Cobra microTALK CX112 User Manual

User’s Guide

TWO-WAY RADIO MODEL

CX112

Making Life Easier
And Safer

Staying in touch with your family and
friends is convenient and easy when using
your microTALK

®

radio. Some of the many

uses you will discover include:

Communicating with others while hiking, biking,
and working; keeping track of family and friends
at a crowded public event; checking with travel companions
in another car; talking with neighbors; arranging meeting
spots with others while shopping at the mall.

Up/Down Buttons

While in mode function, press

and release to change channels.

Press and release to adjust

the volume.

Call Button

Press and release to alert others that you

are calling. This tone is used only to establish
voice communications.

Talk Button

Press and hold to communicate with
others. With the microphone about two
(2) inches [five (5) cm] from your mouth,
speak in a normal voice.

Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.

NOTE Both radios must be tuned to

the same channel to communicate.

LCD
Display

Maximum range may vary and is based on unobstructed
line-of-sight communication under ideal conditions.

Speaker/Microphone
Jack

WR

TX

Channel Numbers

While in Standby mode or when selecting

a channel, shows current channel (1 through 22).

When adjusting the volume,

shows current level (1 through 8).

Battery Low Icon

Icon blinks and an audible tone will be

heard when battery power level is low.

Your microTALK

®

radio has a unique circuit

designed to extend battery life. If there are no

transmissions within ten (10) seconds, the radio

will automatically switch to Battery Save mode.
This will not affect the radio’s ability to receive

incoming transmissions.

Receive Icon

Visible when receiving
a message.

Transmit Icon

Visible when transmitting
a message.

Channel/Volume

Indicator

Visible when receiving
a message.
“ CH” is visible when in

Standby mode or when
selecting a channel.

“ LE” is visible when

adjusting volume.

Mode/Power Button

Press and release to enter mode function to

change channels.

The channel numbers will blink when that
mode is selected. Use the Up/ Down buttons
to select a channel.

Press and hold to turn the radio On or Off.

Press and release again to enter the NOAA
Weather Channels. Use the Up/Down buttons
to select the strongest weather channel in
your area.

Battery
Compartment
Cover

Antenna

USB Charge
Jack

Installing Batteries

To Install or Replace Batteries:

1. Remove belt clip by releasing belt clip
latch and sliding clip up.

2. Pull up on the battery door latch to remove the
battery compartment cover.

3. Insert three (3) AAA batteries. Position
batteries according to polarity markings.

4. Replace battery compartment cover
and belt clip.

• Do not attempt to charge alkaline batteries.

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc), or

rechargeable (Ni-Cd, Ni-MH, etc.) batteries.

• If you are planning to buy NiMh batteries,

please purchase Cobra supplied batteries only.

Insert Batteries

Pull Latch Up

Remove Belt Clip

Weather Icon

Visible when in NOAA weather radio
mode. You can use your microTALK

®

radio to listen to weather channels
transmitting in your area.

COBRA RADAR DETECTORS

GPS RADAR DETECTOR