Cobra Electronics FRS120C User Manual
FRS_120 12/29/00 2:19 PM Page 1
How to Use Your Cobra
M i c ro Ta l k 2 - Way Radio
Contents
Features..........................................................................1
Family Radio Service................................................A1
FCCWarnings
Included Accessories
Controls & Indicators................................................A2
Our Thanks toYou......................................................A3
Customer Support ...................................................A3
Operating your microTALK
Battery Installation...................................................2
Turning On..................................................................3
Illuminating the Display ........................................3
Auto Squelch.............................................................4
Maximum Range Extender/Auto Monitor......4
Select Channel..........................................................5
Calling Another Party .............................................6
Talking To Another Party.......................................7
Roger Beep Confirmation Tone...........................8
Listening For Another Party.................................8
microTALK Range.....................................................9
Making Life Easier And Safer...............................10
microTALKSNAP Removable Front....................11
External Microphone/Speaker Jack...................12
Caring for Your microTALK....................................14
Frequency Ranges .....................................................16
microTALK Specifications.......................................16
Limited TwoYear Warranty....................................18
Optional Accessories................................................19
Order Form....................................................................20
If You Think You Need Service.............Back Cover
Features of This Product
• Two-way radio with
up to a 2 mile range
• 14 channels
• Backlit LCD
• Roger beep confirmation
tone
• Call feature
• SuperFlex™ antenna
• Speaker/Microphone
jacks
• Belt clip
• Wrist strap
1
FRS_120 12/29/00 2:19 PM Page 2
Operation
Battery
Installation
Note
Batteries are not included
with microTALK 2-way
radio.Always use 3 high
q u a l i ty AA alkaline batte ri e s
or optional batte ry pack
(sold separa te ly ) .
Note
When batteries are low the
i n d i ca tor willb l i n k .
Note
Visit Cobra Electronics
( w w w. co b ra e l e ct ro n i c s. co m )
for information abo u t
optional batte ry pack and
d e s k top charger acce s s o ri e s.
Install Batteries
1 2
Pull lock tab down
to remove battery
cover.
Insert three “AA”
batteries.Position
batteries according
to po l a ri ty marki n g s.
Turning On Your microTALK
1
Turnthe On/Off/Volume switch.An audible
“tone”will indicate the unit is on.
Illuminating the Display
Operation
Turning
On Your
microTALK
Note
Whenever the unit is on
you can receive communications.
Illuminating
the Display
1
Push and release LIGHT/MAX RANGE
button to illuminate display for ten seconds.
2
3
FRS_120 12/29/00 2:19 PM Page 4
Operation
Auto Squelch
Maximum
Range
Extender
Note
To learn more about the
range of your microTALK,
see page 9.
Range is dependent on
battery condition and
geographic terrain.
Auto Squelch
Your microTALK is equipped with Auto Squelch,
which automatically shuts off weak transmissions
and unwanted noise due to terrain conditions or
if you have reached your range limit.
Maximum Range Extender
Auto Squelch can be temporarily removed to allow
all signals to enter (Maximum Range Extender).
1
Push and hold LIGHT/MAX RANGE
button to allow all signals to enter.
Select Channel
1
Turn on the microTALK 2-Way Radio.
2
Select any of the 14 channels by pushing the
channel up or down buttons.
Operation
Select
Channel
Note
Units must be tuned to the
same channel number in
order to communicate.
Auto Monitor
Auto Monitor
When the signal you want to hear is consistently
weak,you may place the radio in Maximum
Range mode without having to constantly hold
the button:Press and hold the Maximum Range
Extender button for five seconds.Two beeps
confirm Auto Monitor is on.To return to normal
operation,momentarily press the Maximum Range
Extender button again or change channels.
4
5
FRS_120 12/29/00 2:19 PM Page 6
Operation
Calling
Another
Party
Note
Both units must be ON and
tuned to the same channel.
Your incoming “Call”signal
volume is dependent on the
unit volume s e t t i n g.
Calling Another Party
To alert another party that you wish to
communicate:
1
Push and release CALL button.The unit
you are calling will hear a two second ringing
tone.
Talking To Another Party
1 2
Push and hold
TALK button.
3 4
Hold mic about
2 inches from
mouth. Speak in
a normal voice.
Operation
Talking To
Another Party
Note
While the TALK button is
depressed you cannot
receive incoming calls.
The TX / RX indicato r
will be displayed.
Release TALK
button and listen
for response.
6
7
Loading...