Cobra Electronics 0102A Users manual
word mark and logos are owned by the Bluetooth SIG,
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO
OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS
TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
®
Inc. and any use of such marks by Cobra is under license.
The Bluetooth
tion™ are trademarks of Cobra Electronics Corporation, USA.
Cobra PhoneLynx™, PhoneLynx and Cobra Electronics Corpora-
Corporation, USA.
registered trademarks of Cobra Electronics
Cobra®, Nothing Comes Close to a Cobra® and the snake design are
TRADEMARK ACKNOWLEDGEMENT
• Consult the dealer or an experienced radio/TV technician for help.
that to which the receiver is connected.
• Connect the equipment into an outlet on a circuit different from
• Increase the separation between the equipment and receiver.
• Reorient or relocate the receiving antenna.
more of the following measures:
on, the user is encouraged to try to correct the interference by one or
reception, which can be determined by turning the equipment off and
this equipment does cause harmful interference to radio or television
guarantee that interference will not occur in a particular installation. If
harmful interference to radio communications. However, there is no
not installed and used in accordance with the instructions, may cause
ment generates, uses and can radiate radio frequency energy and, if
against harmful interference in a residential installation. This equipRules. These limits are designed to provide reasonable protection
the limits for a Class B digital device, pursuant to part 15 of the FCC
NOTE: This equipment has been tested and found to comply with
has that feature and make sure that the feature is activated.
See your cell phone owner’s manual to determine if your cell phone
area and you must have a GPS enabled and activated cell phone.
provide your exact location, E911 services must be deployed in your
land line. In order for a call to 911 emergency services to be able to
Calling 911 using a cell phone works differently than calling 911 on a
911 Statement
For any questions, please call 773-889-3087 for assistance.
charge.
be sent with information as to the repair charge or replacement
status. If the product is out of warranty, a letter will automatically
allow approximately 3 – 4 weeks before contacting Cobra for
either be repaired or exchanged depending on the model. Please
6. If the product is in warranty, upon receipt of the product, it will
Chicago, Illinois 60707 U.S.A.;
6500 West Cortland Street
Cobra Electronics Corporation
Cobra Factory Service
to:
4.
United Parcel Service (UPS) or Priority Mail to avoid loss in transit
5. Ship prepaid and insured by way of a traceable carrier such as
sible, use the original packing material;
Pack the product securely to prevent damage in transit. If pos-
to be returned, with phone number (required for shipment).
a typed or clearly printed name and address of where the product is
3. Enclose a description of what is happening with the product. Include
2. Send the entire product;
clearly readable. If the originals are sent, they cannot be returned;
Make sure the date of purchase and product model number are
such as a mechanical reproduction or carbon of a sales receipt.
1. For Warranty Repair include some form of proof-of-purchase,
and returned:
factory, the following must be furnished to have the product serviced
time on any repair. If Cobra asks that the product be sent to its
before sending the product. This will ensure the fastest turnaround
If this product should require factory service, please call Cobra rst
return this product to the store.
uct, or if parts are missing… PLEASE CALL COBRA FIRST…do not
For any questions about operating or installing this new Cobra prod-
PRODUCT SERVICE
tion, distance, location and/or topography.
not be used for any purpose requiring precise measurement of direc-
bly. This product is intended to be used only as a travel aid and must
It is the user’s responsibility to use this product prudently and responsi-
above limitations may not apply to some consumers.
or limitation of incidental or consequential damages. Part or all of the
the duration of an implied warranty and/or do not allow the exclusion
COST OF INSTALLATION. Some states do not allow limitations on
LIMITATION, DAMAGES RESULTING FROM LOSS OF USE OR
CONSEQUENTIAL OR OTHER DAMAGES; INCLUDING, WITHOUT
warranty. COBRA SHALL NOT BE LIABLE FOR ANY INCIDENTAL,
tness for a particular purpose are limited in duration to the term of this
All implied warranties, including warranties of merchantability and
4. If the owner of the product resides outside the U.S.A. and Canada.
3. If the serial number has been altered, defaced or removed;
unauthorized alterations or repairs;
2. In the event of misuse or abuse of the product or as a result of
1. To any product damaged by accident;
EXCLUSIONS – THIS LIMITED WARRANTY DOES NOT APPLY:
also have other rights which vary from state to state.
This warranty gives the consumer specic rights, and he or she may
replaced under warranty.
Return shipping will be at Cobra’s expense if the product is repaired or
shipping charges required to ship the product for warranty service.
duplicated copy of a sales receipt. The consumer must pay any initial
companied by proof of the date of rst consumer purchase, such as a
parts upon delivery to the Cobra Factory Service Department, if acreplace, at its option, defective PhoneLynx™ products or component
within the U.S.A. and Canada. Cobra will, without charge, repair or
rst consumer purchaser, provided that the product is used solely
of rst consumer purchase. This warranty may be enforced by the
in workmanship and materials for a term of one year from the date
PhoneLynx™, and the component parts thereof, will be free of defects
COBRA ELECTRONICS CORPORATION warrants that its Cobra
WARRANTY
Plug It In,
Pair and Go
Spanish,
XXXX XXXX XXXX
French,
XXXX XXXX XXXX
BT215
Operating Your Cobra PhoneLynx™
PhoneLynx
BT215-1
PhoneLynx
BT215-2
Plug It In
1. Plug the power adapter plug (1) into the power port of the PhoneLynx (2).
2. Plug the power adapter cord into a 110/120-volt household wall outlet.
3. Plug the phone line (3) coming from the phone, not from the wall jack, into the
transmitter.
2
1
3
⁄ WARNING
line. Only your home/ofce phone should connect to the PhoneLynx.
4. When the unit is rst powered on, the transmitter will beep twice and both
buttons will be illuminated in red.
Keep away from 2.4 GHZ wireless home phones to avoid potential
interference. Keep a reasonable distance between the base and PhoneLynx.
Never connect the PhoneLynx to the telephone company land
Pair with Cell Phone
5. Hold in either one of the buttons for three seconds. The LED for that button will
begin to blink with a blue light once per second. This indicates the PhoneLynx
is waiting to pair with your cell phone via Bluetooth® wireless technology.
6. Search for a new Bluetooth-enabled device on your cell phone.
7. When your cell phone nds the device, it will read “PhoneLynx BT215-1” or
“PhoneLynx BT215-2,” depending on what button was pushed.
8. When prompted for a password on your cell phone, enter “0000” in the
password eld.
9. When your cell phone is paired, the PhoneLynx will beep twice and the blue
LED will slowly blink once every four seconds. The system is now ready.
NOTE: To add another cell phone, push the other button and repeat the
pairing procedure.
Go
10. Make and receive calls on your home/ofce phone just as you normally would.
You will hear a dial tone provided by the PhoneLynx when picking up the receiver.
Loading...