SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL
MAKE
OPEL
MOD.
CORSA
YEAR.
01 →→
DIESEL
ALARM/SIREN
POSITION
CENTRAL UNIT POSITION
POWER SUPPLY + 30: connect to the 2mm2 RED wire located in a multiway connector in the fuse
IGNITION WIRE + 15/54: connect to the 0,5mm2 BLACK/RED wire located in the wiring harness
DIRECTION INDICATORS
ELECTRIC WINDOWS Comfort closing
CENTRAL DOORS LOCKING Negative control signal
Position the compact alarms and the sirens on the wheelhouse, driver’s side.
To pass the cables use the original rubber core hitch located near the spout of the
drainage, in the engine compartment, driver’s side, then use the rubber core hitch
where the pipe of the rear windshield wiper passes.
Position the modular systems and the modules under the dashboard, driver’s side,
on the left of the steering column.
box.
- 31: connect to one of the ground terminals located behind the left lateral
bulkhead, driver’s side.
coming out of the connector of the ignition key.
Connect to the BLACK/WHITE and BLACK/GREEN wires located in the wiring
harness behind the left lateral bulkhead, driver’s side.
Negative control
To make the windows locking it is necessary to time at 24s the same
RED/YELLOW wire used to lock the doors.
Connect to the BROWN/RED wire (lock) and to the RED/BLUE wire (unlock) (it
opens the driver’s side door only) located in the wiring harness coming out of the
driver’s side oor. To open the other doors and the boot it is necessary to connect
the WHITE/RED wire of the antitheft (autodriven Bridge version only) to the
RED/BLUE wire (it opens the remaining doors) located in the wiring harness
coming out o the driver’s side door. For the (autodriven) Bridge serie antithefts
refer to diagram nr.110, for the (no autodriven) Bridge serie antithefts refer to
diagram nr.111. For the 3100 serie antithefts refer to diagram nr.111A.
IMMOBILISATION POINT Fuel pump
Cut the 2,5 mm2 RED/BLUE wire located in the wiring harness behind the left
lateral bulkhead, driver’s side.
STARTER + 50: Cut the BLACK/YELLOW wire located in the wiring harness coming out of
the connector of the ignition key.
BONNET SWITCH
DOORS SWITCH
BOOT SWITCH
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
Install an additional switch on the headlamp support plate.
Connect to the GREY wire located in the wiring harness behind the driver’s side sill
cover. (This control is timed).
Connect to the 0,35 mm2 BROWN/WHITE wire coming out of the wiring harness
behind the left lateral bulkhead, driver’s side.
opcor01gbb.doc
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
FITTING DIAGRAM N°110
Diagram to make the central doors locking on
OPEL CORSA year 2001
(Comfort windows locking)
Autodriven Bridge serie
VIOLET/ORANGE BROWN/WHITE
VIOLET ORANGE WHITE/RED
(Programming using
B button, see manual)
BROWN/RED
RED/BLUE
RED/YELLOW (windows closing)
(BROWN/BLACK)
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
opcor01gbb.doc