Coby CMB-102, CHBT-617 User Manual

User Manual
Manual De Usuario
Manuel de l'utilisateur

Please read carefully before use
Por favor, lea cuidadosamente antes de su uso
Se il vous plaît lire attentivement avant utilisation

CMB-102

Read Me

Important Safety Instructions

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near water.

6) Clean only with dry cloth.

7) Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.

8) Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.

9) Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.

10) Only use attachments/accessories specified by the manufacturer.

11) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.

12) Unplug this apparatus during lightning storms or when unused for long periods of time.

13) Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.

FCC NOTICE TO USERS:
FCC ID: 2AMSOCMB-102
Caution: Changes or modifications not expressly approved by the Party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection Against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications, however there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

- Consult the dealer or an experienced radio/TV technician for Help.
The device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by Summit CE Group LLC is under license.

Welcome! Thank you for purchasing a COBY® Product.
Remove product from packaging. Read instructions carefully before using the product and retain them
for future reference

What’s Included

Bluetooth Speaker
USB Charging Cable

3.5mm Audio Connection Cable
Instruction Manual

Instructions for Use

LED Indicator Guide

Off: Power off
Flashing Blue- Power on, Pairing Mode
Steady Blue: Paired Successfully
Red: Battery charging

Charging the CMB-10

2

Make sure to fully charge the CMB-102 before use
Connect the included USB charge cable to the port on the back of the speaker and insert the other end
into a PC’s USB port or an AC USB charger.
The red indicator light will light up, showing the battery is charging, and will turn off when the CMB-102
is fully charged

Placing the CMB-104 in Bluetooth® Pairing Mode
Press and Hold the

button to power on the CMB-102

CMB-102

device.

Pairing to a Bluetooth Device

Power on the CMB-102 on to place it in Pairing Mode
Set your phone, tablet or other device to search for Bluetooth® devices (i.e., the speaker).
When the CMB-102 is found , select it from the list. If asked to enter a pairing code, enter “0000” or
“1234”

Controlling Music Playback when Connected via Bluetooth:

Once your Bluetooth audio source is successfully paired to the CBM-102, music played will be
heard through your speaker

TO: DO THIS

Answer or end a call

Click the

Play or pause a song or video

Click the

Go to the previous track Press and hold the <<- button.
Skip to the next track Press the >>+ button.
Increase volume Press and hold the >>+ button.
Decrease volume Press and hold the <<- button.

Change Mode

Click the

button twice

US