DP860/DP862
WARNING:
To prevent fire or shock hazard, do not expose this device to rain or moisture. Dangerous high
voltage is present inside the enclosure. Do not open the cabinet.
CAUTION: To prevent electric shock, match wide blade of plug to wide slot of outlet and fully
insert.
Protect your hearing: Hearing exper ts advise against the constant use of personal stereos
played at high volume. Constant exposure to high volumes can lead to hear
ing loss. If you should
experience ringing in the ears or hearing loss, discontinue use and seek medical advice.
FCC State ment:
this devic e complies with Par t 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for Class B digital
devices, pursuant to Par t 15 of the FCC rules. These limits are designed to provide
reasonable protection again
st harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in ac cordance with the instructions, may cause harmful inter ference to radio
communications. However, there is no guarantee that inter ference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
enc
ouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Use of shielded cable is required to comply with Class B limits in Subpar t B of Part 15 of
the FCC rules.
Do not make any changes or modifi
cations to the equipment unless other wise specified
in the manual. If such changes or modifi cations should be made, you could be required
to stop operation of the equipment.