Page 1
BBG-MB
BBG Mounting Bracket Installation Instructions
The BBG-MB Mounting Bracket allows most BBG™ throwdown compact units to be rigidly mounted to affixing surfaces. The instructions below show
how to mount BBG using the bracket, as well as attaching dimension details.
BBG-MB Mechanical Details
Kit Contents
• (1) Mounting bracket
• (4) 4-40 x 0.3 PHMS w/ captive
flatwasher
Surface Attachment Drilling
Template
Make certain printer PDF scaling is
set to Actual Size (no scaling) if
using printed template.
If secure mounting to surface using screws is desired, note attachment details and
1
dimensions shown above, determine mounting location and drill bracket mounting holes on
surface.
Noting desired orientation of BBG unit with mounting bracket, remove four (4) flathead
2
Phillips screws from desired side of BBG unit.
• Bracket can be affixed to either side of BBG unit, with top or bottom of BBG facing up or
down as desired.
• Bracket can be oriented with mounting flange projecting from BBG, or mounting flange
positioned underneath BBG as desired.
Align bracket BBG mounting flange holes with BBG screw holes (noting desired orientation) and start (but do not tighten) four (4) Phillips
3
panhead screws provided (removed BBG flathead screws can be saved or discarded).
Tighten bracket-to-BBG screws, tighte ning no more than 1/4-turn .
4
Secure mounting bracket, along with BBG unit, to surface using appropriate hardware using any of the three mounting flange holes.
5
2016 Cobalt Digital Inc. All Rights Reserved. E&OE. BBG-MB-INSTL (Jan 2016)
Using screws other than supplied bracket-to-BBG
mounting screws can damage BBG unit.
Loading...