Coby TF DVD 3299 User Manual

TFT LCD Widescreen Television
Instruction Manual
TF DVD 3299
Please read this manual carefully before connection and use
Precautions
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of sufcient magnitude to constitute
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operation and servicing instructions in the literature accompanying the appliance.
For recycling or disposal information about this product, please contact your local authorities or the Electronics Industries Alliance:www.eiae.org.
For Customer Use:
Enter below the serial number that i s located on t he rear of the unit. Retain this information for future ref­erence.
Model No.
Serial No.
TFDVD 3299
Precautions
WARNING: To prevent re or shock hazard, do not expose this device to rain or moisture. Dangerous high
voltage is present inside the enclosure. Do not open the cabinet.
Note: If the product suddenly has no response or powers off, an electrostatic discharge may be the cause. In this circumstance, please follow the procedures below for recovery:
• Unplug the unit. Wait 30 seconds.
• After 30 seconds, plug the unit in and turn it on again.
FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired
operation.
Note:
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules. Do not make any changes or modications to the equipment unless otherwise specied in the manual. If such changes or modications should be made, you could be required to stop operation of the equipment.
Important Safety Instructions
Warnings and precautions
To prevent any injuries, the following safety precautions should be observed in the installation, use, servicing and maintenance of this equipment. Before operating this equipment, please read this manual completely,
and keep it nearby for future reference.
Important Safety Instructions
1. Read these instructions:All the safety and operating instructions should be read before the product is operated.
2. Keep these instructions: The safety and operating instructions should be retained for future reference.
3. Heed all warnings: All warnings on the product and in the operating instructions should be adhered to.
4. Follow all instructions: All operating and usage instructions should be followed.
5. Do not use this apparatus near water: (e.g., near a bath tub, washbowl, kitchen sink, laundry tub, in wet
basements, or near a swimming pool and the like).
6. Clean only with a soft dry cloth. Never use liquid or aerosol cleaners on the equipment.Always remove the power cord from the outlet before cleaning the equipment.
7. Do not block any ventilation openings.Install in accordance with the manufacturer’s instructions:Do not insert anything into the ventilation holes of your equipment.Inserting any metal or flammable objects
may result to re or electric shock.Do not install this equipment in a conned or building-in space such as a book case or similar unit,and remain a well ventilation openings with items such as newspaper,table –cloths,curtains etc
8. Do not install near any heat sources such as radiators,heat registers,stoves,or other apparatus (including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided you’re your safety .If the provided plug does not t you’re your outlet,consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs , convenience receptacles,
and the point where they exit from the apparatus.
11. Only use attachments/accessories specied by the manufacturer.
12. Use only with the cart,stand,tripod,bracket,or table specified by the manufacturer, or sold with the
apparatus .When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13. Do not place the equipment on uneven or unstable carts,stands,tables,shelves etc,The equipment may fall,causing serious injury to children or adults and serious damage to the equipment itself. Always place the equipment on the oor or on a surface that is sturdy,level,stable and strong enough to support the
weight of the equipment.
14. Unplug this apparatus during lightning storms or when unused for long periods of time.
15. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus,the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
16. If you can not t the plug into the electrical outlet, contact an electrician to install a grounding outlet.
17. Always operate this equipment from the type of power source indicated on the rear of the serial/model plate.
18. Never overload wall outlets and extensions.
19. Use and handle the power cord with care. Do not place any heavy objects on the AC power cord.
20. Do not pull the AC power cord. Do not handle the AC power cord with a wet hand.
21. Remove the plug from the wall outlet, if the equipment will not be used for a long period of time.
22. Do not expose the equipment to extreme temperature or to direct sunlight, as the equipment may heat up and suffer damage.
23. Do not attempt to service the equipment yourself.
Important Safety Instructions
24. Opening and removing the covers may expose you to dangerous voltage or other hazards and may void
your warranty. Refer service to qualied personnel.
25. Do not place or drop any other objects on top.
26. Protect the power cord from being walked on or pinched particularly at plugs ,convenience receptacles, and the point where they exit
27. WARNING: The mains plug or an appliance coupler is used as the disconnected device, the disconnected device shall remain readily operable.
28. WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain or moisture.
The apparatus shall not be exposed to dripping or splashing and that no objects lled with liquids, such as vases, shall be placed on apparatus.
29. Protective earthing terminal. The apparatus should be connected to a mains socket outlet with a protective earthing connection.
30. Battery shall not be exposed to excessive heat such as the sunshine, re or the like. Danger of explosion
if battery is incorrectly replaced. Replace only with the same or equivalent type.
Important Safety Instructions
Antenna Safety Instructions
If an outdoor antenna is connected, follow the precautions below:
An outdoor antenna should not be located in any area where it could come in contact with overhead power lines, or any other electric light or power circuits.
When installing an outdoor antenna system, extreme caution should be taken to prevent contact with
power lines. Direct contact with power lines may be fatal and should be avoided at all costs.
Section 810 of National Electrical Code (NEC) provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the
grounding electrode.
Listening with Earphones
Listen at moderate Volumes to avoid hearing damage.
If you hear no sound during playback, do not turn the Volume up as the music may suddenly begin at a high Volume. Excessive sound pressure from earphones and headphones can cause hearing loss.
To avoid damaging your ears, adjust the Volume to the lowest level before playback, and turn up to the
desired level when playback has started.
Legal and Trademark Notices
Coby is a registered trademark of Coby Electronics Corporation. All other trademarks and logos are property
of their respective owners unless indicated otherwise.
Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories. Condential unpublished works. © 1992 -1997 Dolby Laboratories, Inc. All rights
reserved.
This TV incorporates High-Denition Multimedia Interface (HDMITM) technology. HDMI, the HDMI logo and High-Denition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.
Note: This product contains electrical or electronic materials.The presence of these materials may, if not disposed of properly, have potential adverse effects on the environment and human health. Presence of this
label on the product means it should not be disposed of as unsorted waste and must be collected separately.
As a consumer, you are responsible for ensuring that this product is disposed of properly.
Table of Contents
Table Of Contents
Precautions
Important Safety Instructions
Main Feature-----------------------------------------------------------------------------------------------------------------------------1
Package Contents-----------------------------------------------------------------------------------------------------------------2
Unit View---------------------------------------------------------------------------------------------------------------------3
Wall Mounting----------------------------------------------------------------------------------------------------------------3
Remote Control ------------------------------------------------------------------------------------------------------------------4
Cable Connections----------------------------------------------------------------------------------------------------------------7
TV Function----------------------------------------------------------------------------------------------------------------12
AV Function-----------------------------------------------------------------------------------------------------------------------------16
PC Function----------------------------------------------------------------------------------------------------------------------------17
DVD Operation------------------------------------------------------------------------------------------------------------------------18
Playback Function--------------------------------------------------------------------------------------------------------------------20
DVD Setup----------------------------------------------------------------------------------------------------------------------------22
Troubleshooting -----------------------------------------------------------------------------------------------------------------------24
Specifications ----------------------------------------------------------------------------------------------------------------------25
Multiple Mode
TV
AV COMPONENT
DVD
VGA
HDMI 1 HDMI 2 HDMI 3
High Quality Property
Main Features
High Resolution
Adopt an MPEG2 decoding format to achieve horizontal resolution more than 500 lines.
Superior sound
Built-in Dolby Digital decoder to output high quality sound effects.
Screen
Support the picture size of a normal screen (4:3) and a wide screen (16:9)
Panel Information
The panel used in this television contains millions of thin lm transistors that have been manufactured using a high-technology process to deliver a crisp, clear, and detailed picture. Occasionally, a few of these transistors may become stuck or non-active; please note that this does not affect the performance of the television.
NOTE: It is normal to experience some light or dark spots appearing on the screen.
Power Supply:
Insert the power plug into the
the plug, turn it over and re-insert it.
AC100-240V wall outlet. If you have difculty inserting
Power Management:
• Before plugging the power cord into the AC outlet, make sure that all necessary
connections have been properly made.
• If the unit will not be used for a long period of time, disconnect the power and
remove the batteries from the remote.
1
Package Contents
Please make sure the following items are included with your product. If any item is missing, contact your
dealer.
a.
b. c.
a, Main Unit
b, RCA Cable
c, Remote Control Unit
2
Unit View
Unit Stand
Remote Control Senser
Sense the remote control signal.
Power Indicator
Lights bright blue when TV is on, it will dim when TV is turned off (Standby mode).
Unit View
Open/close a disc room. Start/hold a disc playback. Stop a disc playback. Connects to USB
Connects to SD Card
Disc Entry
TFT Screen
Adjust the audio level.
Skip channels. Display the system menu.
Select a desired mode. Turn the unit on/off.
NOTE: The unit enters into the standby mode after being turned off with the POWER button, and it still consumes power in the standby mode. Unplug the power cord from the outlet completely when it will not be used for a long period of time.
Mounting Thread x 4.
“SERVICE ONLY” is for the engineering use merely and not supposed to be utilized by a finial user. For more specific details on connector pannels, please read the Cable Connection section
Screw X3 These screws are connecting the TV
case to the unit stand.
Wall Mounting - Attach the TV case to the wall
This unit can be deliveried to a final user either as a wholly assembled product or with the TV case
detached from the unit base, depending on different packing methords. If you got the unit as a fully assembled product, you would have to remove the unit stand rst before wall mounting, To detach the unit base, release the xing screws.
Use the VESA standard mountings to fix the TV case on the wall. Take care when mounting, it may cause damage or serious injury should it fall from its mountings. See the Specication page for VESA informaiton. A variety of mounts are available in your local retailer, see instructions when installing the unit. An adequate space is necessary for this installation. Screws used for mounting purposes shall not exceed 10mm in length.
3
Loading...
+ 22 hidden pages