and check our website at www.cobyusa.com for Frequently Asked Questions (FAQs) and firmware updates. If these resources do not resolve the problem, please contact Technical Support.

ADDRESS

COBY Electronics Technical Support 150 Knowlton Way Savannah, GA 31407

techsupport@cobyusa.com

WEB

www.cobyusa.com

PHONE

800-727-3592: Weekdays 8:30AM–9:00PM EST Saturdays 9:00AM–5:30PM EST 718-416-3197: Weekdays 8:00AM–5:30PM EST

I cannot select a memory card.

Ensure that a memory card has been installed. Ensure that the memory card is properly installed. Ensure that the memory card is not defective.

•

The alarm does not work.

Make sure the Alarm Setting is set properly in Calendar Setup in Setup Menu.

TROUBLESHOOTING

UNIT VIEW

Note: You can only press the “-” button to zoom out the amplified pictures, but can’t zoom out the original pictures.

PACKAGE CONTENTS......................................................................................................................

............................9

UNIT VIEW....................................................................................................................................................................11

Function Buttons.....................................................................................................................................................11

KICKSTAND..................................................................................................................................................................18

Using the Kickstand................................................................................................................................................18

GETTING STARTED.....................................................................................................................................................12

Installing a Memory Card.........................................................................................................................................12

Powering your Digital Picture Frame........................................................................................................................12

Turning Your Photo Frame ON/OFF..................................................................................................................... ..13

Connecting to a computer........................................................................................................................................13

Photo...........................................................................................................................................................................14

Change View............................................................................................................................................................14

Zoom........................................................................................................................................................................14

CALENDAR...................................................................................................................................................................15

PRECAUTIONS..............................................................................................................................................................2

IMPORTANT SAFETY INSTRUCTION.........................................................................................................................

SETUP ..........................................................................................................................................................................16

Photo Setup.................................................................................................................................................................................................................................16

Calendar Setup...........................................................................................................................................................................................................................16

System Setup...............................................................................................................................................................................................................................17

TROUBLE SHOOTING...................................................................................................................................................19

SPECIFICATION..........................................................................................................................................................20

TABLE OF CONTENTS..................................................................................................................................................8

FEATURES...................................................................................................................................................................10

P/N: 907-DP74-0S01-00R

Speciﬁcations and manual are subject to change without prior notice.

Display Type 7″ Full-Color TFT LCD

Display Resolution 800×480

Memory MS Card SD/MMC/XD Card Full-size USB

Photo Format JPEG

USB Host USB 2.0 High-Speed

Power Supply DC 5V, 1A, 100-240V AC Adapter

JPG

SPECIFICATION

Inserted: A card icon that is in-color indicates that a memory card has been inserted(installed) in the corresponding slot. No card: A card icon that is grayed-out indicates that a memory card has not been installed in the corresponding slot and is not available for use. Selected: A higlighted frame indicates that the card slot is selected. Only card slots with an installed memory card may be selected.

Upon turning on the power, your photo frame will display the “Main menu” screen shown below: Press the MENU button and then press the UP/DOWN button to select an available card.

To the amplified picture(only), press Up/Down button to move it up/down; press and hold “-/+” button to move it left/right.

English