Cobra OPEL ZAFIRA 2001 Service Manual

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL
MAKE
* Models with original equipment keyless entry system.
OPEL
MOD.
YEAR
01
DIESEL
ALARM/SIREN POSITION
CENTRAL UNIT POSITION
POWER SUPPLY + 30: connect to the 4 mm2 RED wire located in the wiring harness of the driving
IGNITION WIRE + 15/54: Connect to the BLACK wire located in the wiring harness coming out of a
DIRECTION INDICATORS
ELECTRIC WINDOWS Comfort closing
ACTIVAT./DEACTIVATION CONTROLS
Position the compact alarms and the sirens in the engine compartment, behind the driver’s side headlamp.
Position the modular systems and the modules under the left side of the dashboard, driver’s side.
connector in the fuse box.
- 31: connect with a cable terminal directly to the car body.
multiway connector, in the fuse box. Connect to the 0,75 mm2 BLACK/WHITE wire at the position nr. 65 and to the
BLACK/GREEN wire at the position nr. 19 located in the 80 way green connector placed behind the driver’s side bulkhead.
The closing of the electric windows is obtained timing to 24s the Comfort locking RED/BLUE wire located in the wiring harness coming out of the central doors locking unit placed behind the passenger’s side sill cover.
Connections antitheft/vehicle Art. 38XX Vehicle Position
GREY/BLACK BLUE/BLACK (Super locking motor) coming out central YELLOW/BLACK RED/BLACK (Motor) coming out central VIOLET/WHITE ground car body ORANGE +30 positive in the fuse box VIOLET BROWN/WHITE coming out central ORANGE/WHITE +30 positive in the fuse box All the above connections are made directly in the wiring harness coming out of the central doors locking unit located behind the passenger’s side sill cover. Note: The antitheft is activated and deactivated by the 2nd locking of the doors only. It is suggested to refer to diagram nr.108.
IMMOBILISATION POINT Fuel pump
Cut the RED/BLUE wire located in the wiring harness coming out of the green connector placed behind the left side frame.
STARTER + 50: Cut the 2,5 mm2 BLACK/RED wire located in the wiring harness coming out of the
connector of the switchboard key.
BONNET SWITCH
DOORS SWITCH
BOOT SWITCH
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed as per the instructions given on the product installation manual.
Install an additional switch on the headlamp support plate, above the driver’s side lamp. Connect to the GREY wire located in the wiring harness coming out of the green
connector placed behind the left side frame. Connect to the 0,75 mm2 BROWN/WHITE wire located in the wiring harness coming out
of the boot lamp.
opzaf01gbbt.doc
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
FITTING DIAGRAM N°108
Diagram to make the connection of art. 3800 on
OPEL ZAFIRA year 2001
Central doors locking unit located behind
the sill cover, passenger’s side
ART.3800 RED/BLACK BLUE/BLACK
(super locking)
GREY/BLACK YELLOW/BLACK
BROWN/WHITE VIOLET/WHITE
DIODE 1N4004 VIOLET
ORANGE ORANGE/WHITE
+ 30
M
Attention
During the programming of activation/deactivation controls proceed as follows:
- Connect, as per the diagram, all the wires indicated.
- Enter into programming of the controls (LED flashing quickly).
- Open and close , by hand, the driver’s side door (this enables the super locking function).
- Make the first locking of the doors (from original radiocontrol).
- Make the second locking of the doors (from original radiocontrol).
- Make the reopening of the doors (from original radiocontrol).
Note: with this programming, the antitheft will activate/deactivate by making the super central locking only.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed as per the instructions given on the product installation manual.
opzaf01gbbt.doc
Loading...