Cobra Vehicle Alarm Series 3100, Series 3100 Fitting Instructions Manual

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.

danub98gbb.doc

MAKE

DAEWOO

MOD.

NUBIRA

YEAR

98 →→

PETROL
DIESEL

ALARM/SIREN
POSITION

Position the compact alarms and the sirens in the engine compartment near the
left lateral headlamp. Position the modular systems and the modules under the
dashboard, drivers side.

POWER SUPPLY + 30: connect to the 2,5mm2 RED wire located at the rear of the left lateral frame,

drivers side.

- 31: connect with an eyelet cable terminal to one of the fastening bolt of the
dashboard.

DIRECTION INDICATORS

Connect to the 1 mm2 BLUE and LIGHT BLUE wires located in the wiring
harness and coming out of the 22 way yellow connector located on the support of
the connector holder, above the fuse box behind the left lateral frame, drivers
side.

ELECTRIC WINDOWS Positive control signal

Front window, driver’s side:

cut the BLUE wire directly outgoing from the switch of the window to the inner
drivers side door.

Front window, passenger’s side:

cut the 1,5 mm2 LIGHT BLUE wire.

Rear window, driver’s side:

cut the 1,5 mm2 BROWN wire.

Rear window, passenger’s side:

cut the 1,5 mm2 GREEN wire located in the wiring harness coming out of the
drivers side door.

CENTRAL DOORS LOCKING Negative control signal

Connect to the LIGHT BLUE wires with WHITE reference located at the position
nr. 7 (lock) and the YELLOW at the position nr. 1 (unlock), in the 9 way white
connector of the central door locking unit located at the rear of the left lateral
frame, drivers side.

Note: for the vehicles without original key less entry, please refer to
diagram nr. 42 for the serie Bridge antithefts or refer to diagram nr.42A for
serie 3100 antithefts.

IMMOBILISATION POINT

The vehicle has an original equipment immobiliser that may be enabled
immediately when the switchboard is switched off.

BONNET SWITCH

Install an additional switch on the front headlamp support plate.

DOORS SWITCH

Connect to the 0,5 mm2 WHITE wire located in the wiring harness coming out of
the 16 way white connector, on the support of the connector holder, above the
fuse box behind the left lateral frame, drivers side.

BOOT SWITCH

Connect to the 0,5 mm2 PINK wire with BLACK reference located in the wiring
harness and coming out of the 16 way white connector located on the support
mentioned above.

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.

danub98gbb.doc

VIOLET ORANGE

FITTING DIAGRAM N°42

1

2

3

5

6

7

8

9

Negative control signal

For the versions without original radio control the positions Nr. 1 and Nr. 7 of the
white connector of the central doors closing are free, so insert suitable fastons.

ORANGE/VIOLET

Serie BRIDGE antitheft

White connector coming out of the central
doors locking unit.