Coby TF-TV3717, TF-TV4217, TF-TV2617, TF-TV3217 Instruction Manual
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk
of electric shock, do not perform any servicing other than that contained in the operating
instructions unless you are qualified to do so. Refer to manual for servicing instructions.
POWER SUPPLY:
Connect one end of the supplied power cable to the AC jack on the back of the unit and other
end to an AC100-240V wall outlet. If you have difficulty inserting the plug, turn it over and
reinsert it, if the unit will not be used for a long time, disconnect the plug from the outlet.
POWER MANAGEMENT:
1. If the player will not be used for a period of time, please disconnect the power.
2. Before plugging the power cord into an AC outlet, make sure that all the connections have been
made.
•
rtant aet nstrutin
•
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended
to alert the user to the presence of uninsulated “dangerous voltage” within the
product’s enclosure that may be of sufficient magnitude to constitute a risk of
electric to persons.
The exclamation point within an equilateral triangle is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
Precautions
For Customer Use:
Enter below the serial number that is located on the
rear of the unit. Retain this information for future reference.
Model No.
TF-TV2617/3217/3717/4217
Serial No.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Note:
This equipment has been tested and found to comply with the limits for Class B digital devices,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC
rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual.
If such changes or modifications should be made, you could be required to stop operation of the
equipment.
NOTE:
The LCD panel used in this television contains millions of thin film transistors that have been
manufactured using a high-technology process to deliver a crisp, clear, and detailed picture.
Occasionally, a few of these transistors may become stuck or non-active; please note that this does
not affect the performance of the television.
Copyright Protection
Unauthorized copying, broadcasting, public performance, and lending of disks are prohibited. This
product incorporates copyright protection technology that is protected by method claims of certain U.S.
patents and other intellectual property rights owned by Macrovision Corporation and other rights
owners. Use of this copyright protection technology must be authorized by Macrovision Corporation,
and is intended for home and other limited viewing uses only unless otherwise authorized by
Macrovision Corporation. Reverse engineering or disassembly is prohibited.
•
rtant aet nstrutin
•
Precautions
•
rtant aet nstrutin
Important Safety Instructions
Read Instructions: All the safety and operating instructions should be read before the product
is operated.
Retain Instructions: The safety and operating instructions should be retained for future reference.
Heed Warnings: All warnings on t he product and in the oper ating instructions s hould be
adhered to.
Follow Instructions: All operating and usage instructions should be followed.
Cleaning: Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners
or aerosol cleaners. Use a damp cloth for cleaning.
Attachments: Use only attachments recommended by the manufacturer. Use of other attach-
ments may be hazardous.
Water and Moisture: Do not use this produc t near water (e.g., near a bath tub, washbowl,
kitchen sink, laundry tub, in wet basements, or near a swimming pool and the like).
Accessories: Do not place this product on an unstable cart, stand, tri-
pod, bracket, or table. Use only with carts, stands, tripods, brack ets,
or tables recommended by the manufacturer or sold with the product. Any mounting of the product should follow the manufacturer’s
instructions and should use a mounting accessory recommended
by the manufacturer.
A product and cart c ombination should be moved with care.
Quick stops, excessive force, and uneven surfaces may cause the
product and cart combination to overturn.
Ventilation: Slots and openings in the c abinet are pr ovided fo r ven tilation to ensure reliable operat ion of the p roduc t and to pr otect it f rom over heat ing. The se
openings should never be blocked by placing the product on a bed, sofa, rug, or other similar
surface. This product should not be placed in a built-in installation such as a bookcase or rack
unless proper ventilation is provided or the manufacturer instructions have been adhered to.
Power Sources: This product shoul d be operated only f rom the ty pe of power sourc e indi cated on the rating label. If you are not sure of the type of power supply to your home, consult
your product dealer or local power company. For products intended to operate from battery
power or other sources, refer to the operating instructions.
Grounding or Polarization: This product may be equipped with a polarized alternating-current
line plug that has one blade wider than the other. This plug will only fit into the power outlet in
one direction. This is a safety feature. If you are unable to insert the plug fully into the outlet,
try reversing the direction of the plug. If the plug should still fail to fit, contact an electrician to
replace the obsolete outlet. Do not defeat the safety purpose of the polarized plug.
Power-Cord Protection: Power supply co rds shoul d be routed s o that they are not likely to
be walked on or pinched by items placed upon or against them, paying particular attention to
cords at plugs, convenience receptacles, and at the point which they exit from the product.
Protective Attachment Plug: The product may be equipped with an attachment plug with
overload protection. This is a sa fet y featur e. See t he op erat ing in str uc ti ons fo r repl ace ment
or directions to reset the protective device. If replacement of the plug is required, be sure the
service technician has used a replacement plug that has the same overload protection as the
original plug as specified by the manufacturer.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
•
rtant aet nstrutin
Important Safety Instructions
Outdoor Antenna Grounding: If an outside antenna is c onnec te d to the p ro duc t, be sure t he
antenna system is grounded so as to prov ide some prote ction again st voltage sur ges and
built-up static charges. Article 810 of the National Electrical Code, ANS/NFPA 70 provides
information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna - discha rge unit, s ize of ground ing co nducto rs, loc atio n
of antenna-discharge unit, connection to grounding electrodes, and requirements for the
grounding electrode (see figure).
Lightning: For added protection for this product, unplug it from the wall outlet and disconnect
the antenna or cable system during a lightning storm or when it is left unattended and unused
for long periods of time. This will prevent damage to the product due to lightning or power-line
surges.
Power Lines: An outside antenna system should not be located in the vicinity of overhead
power lines or other electr ic li ght or p owe r ci rc uit s, or w her e it c a n fal l into suc h p ower li ne s
or circuits. When installing an outside antenna system, extreme care should be taken to keep
from touching such power lines or circuits, as contact with them might be fatal.
Overloading: Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.
Object and Liquid Entry: Never push objects of any kind into this product through openings
as they may touch dangerous volt age po ints or sh out- out pa r ts that c ould r esult in a fire or
electric shock. Never spill liquid of any kind on the product.
Servicing: Do not attempt to service this product yourself as opening or removing covers may
expose you to dangerous voltag e or other haza rds. Refer all ser vicing to qu alified servic e
personnel.
Damage Requiring Service: Unplug this product from the wall outlet and refer ser vicing to
qualified service personnel under the following conditions: a) when the power-supply or plug
is damaged; b) if liquid has been spilled or if objects have fallen into the product; c) if the
product has been exposed to rain or water; d) if the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating
instructions as improper adju stment of other cont rols may result in damage and w ill often
require extensive work by a qualified technician to restore the prod uct to its normal operation ;
e) if the product has been dropped or damaged in any way; f) when the product exhibits a
distinct change in performance—this indicates a need for service.
15.
16.
17.
18.
19.
20.
21.
nain
Please make sure the following items are included with your LCD TV/monitor. if any items are missing,
contact your dealer.
1
••
FAV+
FAV-
023
Package Contents
LCD Television
•
rtant aet nstrutin
Important Safety Instructions
Replacement Parts: When replacement parts are required, be sure that your service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or
other hazards.
Safety Check: Upon completion of any service or repairs to this produ ct, ask the service technician to perform safety checks to ensure that the product is in proper operating condition.
Wall or Ceiling Mounting: The product should be mounted to a wall or ceiling only as recommended by the manufacturer.
Heat: The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.
22.
23.
24.
25.
nit ie
3
Unit View
1. MODE/ENTER
Press to shift modes. While working with the
menu, press to confirm settings.
2. MENU
Press to display the system menu.
3. CH+
Press to skip channels forward.
It also works as the up direction button while
working with the menu.
4. CH Press to skip channels backward.
It also works as the down direction button
while working with the menu.
5. VOL+
Press to increase the volume.
It also works as the right direction button
while working with the menu.
6. VOL Press to decrease the volume.
It also works as the left direction button
while working with the menu.
7. POWER
Press to turn the power on/off.
8. Remote Sensor
Sense the remote signal.
9. Power On Indicator
Lights green during normal usage.
Lights red during standby.
10. Screen
Present the high resolution picture.
11. Speaker
Output sound.
<
8
1
2
3
4
5
6
7
9
11
10
Front Panel
nit ie
4
Unit View
>
VIDEO-OUT AUD IO-R AUDIO-L
HDMI-2 HDMI-1 YPbPr
VIDEO-1 AUDIO-R AUDIO-L S-VIDEO OPTICAL
1234567101112
8
9
1. Power Jack
Connect with the power supply.
2. HDMI2
Input the audio/video signal.
3. HDMI1
Input the audio/video signal.
4. PC Audio In
Input the PC audio signal.
5. VGA
Connect with the VGA port on the computer.
6. Component Input
YCb/Pb Cr/Pr - - Input the video signal.
AUDIO-L, AUDIO-R - - Input the audio signal.
7. AV1 Input
VIDEO-1 - - Input the video signal.
AUDIO-L, AUDIO-R - - Input the audio signal.
8. AV2 Video Input
VIDEO-2 - - Input the video signal.
9. AV Output
VIDEO-OUT - - output the video signal.
AUDIO-L, AUDIO-R - - Output the audio
signal.
10. S-VIDEO
Input the S-Video signal.
11. OPTICAL
Output the audio signal.
12. Antennal Jack
Connect with the TV RF signal source.
Rear Panel
Loading...